Summary of the content on the page No. 1
INSTALLATION AND OPERATION INSTRUCTIONS
DIRECT DRAW DISPENSER - SELF-CONTAINED MODELS
MODEL NOS.
DS Series
IMPORTANT INFORMATION Table of Contents
Fill out the enclosed warranty card and mail to the
PREPARING THE CABINET FOR USE
Perlick Corporation to register the warranty. If the
Specifications.........................................................2
card is not returned, the warranty period will begin
List of Included Parts.............................................3
from the date the equip
Summary of the content on the page No. 2
Installation and Operating Instructions Sizes and Specifications, Direct Draw Dispensers - Self-Contained MODEL NUMBERS BLACK DS2KP DS3KP DS4KP STAINLESS STEEL DS2KS DS3KS DS4KS SPECIFICATIONS KEG CAPACITY 2 Keg 3 Keg 4 Keg NUMBER OF DOORS 2 2 3 DIMENSIONS Length Ins. (mm) 60” (1524) 72” (1829) 84” (2134) 1 1 1 Cabinet Depth Ins. (mm) 24 /8” (613) 24 /8” (613) 24 /8” (613) 1 1 1 Height Ins. (mm) 34 /2” (876) 34 /2” (876) 34 /2” (876) NO. OF DISPENSING HEADS 1 1 2 NO. FAUCETS 2 2 2 1 1 1 CONDENSE
Summary of the content on the page No. 3
Preparing the Cabinet for Use – Direct Draw Dispensers Self-Contained Attach faucet to standard using spanner Parts List wrench to tighten coupling. Attach faucet Faucet Standard. handle to faucet. Faucet Head Assembly. Insert flexible plastic air hose six to seven 3 Black Connector Hose ⁄16” x 3’. inches into bottom of faucet standard. 5 ⁄16” Air Hose. Secure hose with tie wrap (supplied). Spanner Wrench. Bag of Miscellaneous Parts. Plumbing The floor drain in the right rea
Summary of the content on the page No. 4
Installation and Tapping – Direct Draw Dispensers Self-Contained Connecting the Keg Coupler Tapping a Single Valve Keg (Sankey): (when Supplied by Perlick) Place one brown leather washer into black beer line connector hose on hex nut side. Screw connector to stainless steel beverage line on Step 1 faucet standard. Tighten with a wrench, but do Single Valve Keg Coupler not over tighten. Make sure lever handle on the keg coupler is in the UP (untapped) position. Place one brown leather
Summary of the content on the page No. 5
Installation and Tapping – Direct Draw Dispensers Self-Contained Unscrew regulator from cylinder fitting. Connecting the Regulator to the Replace carbonic washer (Part No. 157F2P), CO2 Cylinder if needed and reattach regulator to filled Remove blue plug from regulator fitting. cylinder. (Note: Do not remove the carbonic washer). Turn CO2 hand valve counterclockwise until Screw regulator onto gas cylinder valve. Tighten fully open. Turn regulator shut-off valve to with wrench unti
Summary of the content on the page No. 6
Draft Beer Information – Direct Draw Dispensers Self-Contained Temperature One of the most common causes of dispensing At temperatures lower than 30° F., beer will freeze. When beer freezes, the alcohol in the beer may problems is improper temperature. Draft beer separate and cause the beer to be cloudy with an should be stored at a temperature between 32° and 38°. At warmer temperatures, beer will foam. “off” taste. Refrigeration and Temperature Control Adjusting the temperature The Direct Dra
Summary of the content on the page No. 7
Cleaning the Beer System – Direct Draw Dispensers Self-Contained The entire beer system, to include the faucet, flexible Beer Stone: beer line and tapping devices must be cleaned at All beer contains calcium which is present from regular intervals. We recommend flushing the entire the grains used in the brewing process. it is an system with fresh water immediately after a keg has important natural material in draft systems in been emptied. Once each month the system should that as it oxidi
Summary of the content on the page No. 8
Pouring a Perfect Glass of Beer – Direct Draw Dispensers ➠ STEP 1 Start with a clean glass. Place the glass at a 45° angle, one inch below faucet. Do not let the glass touch the faucet. Open the faucet all the way. STEP 2 ➠ After the glass has reached half full, gradually bring the glass to the upright position ➠ STEP 3 Let the remaining beer run straight down the middle of the glass. This ensures proper release of CO2 by 3 producing a ⁄4” to 1” foam head. STEP 4 ➠ Close the faucet quickly an
Summary of the content on the page No. 9
Trouble Shooting – Direct Draw Dispensers Self-Contained Beer Service Problems Cloudy Beer: Beer in glass appears hazy, not clear. Wild Beer: CAUSES: Dispensed beer has either too much foam or Dirty glass. is all foam. Dirty faucet or beer line. CAUSES: Frozen or nearly frozen beer. Beer has been dispensed improperly. Old beer. Solution: See pouring instructions Beer that has not been refrigerated for a on page 8. long period of time. Regulator pressure is set too high. War
Summary of the content on the page No. 10
Replacement Parts – Direct Draw Dispensers Self-Contained MODEL NOS. DS2KP DS3KP DS4KP DS2KS DS3KS DS4KS All Models Left hinged door assembly, black 64357SLBL-LK 64357SLBL-LK 64357SLBL-LK Left hinged door assembly, SS 64357SLSS-LK 64357SLSS-LK 64357SLSS-LK Right hinged door assembly, black 64357SRBL-LK 64357SRBL-LK 64357SRBL-LK Right hinged door assembly, SS 64357SRSS-LK 64357SRSS-LK 64357SRSS-LK Magnetic door gasket 62085-1 62085-1 62085-1 Hinge set, left 63407L 63407L 63407L Hinge set, right 6
Summary of the content on the page No. 11
Replacement Parts – Concessionaire Dispensers For Single Valve Keg Coupler (Series D) Item Part No. No. Description 1 2 1 ............26000D ..............Single valve keg coupler 2 ............C14316 ..............“O” ring 3 3...........31080-2P.............Ball check 4...........31089-2P.............“O” ring (3 per assembly) 5...........31088-2P.............Bottom seal washer 4 6...........31087-2P.............Probe washer domestic 7............157R2P ..............Coupling Gasket 8..........
Summary of the content on the page No. 12
Wiring Diagram – Concessionaire Dispensers 8300 West Good Hope Road • Milwaukee, WI 53223 • Phone 414-353-7060 • Fax 414-353-7069 Toll Free 800-558-5592 • E-Mail: Perlick@Perlick.com • www.Perlick.com Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice. Form No. Z2025A Rev. 12.05.03 12
