Psiber Data Systems Psiber PINGER user manual

Summary of the content on the page No. 1

LINK SEARCH SCREEN LINK SEARCH SCREEN LINK SEARCH SCREEN LINK SEARCH SCREEN LINK SEARCH SCREEN
The Link Search setup screen is used to set the length of time that the
Pinger Plus will monitor a wire pair for Link signals. Normal (about 2.5
seconds) is the default setting or use the Up/Down cursor key to select the
Long setting (about 5 seconds). Some switches, especially if configured for TM
+
PINGER PLUS
VoIP, require a longer time to complete Link negotiations and the Long
setting will pr

Summary of the content on the page No. 2

PINGER IP SETUP SCREEN PINGER IP SETUP SCREEN PINGER IP SETUP SCREEN PINGER IP SETUP SCREEN PINGER IP SETUP SCREEN BO BO BO BO BOX CONTENTS X CONTENTS X CONTENTS X CONTENTS X CONTENTS The IP address for the Pinger Plus is input from this screen. The unit • Pinger Plus Network IP Tester• AC Adapter comes programmed with a default address of 192.168.1.42. • Four AA Alkaline Batteries • User Guide SUBNET MASK SETUP SCREEN SUBNET MASK SETUP SCREEN SUBNET MASK SETUP SCREEN SUBNET MASK SETUP SCREEN SU

Summary of the content on the page No. 3

POR POR POR POR PORT ID SCREEN T ID SCREEN T ID SCREEN T ID SCREEN T ID SCREEN OPERA OPERA OPERA OPERA OPERATION TION TION TION TION Pressing the PortID function key in the Link Screen presents the Port ID To test a hub, switch, router or NIC connect a patch cable from the RJ- Screen. As soon as this screen appears, the Pinger begins transmitting a 45 port on the equipment to the RJ-45 jack on the Pinger Plus. pattern of Link signals that will cause the LINK SCREEN LINK SCREEN LINK SCREEN LINK S

Summary of the content on the page No. 4

Note: When the IP address of the device being PINGed is in the same DHCP SCREEN DHCP SCREEN DHCP SCREEN DHCP SCREEN DHCP SCREEN subnet/VLAN as the IP address of the Pinger, the Subnet Mask can be “ON” Pressing the DHCP function key in the Link Screen presents the DHCP or “OFF” and a Gateway IP address is not required. When the IP address is Screen and begins the DHCP client-server test. in a different subnet/VLAN, the Subnet Mask must be “ON” with the mask Note: The MAC Address of the Pinger ent