Summary of the content on the page No. 1
DOCKING MUSIC SYSTEM FOR
TM
®
iPod and iPhone
ALARM 1
FM STEREO
ALARM 2
PM
OWNER’S MANUAL
JiMS-198i
(iPod/iPhone Not Included)
PLEASE READ THIS OPERATING MANUAL COMPLETELY BEFORE
OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
Summary of the content on the page No. 2
® DEAR JENSEN CUSTOMER Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association's Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level. One that lets the sound come through loud and clear without annoying blaring or distortion and, m
Summary of the content on the page No. 3
IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Read these instructions 2. Keep these instructi
Summary of the content on the page No. 4
15. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 16. The MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable. 17. Battery pack or battery installed shall not be exposed to excessive heat such as sunshine, fire or the like. 18. Name plate is located on bottom of product. IM
Summary of the content on the page No. 5
COMPLIANCE WITH FCC REGULATIONS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation This equipment has been tested and found to comply with the limits for a Radio Receiver, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection a
Summary of the content on the page No. 6
POWER SOURCE AC-DC ADAPTOR CONNECTION The unit is powered by an external AC - DC Power Adaptor with an output of 10V DC - 1400mA (included). (1) Firmly and securely plug the adaptor's AC plug into a household AC wall adaptor. (2) Insert the adaptor's DC output plug into the DC -IN jack on the back of the unit. Operating this unit from any other power source may cause damage to the unit and will void your warranty. BATTERY BACK – UP SYSTEM The radio is also pre-loaded with 2 x “AA” batteries
Summary of the content on the page No. 7
BATTERY INSTALLATION Open the battery compartment door on the bottom of the cabinet. 1. Insert 2 “AA” size batteries into the battery compartment according to the polarity 2. diagram engraved inside the compartment. Replace the battery compartment Door. 3. IMPORTANT:Be sure that the batteries are installed correctly. Wrong polarity may damage the unit. Alkaline-type batteries are recommended. For optimum performance, these batteries 4. should be replaced after ever
Summary of the content on the page No. 8
LOCATION OF CONTROLS AND INDICATORS 2 4 13 14 5 8 10 11 1 12 6 16 3 15 7 9 17 18 1. SHUFFLE / PRESET- BUTTON 10. SLEEP BUTTON 2. REPEAT / PRESET+ BUTTON 11. ON / OFF BUTTON 3. MEMORY / SET BUTTON 12. FUNCTION(FM / AM / iPod / AUX IN) BUTTON 13. VOLUME + BUTTON 4. TUNE+ / UP BUTTON 14. VOLUME - BUTTON 5. TUNE- / DOWN BUTTON 6. SNOOZE BUTTON 15. MONO / STEREO / PLAY / PAUSE BUTTON 7. NAP BUTTON 16. DIMMER BUTTON 8. ALARM 1 BUTTON 17. DAY LIGHT SAVING TIME SWITCH 9. ALARM 2 BUTTON 18. R
Summary of the content on the page No. 9
LOCATION OF CONTROLS AND INDICATORS 1 3 4 ALARM 1 FM STEREO ALARM 2 2 PM 5 6 6 78 13 91011 12 1. ALARM 1 INDICATOR 8. HEADPHONE OUTPUT JACK 2. ALARM 2 INDICATOR 9. TIME ZONE SWITCH 3. MULTI FUNCTION DISPLAY 10. AM LOOP ANTENNA JACK 11. AUX IN JACK 4. FM STEREO INDICATOR 12. FM ANTENNA 5. PM CLOCK INDICATIOR 6. SPEAKER 13. BATTERY COMPARTMENT 7. DC INPUT JACK 8
Summary of the content on the page No. 10
OPERATING INSTRUCTIONS AUTO TIME SET This unit features an Automatic Time Set system powered by 2 X “AA” batteries (3V DC) (Included), so you will not need to set the clock time when first plugged in. After the unit is plugged in, the LED display will show the time automatically. You will only need to set the correct time zone and daylight saving time for your area. SETTING THE TIME ZONE Change to your time zone area by sliding the TIME ZONE switch on the back of the unit to the appropriate
Summary of the content on the page No. 11
SETTING THE CLOCK In case the back-up batteries are accidentally removed. You will need to set the clock manually. If the LED display is blinking 1. In standby mode, press the UP button to increase or press the DOWN button to decrease the minutes setting. 2. Press and hold the UP / DOWN button to fast forward/backward the clock setting. 3. Press the MEM/SET button to confirm the setting. If the LED display is steady 1. In standby mode, press and hold MEMORY/SET button for 3 seconds, Time
Summary of the content on the page No. 12
