Summary of the content on the page No. 1
User Guide
TL-SF1008P
8-Port 10/100Mbps Desktop PoE Switch
Rev ：1.0.0
7106503865
Summary of the content on the page No. 2
Summary of the content on the page No. 3
COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2012 TP-LINK TECHNO- LOGIE
Summary of the content on the page No. 4
FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio commu
Summary of the content on the page No. 5
2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. CE Mark Warning This is a class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. SAFETY NOTICES Cautions Do not use thi
Summary of the content on the page No. 6
CONTENT Package Contents ...................................................... 1 Chapter 1. Introduction of the Product .......................... 2 1.1 Overview of the Product ...................................... 2 1.2 Convention............................................................ 3 1.3 Features................................................................. 3 Chapter 2. Installation................................................. 4 2.1 Mounting the Switch on a Desk.......
Summary of the content on the page No. 7
Package Contents The following items should be found in your box: One TL-SF1008P 8-Port 10/100Mbps Desktop PoE Switch One DC Power Adapter Four rubber cushions to be used under the Switch This User Guide Note Make sure that the box contains the above items. If any of the listed items are damaged or missing, please contact your distributor. 1
Summary of the content on the page No. 8
Chapter 1. Introduction of the Product Thank you for choosing the TL-SF1008P 8-Port 10/100Mbps Desktop PoE Switch. 1.1 Overview of the Product The TL-SF1008P 8-Port 10/100Mbps Desktop PoE Switch provides the seamless network connection, which integrates 100Mbps Fast Ethernet and 10Mbps Ethernet network capabilities. This PoE Switch is also a Power Sourcing Equipment (PSE*). Four of the eight Auto-Negotiation RJ45 ports (port-1~port-4) on the Switch support Power over Ethernet (PoE*)
Summary of the content on the page No. 9
1.2 Convention The Switch or TL-SF1008P mentioned in this User Guide stands for TL-SF1008P 8-Port 10/100Mbps Desktop PoE Switch without any explanation. 1.3 Features Complies with IEEE802.3, IEEE802.3u, IEEE802.3x, IEEE802.3af standards 8 10/100Mbps Auto-Negotiation RJ45 ports with 4 ports supporting PoE function (port-1~port-4), all of them support Auto-MDI/MDIX Supports PoE power up to 15.4W for each PoE port Supports PoE power up to 53W for PoE ports Supports PoE IEEE802.3a
Summary of the content on the page No. 10
Chapter 2. Installation During the installation procedure, please only use the accessories equipped with the Switch. 2.1 Mounting the Switch on a Desk To install the Switch, please follow the steps: 1) Place the Switch on a flat desk. 2) Remove the adhesive backing papers from the rubber cushions. 3) Turnover the Switch and attach the supplied four rubber cushions to the recessed areas on the bottom at each corner of the Switch. Note 1) Please avoid any heavy thing placed on the S
Summary of the content on the page No. 11
2.2 Power On The TL-SF1008P Switch can be used with DC power supply. Powering on the Switch, it will automatically initialize and its LED indicators will respond as follows: 1) Firstly, the Power LED indicator will light up. 2) Then, the 100Mbps and Link/Act LED indicators will flash momentarily for one second, which represents a resetting of the system. Note If the LED indicators don’t respond as described above, please check the power supply and its connection. Chapter 3. Identif
Summary of the content on the page No. 12
Name Status Indication On The Switch is powered on. (green) Power Off The Switch is powered off. On There is a PoE PD connected to the port, (green) which supply power successfully. PoE Flashing The PoE power circuit may be in short or ports the power current may be overloaded. (green) (port-1~ No PD is connected to the corresponding port-4) Off port ，or no power is supplied according to the power limits of the port. The power of all the connected PoE ports On is >=46W.
Summary of the content on the page No. 13
Note If all PoE PDs power consumption is >= 53W, a priority* will be arranged among the PoE ports like port-1 = port-2 = port-3 > port-4, then the system will cut off the power of the lowest-priority port. *Priority: This function will help protect the system when the system power is overloaded. For example, Port 1, 2 and 4 is using 15.4W (maximum power for per port is 15.4W); the system power is 46.2W in total. If there is an additional PD inserted to Port 3 with 10W, and then the s
Summary of the content on the page No. 14
use it as a 10/100Mbps Auto-Negotiation RJ45 Ethernet port. The working status can be indicated by the corresponding LEDs on the front panel. Ethernet Ports (1-8): Besides the 4 PoE ports, the TL-SF1008P Switch is also equipped with the other four 10/100Mbps Auto-Negotiation RJ45 ports without PoE function. Once the network devices are connected to these 8 ports through the network cable, the Switch will make them plug and play according to the Auto-MDI/MDIX detection. The working st
Summary of the content on the page No. 15
Appendix A: Specifications General Standard IEEE802.3,IEEE802.3u,IEEE802.3x,IEEE802.3af Protocol CSMA/CD Ethernet: 10Mbps (Half Duplex) 20Mbps (Full Duplex) Data Transfer Rate Fast Ethernet: 100Mbps (Half Duplex) 200Mbps (Full Duplex) 10Base-T: UTP category 3, 4, 5 cable (maximum 100m) EIA/TIA-568 100 Ω STP (maximum 100m) Network Media(Cable) 100Base-TX: UTP category 5, 5e cable (maximum 100m) EIA/TIA-568 100 Ω STP (maximum 100m) Number of 8 10/100Mbps Auto-Negotiation R
Summary of the content on the page No. 16
Environmental and Physical 5.8 Watts (max. no PD connected) Power Consumption 58 Watts (max. with 53W PD connected) Operating Temperature 0 ~40 ℃ (32 ~104 ℉ ) Storage Temperature -40 ~70℃(-40 ~158 ℉) Operating Humidity 10%~90% non-condensing Storage Humidity 5%~90% non-condensing 10
