Specialized Command Post Adjustable Height Seat Post user manual

Summary of the content on the page No. 1

LEFT-HANDED
REMOTE LEVER
(CAN BE MOUNTED
ON RIGHT SIDE)
LEFT GRIP
DEVICES
(BRAKE, SHIFTER)
RIGHT-HANDED
REMOTE LEVER
(NOT INCLUDED)
RIGHT GRIP
DEVICES
(BRAKE, SHIFTER)
NON-CARBON
HANDLEBARS
NO GREASE! REMOTE LEVER I.D.
15 in-lbf (1.7 N-m)
RUN CABLE
THROUGH
90-DEGREE
CABLE TO
PIPE
SEAT POST
NON-GROMMETED END
INSERT CABLE
THROUGH SLOT
FERRULE
NUT BOLT
INSERT CABLE
SLOT
WEDGE RAIL INTO NON-FERRULE
CLAMP
NUT AND RAIL CLAMP ASSEMBLY END OF CABLE
HOUSING
PULL CABLE
UNTIL CABLE
HEAD RESTS
IN SLOT
CAB

Summary of the content on the page No. 2

PULL THE CABLE PULL THE CABLE AS YOU GUIDE THE TIGHT WITH PLIERS, FERRULE INTO THE THEN TIGHTEN THE BARREL ADJUST HEX NUT/WASHER WITH A 3MM HEX KEY BARREL ADJUST CABLE FROM REMOTE LEVER IN THE POWER POSITION, THE CABLE HOUSING NEEDS TO ENTER THE BARREL ADJUST IN A STRAIGHTFORWARD MANNER. 1MM OF PLAY 7. Insert the cable into the non-ferrule end of the cable housing. Pull the cable taught, SETUP AND USE making sure the housing properly interfaces with the 90-degree pipe (see fig. 5). The Comma