FM STEREO / MONO RECEPTION 1. This unit provides FM STEREO and FM MONO settings. In stereo mode, the unit will automatically switch to stereo when a FM stereo broadcast is received. The FM ST indicator turns on. 2. To receive a weak (noisy) FM station, press the MONO/STEREO button once to switch the FM mode to “MONO”. The FM ST indicator turns off, the reception may be improved, but the sound is now monaural (MONO). Note: 1. When listening to an FM program, fully extend the Wi
Summary of the content on the page No. 13
LISTENING TO iPod AND iPhone PLAYBACK 1. To play your iPod, insert the adaptor included with your iPod into the docking bay area. To play your iPhone, insert the included adaptor into the docking bay area. Your iPod / iPhone can now be docked by placing the connector on the bottom of the iPod / iPhone onto the connector in the docking bay. Note: 1. Please be careful when docking the iPod / iPhone. Excessive force or pressure can damaging the 30-pin connector on iP
Summary of the content on the page No. 14
USING HEADPHONES (NOT INCLUDED) Insert the plug of your headphones (not included) into the Headphone jack, on the back of the unit and you can now listen in private. When using headphones, the speakers will be disconnected automatically. NOTE: READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES 1. Avoid extended play at very high volume as it may impair your hearing. 2. If you experience ringing in your ears, reduce the volume or shut off your unit. 3. Keep the volume at a
Summary of the content on the page No. 15
NOTE: The last radio station you listen to will be the same station you will wake to. 3. The radio will automatically turn on and the ALARM indicator will flash when the alarm time is reached. The volume starts softly and becomes gradually louder. 4. The radio alarm will keep sounding for 60 minutes and then automatically shut off and resets for wake up at the same time the following day. 5. To stop the alarm immediately, press the ON/OFF button once. The radio will stop but the
Summary of the content on the page No. 16
SNOOZE OPERATION You may active the SNOOZE function manually after the alarm sounds by pressing the SNOOZE button. The snooze time can be adjusted from 1 ~ 30 minutes. The default snooze time setting is 9 minutes. SNOOZE TIME SETTING: 1. In standby mode, press and hold the SNOOZE for 3 seconds, the display shows current snooze time and flashes. 2. Press the UP / DOWN button to increase / decrease the snooze time. 3. Snooze function only effective in 59 minutes., the alarm will not sou
Summary of the content on the page No. 17
SLEEP TIEMR OPERATION The Sleep Timer allows you to set the unit automatically power off after a selected sleep time duration is set. Sleep time function can be set from 1 minute to 120 minutes. 1. In unit power ON mode, press the SLEEP button to enter SLEEP setting. LED flashing and showing “90”. Press the SLEEP button repeatedly, it shows 90-60-30-15-OFF (display showing normal clock) for selection. 2. Press the UP / DOWN buttons to select exact minutes you desired. 3. Wait for 3 s
Summary of the content on the page No. 18
Note: If you connected the Line Out Jack of your external device then you only need to adjust the volume control of this system. If you connected the Headphone Jack of your external device then you may need to adjust both the volume control of your external device and the volume control of this system to find the most desirable volume setting. CARE AND MAINTAINANCE - Do not subject the unit to excessive force, shock, dust or extreme temperature. - Do not tamper the internal components of the
Summary of the content on the page No. 19
TROUBLESHOOTING GUIDE Symptom Possible Problem Solution AC Adaptor is not plugged into a wall outlet Plug the AC adaptor into a wall outlet and plug or the connector is not plugged into the the connector into the supply jack on the unit. power supply jack on the back of the unit. The unit does Plug another device into the same outlet to not respond Wall outlet is not functioning. confirm the outlet is working. (no power) Remove your iPod / iPhone from the dock and check for obstruction on
Summary of the content on the page No. 20
SPECIFICATIONS Power Supply Power Adaptor (included): Input: AC120V ~60Hz Output: DC10V, 1400mA Battery Back-up for Clock: 2 X DC1.5V ‘AA’ (UM-3) Frequency Range AM 520 – 1710 kHz, 10 kHz tuning step FM 87.5 – 108 MHz, 0.1 MHz tuning step "Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple
