American Standard Connoisseur 4400 SERIES user manual

Summary of the content on the page No. 1

0





1





2




3




4





5





6




Installation
Instructions
CONNOISSEUR
4400 SERIES
SINGLE CONTROL KITCHEN
FAUCET AND CAST SPOUT
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
Certified to comply with ANSI A112.18.1M
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
M968955 REV. 1.2
TOOLS REQUIRED
Phillips Screwdriver
Channel Locks Adjustab

Summary of the content on the page No. 2

0 1 2 3 4 5 6 MAKE WATER SUPPLY CONNECTIONS 2 Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply to Hot (Marked with a Red Tag) and right supply to Cold wall supply. Use adjustable wrench to tighten connections. 2 Do not over tighten. 1 Faucet supplies are 21" long from faucet base. Note: If

Summary of the content on the page No. 3

0 1 2 3 4 5 6 TEST INSTALLED FAUCET 5 Move HANDLE down into "off" position and remove AERATOR. Turn on water supplies and check connections for leaks. Operate HANDLE up and down, left and right to flush water AERATOR lines thoroughly. For faucet with spray, direct SPRAY HEAD into sink and activate SPRAY. Check hose connections for leaks. Move HANDLE down to "off" position and replace AERATOR. CHECK CONNECTIONS FOR LEAKS SERVICE