Summary of the content on the page No. 1
MARVEL WINE CELLAR
Installation
Operation
and
Maintenance
Instructions
Refrigerated
Wine Cellar
30WCM
Summary of the content on the page No. 2
STARTING OUT Remove Packaging Your wine cabinet has been packed for shipment with all parts that could be damaged by movement securely fastened. Before using, be sure all packing materials and tape have been removed. Important Keep your carton packaging until your wine cabinet has been thoroughly inspected and found to be in good condition. If there is damage, the packaging will be needed as proof of damage in transit. Note to Customer This merchandise was carefully packed and thoroughly
Summary of the content on the page No. 3
INSTALLATION Select Location The proper location will ensure peak performance of your appliance. Choose a location where the unit will be out of Electrical Plug Optional Location: Cutout shown for electrical outlet which can be located in adjacent direct sunlight and away from heat sources. Best perfor- cabinetry. mance will be maintained when installed within the follow- ing parameters: Ideal Ambient Temperature Range Built-In 65-80 degrees F Free-Standing 65-90 degrees F Cabinet Clearanc
Summary of the content on the page No. 4
OPERATION Door Switch Alarm F Control Light Switch ON/OFF Set Colder Warmer Press and Hold Press and Hold Figure 3 Start Your Appliance Information/Lockout Key To start your appliance, plug it into a power supply. The Each momentary press of the “SET” key activates the Infor- unit should start automatically as the factory default should mation and Lockout selection menu. Additional presses be on. If the unit does not start, push and hold the “ON/ sequentially scroll through the Information
Summary of the content on the page No. 5
OPERATION • Keypad Lockout Feature (Loc) Warning Alarms This feature is useful for prohibiting changes in the Your wine cellar has been fitted with a MicroSentry™ temperature set point or accidentally turning the unit refrigeration monitor. This monitor will let you know if your off. Press and hold the “SET” key to display the cur- cellar is not functioning properly for optimum wine storage. rent “Loc” setting. If “No” is displayed, Lockout is OFF and all keys are enabled. If “Yes” is di
Summary of the content on the page No. 6
APPLIANCE FEATURES Insert Wine Bottles Front Bottles (Necks Facing Rear) The five pull-out shelves each hold four bottles. See Figure Rear Bottles (Necks Facing Front) 4 for typical wine bottle spacing. Tall bottles should not be loaded on the bottom rack because they may prevent the door from closing. Also, there is a fixed, wooden, bottle cradle in the bottom, step section of the cabinet. Three bottles may be stored there. Loading Tips and Suggestions Bottom rack(s) may be removed for
Summary of the content on the page No. 7
CARE AND CLEANING OF YOUR WINE CELLAR To replace the light bulb, unscrew the old light bulb located Condenser behind the display housing at the top of the unit. Set the The condenser tubing inside the cabinet does not require old light bulb aside. Screw the new light bulb into place. frequent cleaning; however, satisfactory cooling depends Check to see if the light bulb operates properly to complete on adequate ventilation over the coils. Be sure that noth- the installation. ing obstru
Summary of the content on the page No. 8
TROUBLESHOOTING Before Calling for Service Before calling for service, check the troubleshooting table on this page. This table lists possible problems that you can remedy with- out difficulty to avoid an unnecessary service call. PROBLEM POSSIBLE CAUSES/SOLUTIONS Odor in cabinet 1. Interior needs cleaning 1. Cabinet not level Noisy operation 2. Weak floor 1. Cabinet not level Cabinet vibrates 2. Weak floor 1. Tube burned out Cabinet light not working 2. No power at outlet 1. “ON/OFF” button p
Summary of the content on the page No. 9
OBTAINING SERVICE If You Do Need Service How to Obtain Service If you do need service, contact your dealer or the manufac- Your refrigerated wine cellar requires little service because turer. In any correspondence, refer to the model number the best and most up to date materials, equipment and and serial number of your unit which is located on the quality methods are employed throughout the manufactur- upper left hand side of the wall liner. Retain your proof of ing process. purchase. You m
Summary of the content on the page No. 10
WARRANTY Entire Product Parts or Service Limited One Year Parts and Labor Warranty Not Supplied or Designated by Marvel Marvel warrants that it will supply all necessary parts and The above warranties also do not apply if: labor to repair or replace in the end user’s home or office, any component which proves to be defective in material • The original bill of sale, deliver date, or serial number or workmanship, subject to the condition and exclusions cannot be verified. stated below, for a pe
Summary of the content on the page No. 11
NOTES 10
Summary of the content on the page No. 12
www.lifeluxurymarvel.com Marvel Industries P.O. Box 997 Richmond, IN 47375-0997 800.428.6644 An AGA Company 41010723 Rev. C All specifications and product designs subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for 10.01.07 previously purchased products.
