Husky HSK1084HD user manual

Summary of the content on the page No. 1

CHINA IN MADE
MANUF VECTOR ACTURING2005
584-5504 (866) Free: oll
U.S. 33312 FL Lauderdale, Ft. ve., 30th S.W 4140
BD062805
NON-TRANSFERABLE NON-REFUNDABLE ISARRANTY AND
II II II II II
584-5504 (866) FREE: TOLL
33312 Lauderdale, FL 28thSW4140
PRODUCTS POWER HUSKY CUSTOMER SERVICE TTN.:
to:receipt sales original the of copy withcompleted along registration form,
warranty activate this purchase to of days registered 30within be products Product mustPower
Husky All ype. ProductasCharger” Batter Smar

Summary of the content on the page No. 2

HSK1084HD_Manual_062805.qxd 10/21/05 7:22 PM Page ii Preparing to Charge IMPORTANT SAFETY INSTRUCTIONS 1. Determine voltage of battery to be charged by referring to the vehicle manual. WARNINGS 2. If it is necessary to remove battery from vehicle to charge, or to clean terminals, always remove 1. RISK OF EXPLOSIVE GAS MIXTURES — WORKING IN VICINITY OF A LEAD-ACID grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not to BATTERY IS DANGEROUS. BATTERI

Summary of the content on the page No. 3

HSK1084HD_Manual_062805.qxd 10/21/05 7:22 PM Page iv 5. Carefully connect the NEGATIVE (BLACK) charger clamp to the free end of the battery cable connected to the NEGATIVE terminal. TABLE OF CONTENTS 6. Set the charge rate to appropriate setting according to battery size. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 7. When disconnecting charger, always do so in reverse sequence of connecting procedure and break first co

Summary of the content on the page No. 4

HSK1084HD_Manual_062805.qxd 10/21/05 7:22 PM Page 2 Stage Three — Top-Off Charge voltage is automatically maintained and reduced to INDICATORS: a predetermined level while current is adjusted for a safe, effective battery charge. At Large (.375”) 3-Character Digital Display in the upper left of the control panel the end of Stage 3, the unit will BEEP signaling the completion of the charging cycle. indicates the various conditions and/or status codes: The Automatic Float Charge feature is idea

Summary of the content on the page No. 5

HSK1084HD_Manual_062805.qxd 10/21/05 7:22 PM Page 4 1. Press Alternator Check to start the check. Charging the Battery 2. Alternator Good LED will light to indicate the alternator is good, or 1. Press 2/6/10 AMP button to begin charging at the 2 amp rate; the unit sounds the FAULT LED will light to indicate the alternator may need service. a beep and displays charging current. The charger starts charging at 2 amp rate automatically if 2/6/10 AMP button is not pressed within 3 minutes after 3

Summary of the content on the page No. 6

HSK1084HD_Manual_062805.qxd 10/21/05 7:22 PM Page 6 WARNINGS • Do not use charger if cords or clamps have been damaged in any way — call Technical Support toll-free at (866) 584-5504. • There are no user-serviceable parts in this unit. • Do not open the unit. In the event of malfunction, it must be returned to manufacturer for professional testing and repair. OPENING THE UNIT WILL VOID THE MANUFACTURER’S WARRANTY. TROUBLESHOOTING Display Indications/Common Problems/Possible Solutions No Fun