Chief Manufacturing Flat Panel Display Security Kit FSA-100 user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS
Flat Panel Display Security Kit
(FSA-1009 and KSA-1009)
The flat panel display security kit replaces exposed
hardware with security hardware.
NOTE: In some installations (i.e. single arm mount) not
all fasteners included in this kit will be required.
The security accessory kit can be used on most flat
panel configurations.
The pivot/pitch mount and mounts that are equipped with
a swing arm use the 4-inch security pivot bolts. Mounts
that are equipped with a height-adj

Summary of the content on the page No. 2

Installation Instructions FSA/KSA-1009 IMPORTANT WARNINGS and CAUTIONS! WARNING A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions. CAUTION A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions. Be aware of the potential for personal injury or damage to the mount if the accessory WARNING kit is not properly installed. Watch for pinch points. Do not put your fingers b

Summary of the content on the page No. 3

Installation Instructions FSA/KSA-1009 CONTENTS TOOLS REQUIRED FOR INSTALLATION TOOLS REQUIRED FOR INSTALLATION .................3 PARTS.......................................................................3 DISPLAY SECURITY SCREWS.................................4 1/8” Hex key wrench Flush Mount............................................................4 Recessed Mount.....................................................4 5/32” Hex key wrench INSTALL SECURITY PIVOT BOLTS.....................

Summary of the content on the page No. 4

Installation Instructions FSA/KSA-1009 M4 x 12mm Security Screw DISPLAY SECURITY SCREWS (typical) Select the appropriate hardware from the security kit to secure your display. Select the procedure, listed below, that applies to your application. Centris Mount Flush Mount (no spacers required) Recessed Mount (spacers required) Flush Mount 1. Verify that you have the correct parts. 2. Remove two M4 x 12mm screws from the top mounting holes on the display. 3. Install two M4 x 12mm security screws

Summary of the content on the page No. 5

Installation Instructions FSA/KSA-1009 INSTALL SECURITY PIVOT BOLTS Perform the applicable procedure to replace the regular 4” Security Pivot Bolts pivot bolts with security pivot bolts. You will need the security hex keys (provided) to complete the installation. Centris Mount Small Install 4-inch Security Pivot Bolts Washer For swing arm models, replace the standard pivot bolts with security pivot bolts, as follows: NOTE: Do not remove the display (not shown) from the Pivot Pin Flat Centris mo

Summary of the content on the page No. 6

Installation Instructions FSA/KSA-1009 INSTALL SECURITY SET SCREWS The security set screw is used to secure the pivot-pitch wall mount. You will need the security hex keys (provided) to install the security set screws. There are two different wall plates, which require different security requirements. Select the option that applies to your configuration. Option I NOTE: If your wall plate uses a 1/4-20 set screw, replace it with a 1/4-20 x 5/8” security set screw (40) and a 1/4-20 x 1/4” security