Summary of the content on the page No. 1
VHSIM2-A6DP
User’s Guide
VHSIM2-A6DP
APIM 1 APIM 2
STS STS
LNK LNK
APIM-21R APIM-21R
9032825-02
Summary of the content on the page No. 2
Summary of the content on the page No. 3
ELECTRICAL HAZARD: Only qualified personnel should perform installation procedures. NOTICE Enterasys Networks and its licensors reserve the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Enterasys Networks to determine whether any such changes have been made. The hardware, firmware, or software described in this manual is subject to change without notice. IN NO EVENT SHALL ENTERASYS NETWORKS
Summary of the content on the page No. 4
FCC NOTICE This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against ha
Summary of the content on the page No. 5
ENTERASYS NETWORKS, INC. PROGRAM LICENSE AGREEMENT BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT, CAREFULLY READ THIS LICENSE AGREEMENT. This document is an agreement (“Agreement”) between You, the end user, and Enterasys Networks, Inc. (“Enterasys”) that sets forth your rights and obligations with respect to the Enterasys software program (“Program”) in the package. The Program may be contained in firmware, chips or other media. UTILIZING THE ENCLOSED PRODUCT, YOU ARE AGREEING TO BECOME B
Summary of the content on the page No. 6
5. UNITED STATES GOVERNMENT RESTRICTED RIGHTS. The enclosed Product (i) was developed solely at private expense; (ii) contains “restricted computer software” submitted with restricted rights in accordance with section 52.227-19 (a) through (d) of the Commercial Computer Software-Restricted Rights Clause and its successors, and (iii) in all respects is proprietary data belonging to Enterasys and/or its suppliers. For Department of Defense units, the Product is considered commercial computer s
Summary of the content on the page No. 7
SAFETY INFORMATION CLASS 1 LASER TRANSCEIVERS THE APIM-29, APIM-29LR, VAPIM-39, AND VAPIM-39LR ARE ATM PORT INTERFACE MODULES THAT USE CLASS 1 LASER TRANSCEIVERS. READ THE FOLLOWING SAFETY INFORMATION BEFORE INSTALLING OR OPERATING THESE MODULES. The Class 1 laser transceivers use an optical feedback loop to maintain Class 1 operation limits. This control loop eliminates the need for maintenance checks or adjustments. The output is factory set, and does not allow any user adjustment. Class 1
Summary of the content on the page No. 8
DECLARATION OF CONFORMITY Application of Council Directive(s): 89/336/EEC 73/23/EEC Manufacturer’s Name: Enterasys Networks, Inc. Manufacturer’s Address: 35 Industrial Way PO Box 5005 Rochester, NH 03867 European Representative Name: Mr. Jim Sims European Representative Address: Enterasys Networks Ltd. Nexus House, Newbury Business Park London Road, Newbury Berkshire RG14 2PZ, England Conformance to Directive(s)/Product Standards: EC Directive 89/336/EEC EC Directive 73/23/EEC EN 55022 EN 55024
Summary of the content on the page No. 9
Contents Figures ............................................................................................................................................ x Tables.............................................................................................................................................xii ABOUT THIS GUIDE Who Should Use This Guide......................................................................................... xiii Structure of this Guide ............................
Summary of the content on the page No. 10
3.2 Accessing the VHSIM2-A6DP ATM Screen....................................................3-8 3.3 ATM Connections Screen .............................................................................3-10 3.4 ATM Connection Setup Screen.....................................................................3-11 3.5 Traffic Management PVC Priority Assignments ............................................3-14 3.5.1 Adding Traffic Management PVC Priority Assignments ................3-17 3.5.2 Modifying
Summary of the content on the page No. 11
3.17 Signalling Screen ..........................................................................................3-57 3.17.1 Changing the UNI Version.............................................................3-59 3.17.2 Changing the ILMI Status to Disabled ...........................................3-59 3.17.3 Changing the UNI Status...............................................................3-60 3.17.4 Restarting UNI..........................................................................
