Lightolier Lighting Systems IS-EC1 user manual

Summary of the content on the page No. 1

Lighting Systems IS-EC1











11”

We reserve the right to change details of design, materials and finish.

Summary of the content on the page No. 2

Lighting Systems IS-EC1 48” or 96” 48” or 96” Junction Box (By Others) Canopy Canopy Power Canopy Power Cord Figure 1 S. R. L. Cord (Optional) Power Cord AC Supply (Male Plug) Cable Female Plug S. R. L. Cord 10-32 Screw (Optional) S. R. L. (Optional) Cable Gripper End-Cap Screw (Do Not Over Tighten) 1/4-20 Bolt Figure 2 We reserve the right to change details of design, materials and finish.

Summary of the content on the page No. 3

Lighting Systems IS-EC1 Step 1. Installing the Suspension Cables A. B. Step 2. Installing the First Fixture A. B. F. Step 3. Installing the Remaining Fixtures A. B. F. Step 4. End of Row A. B. We reserve the right to change details of design, materials and finish.

Summary of the content on the page No. 4

E S E M d f ed Mas e C Slave CS o i i t r Lighting Systems IS-EC1 Step 1. Modifying Master Unit A. B. F. NOTE: In some instances some of the wires in the fixture are required to remain uncut. (DALI, SHARING DAYLIGHT SENSOR , ETC.) In this case cut plug from secondary power cord and only cut and tap into the hot and neutral wires in the thru-harness. Power Cord 1st Power Drop 2nd Power Drop Master Slave Slave Modified Master Slave Slave 96" 96" 96" 96"

Summary of the content on the page No. 5

Lighting Systems IS-EC1 Installing the ECS400T Ground (Green) Common (White) Hot (Black) Ground (Green) Ground (Green) Building’s Electrical ECS400T System White Relay Common Black Installing the ECS100L Common Red +24V in Red N.O. Figure 4 Common (White) Common (White) Ground (Green) Hot (Black) Hot (Black) Ground (Green) Ground (Green) Building’s Electrical System ECS100L Low S. R. L. Low ECS Line Voltage Voltage Voltage Cord Power Cord Wirin