Summary of the content on the page No. 1
802.11g SIP DECT VoIP Router
VIP-462DG
User’s manual
1
Summary of the content on the page No. 2
Copyright Copyright (C) 2005 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed products of PLANET Technology, This User’s Manual contains proprietary information protected by copyright, and this User’s Manual and all accompanying hardware, software, and documentation are copyrighted. No part of this User’s Manual may be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable for
Summary of the content on the page No. 3
Revision User’s Manual for PLANET 802.11g SIP VoIP Router: Model: VIP-462DG Rev: 1.0 (Sept. 2005) Part No. EM-VIP462DGV1 3
Summary of the content on the page No. 4
TABLE OF CONTENTS Chapter 1 Introduction .......................................................................... 6 Overview............................................................................................................................6 Package Content ...............................................................................................................7 Physical Details ..................................................................................................
Summary of the content on the page No. 5
Traffic Statistics........................................................................................................29 NAT Settings....................................................................................................................29 Address Mapping......................................................................................................30 Virtual Server...........................................................................................................
Summary of the content on the page No. 6
Chapter 1 Introduction 1 Overview Combining cutting edge Internet telephony and router manufacturing experience, PLANET proudly introduces the newest member of the PLANET VoIP gateway family: the VIP-462DG. To bring the most satisfaction to customers, the VIP-462DG, not only provides quality voice communications, wired/wireless Internet sharing capabilities, but also offers DECT interface for daily wireless telephony communications. With advanced router/firewall, and VoIP DSP processo
Summary of the content on the page No. 7
DECT Features • DECT & GAP Compatible • Base can register up to 8 Handsets • Intercom call during external call, Call transfer between • handsets , three-way telephone meeting • CID 50 locations • Redial memory: 3 locations, 20 digits • Adjustable ringer volume & melody • 100 hours standby time, 8 hours talk time • Hands-Free, Mute function • Call duration time meter • Transmitted distance: up to 50m indoor / up to 300m outdoor Package Content The contents of your product should co
Summary of the content on the page No. 8
Physical Details The following figure illustrates the front/rear panel of VIP-462DG. Front Panel of VIP-462DG Rear Panel of VIP-462DG 8
Summary of the content on the page No. 9
LED Display & Button LED Indicators Descriptions PWR Light: power on, normal operaion Blink: firmware loading Off: power off or failure WAN Light: connection is active Blink: data transmitting or receiving Off: connection is not established VoIP Light: SIP proxy registration is successful Blink: SIP proxy registration is unsuccessful Off: SIP proxy registration is disable WLAN Light: connection is active LAN 1 ~ LAN 4 Light: connection is active Blink: data transmitting or receivi
Summary of the content on the page No. 10
Back Panels Descriptions DC12V Power Adapter connecter RESET (Reboot) Press for one second to reset the device or press for 5 seconds to reset to the factory default. WAN 10/100Mbps RJ-45 connector connect to ADSL or cable modem LAN 1 ~ LAN 4 10/100Mbps RJ-45 connector connect to PC or local switch/hub. LINE Connect to the RJ-11 PSTN line Phone Connect to the RJ-11 phone line Overview of DECT handset DCT-100 10
Summary of the content on the page No. 11
Keypad and button definition on DCT-100 Descriptions INT Intercom conversation mode Adjust the volume level during the conversation and menu selection on the LCD display Last Number Redial Hang on / up telephone or pressing until to open /close speaker C Cancel and Clear Power on / off R Number 0 –9 and # The function is as the same as the general phone set ** Press ** to switch to PSTN DCT-100 installation The three rechargeable Ni-MH batteries (AAA size) come with y
Summary of the content on the page No. 12
This phone won't work by itself. It should be registered to the main base unit inside the VIP-320. Note Before initial using, it should be charged for 24 hours. Reversing the orientation may damage the handset. The battery needs to be replaced if it does not recover Note its full storage capacity after recharging. When replacing batteries, always use good quality Ni-MH re-chargeable AAA size batteries. Never use other batteries or conventional alkaline
Summary of the content on the page No. 13
Chapter 2 2 Preparations & Installation Physical Installation Requirement This chapter illustrates basic installation of VIP-462DG • Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors. • TCP/IP protocol must be installed on all PCs. For Internet Access, an Internet Access account with an ISP, and either of a DSL or Cable modem (for WAN port usage) Administration Interface PLANET VIP-462DG provides GUI (Web based, Graphical User Interface) for machine
Summary of the content on the page No. 14
Please locate your PC in the same network segment (192.168.0.x) of VIP-462DG. If you’re not familiar with Note TCP/IP, please refer to related chapter on user’s manual CD or consult your network administrator for proper network configurations. LAN/WAN Interface quick configurations Nature of PLANET VIP-462DG is an IP Sharing (NAT) device, it comes with two default IP addresses, and default LAN side IP address is “192.168.0.1”, default WAN side IP address is “172.16.0.1
Summary of the content on the page No. 15
WAN IP address configuration via web configuration interface Execute your web browser, and type http://172.16.0.1 in the adddress bar. If you’re using WAN port login the VIP-462DG, please be sure Hint to check if the “Rermote Management” is enabled in machine. After logging on machine with password (default: 123), browse to “WAN” ”Static IP” configuration menu, you will see the configuration screen below: After confirming the modification you’ve done, Please click on the Ap
Summary of the content on the page No. 16
Chapter 3 3 Network Service Configurations Configuring and monitoring your VIP-462DG from web browser The VIP-462DG integrates a web-based graphical user interface that can cover most configurations and machine status monitoring. Via standard, web browser, you can configure and check machine status from anywhere around the world. Overview on the web interface of VIP-462DG With web graphical user interface, you may have: More comprehensive setting feels than traditional command lin
Summary of the content on the page No. 17
VIP-462DG main page 17
Summary of the content on the page No. 18
Chapter 4 4 General Configurations System Settings This page includes all the basic configuration tools for the product, such as options to control management access. Time Zone Set the proper time zone and the configure time server for the VIP-462DG. When you enable “Automatic Time Server Maintenance” option you will need to configure time servers, use the options below to set the primary and secondary NTP servers in your area Password Settings Set the pa
Summary of the content on the page No. 19
Remote Management The "Remote Management" feature can restrict remote user login from the WAN port. The IP setting of "0.0.0.0" allows user from any IP address to remote logged in to the device. When the 'Enabled" is not checked, remote login is disabled. The remote user can login using WAN IP. The default port Hint number is 8080. WAN Settings The VIP-462DG supports 3 types of WAN connection: Dynamic IP (DHCP Client) PPPoE Static IP (factory deault value)
Summary of the content on the page No. 20
Dynamic IP Under this mode, VIP-462DG enables DHCP client to get IP address automatically from your service provider. The Host Name is optional, but may be required by some Service Provider’s. The default MAC address is set to the WAN’s physical interface on the VIP-462DG. If required by service provider, you use the “Clone MAC Address” button to copy the MAC address of the Network Interface Card installed in your PC and replace the WAN MAC address with this MAC address. If necessary, you