Summary of the content on the page No. 12
Figures Figure Page 1-1 VHSIM2-A6DP ................................................................................................................ 1-1 2-1 Removing the APIM Coverplate...................................................................................... 2-3 2-2 Installing an APIM ...........................................................................................................2-4 2-3 Removing the APIM Coverplate..........................................................
Summary of the content on the page No. 13
B-7 VAPIM-31........................................................................................................................B-7 B-8 VAPIM-39........................................................................................................................B-8 B-9 VAPIM-39LR ...................................................................................................................B-9 Figures xi
Summary of the content on the page No. 14
Tables Table Page 3-1 Event Messages ........................................................................................................... 3-4 3-2 Keyboard Conventions ................................................................................................. 3-5 4-1 VHSIM2-A6DP LEDs.................................................................................................... 4-2 4-2 APIM LEDs .....................................................................................
Summary of the content on the page No. 15
About This Guide Welcome to the Enterasys Networks VHSIM2-A6DP User’s Guide. This manual provides the following information: • Describes VHSIM2-A6DP features • Explains how to install the VHSIM2-A6DP in Enterasys interface module or standalone device • Outlines specifications for the Enterasys Asynchronous Transfer Mode (ATM) Very High Speed Interface Module (VHSIM) The VHSIM2-A6DP provides additional connectivity/functionality to various Enterasys interface modules and standalone devices by
Summary of the content on the page No. 16
Related Manuals Chapter 4, LANVIEW LEDs, describes how to use the VHSIM2-A6DP LEDs to monitor VHSIM performance and status. Appendix A, VHSIM2-A6DP Specifications, describes environmental specifications and safety requirements for the VHSIM2-A6DP. Appendix B, APIM and VAPIM Specifications, describes specifications and features for each of the APIMs and VAPIMs available for the VHSIM2-A6DP. RELATED MANUALS Use the following Enterasys Networks manuals to supplement the procedures and other tech
Summary of the content on the page No. 17
Related Manuals DOCUMENT CONVENTIONS The following conventions are used throughout this document: NOTE: Calls the reader’s attention to any item of information that may be of special importance. TIP: Conveys helpful hints concerning procedures or actions. CAUTION: Contains information essential to avoid damage to the equipment. ELECTRICAL HAZARD: Warns against an action that could result in personal injury or death due to an electrical hazard. bold type Bold type denotes text that the user sho
Summary of the content on the page No. 18
Related Manuals x A lowercase italic x indicates the generic use of a letter (e.g., xxx indicates any combination of three alphabetic characters). n A lowercase italic n indicates the generic use of a number (e.g., 19nn indicates a four-digit number in which the last two digits are unknown). [ ] In the Local Management screens, brackets indicate that a value may be entered or selected. xvi
Summary of the content on the page No. 19
1 Introduction This chapter provides a brief overview of the VHSIM2-A6DP and provides information on obtaining additional help from Enterasys Networks. Figure 1-1 VHSIM2-A6DP VHSIM2-A6DP APIM 1 APIM 2 STS STS LNK LNK APIM-21R APIM-21R 2825_01 NOTE: Unless noted otherwise, all Enterasys Networks APIMs and VAPIMs available for the VHSIM2-A6DP are referred to as “APIMs” in this document. 1.1 OVERVIEW The VHSIM2-A6DP extends the functionality of the Enterasys Networks interface module or standalo
Summary of the content on the page No. 20
Overview 1.1.1 ATM Port Interface Modules (APIMs and VAPIMs) The VHSIM2-A6DP supports two Enterasys Networks APIMs for ATM connectivity and redundancy. APIMs for any interface can be installed into the VHSIM2-A6DP. The two APIMs installed may be of any combination of physical layer cable type and bandwidth. For example, the APIM installed in slot 1 could support Twisted Pair cable and provide 155 Mbps of bandwidth, while the APIM installed in slot 2 could support Coaxial cable and provide 45
