Summary of the content on the page No. 1
TM-1020 Series Progressive Scan Shutter Cameras
Operation Manual
69-0076
Rev. D
Summary of the content on the page No. 2
Page ii
Summary of the content on the page No. 3
R G E N I G G I A A S M S I T S O E D C E Page iii Notice The material contained in this manual consists of information that is proprietary to JAI, Inc., and may only be used by the pur- chasers of the product. JAI, Inc. makes no warranty for the use of its product and assumes no responsibility for any errors which may appear or for damages resulting from the use of the information contained herein. JAI, Inc. reserves the right to make changes without notice. Microsoft, Windows 98, Windows 95,
Summary of the content on the page No. 4
Page iv
Summary of the content on the page No. 5
Page v Table of Contents Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . v List of Tables. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . vii List of Figures. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .ix 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.1 Product Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1.2 Featur
Summary of the content on the page No. 6
Page vi 3.6.5 External VINIT with Pulse Width (TM-1020-15 Only) . . . . . . . . . 25 3.7 Dynamic Range Control . . . . . . . . . . . . . . . . . . . . . . . . . . 26 3.7.1 Programmable Look-Up Table (LUT) and Knee Control . . . . . . . . 26 3.8 Scan Modes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 3.8.1 Full Progressive Scan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 3.8.2 Two-Row Binning . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 7
Page vii List of Tables TABLE 1. 12-Pin Connector (LVDS/RS-422 version) . . . . . . . . . . . . . . . . . . . . . . . . 6 TABLE 2. 12-Pin Connector (CL Version) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 TABLE 3. 31-Pin Connector (MP211-031-113-4300) . . . . . . . . . . . . . . . . . . . . . . . . 8 TABLE 4. Connector and Pin-out Configurations . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 TABLE 5. Shutter Speed Control Dial . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 8
Page viii List of Tables
Summary of the content on the page No. 9
Page ix List of Figures FIGURE 1. TM-1020 Series System Configuration . . . . . . . . . . . . . . . . . . . . . .4 FIGURE 2. CL (Camera Link) System Configuration . . . . . . . . . . . . . . . . . . . .4 FIGURE 3. Rear Panel View of Digital Connector. . . . . . . . . . . . . . . . . . . . . . .8 FIGURE 4. Serial Communication Cable RS-232B-12 . . . . . . . . . . . . . . . . . .10 FIGURE 5. Digital Output Cable 30DG-02 . . . . . . . . . . . . . . . . . . . . . . . . . . .11 FIGURE 6. Pin-out Conf
Summary of the content on the page No. 10
Page x List of Figures
Summary of the content on the page No. 11
May 31, 2007 TM-1020 Series Progressive Scan Shutter Cameras Operation Manual 1 Introduction 1.1 Product Description 1 The JAI, Inc. TM-1020 series consists of high-resolution, high-speed monochrome progressive scan CCD cameras. The interline-type CCD permits full vertical and horizontal resolution of very high speed shutter images and applications. The electronic shutter, which has speeds to 1/16,000 sec., can be reset asynchronously by external puls
Summary of the content on the page No. 12
Page 2 TM-1020 Series Progressive Scan Shutter Cameras 1.2 Features • Miniature size and light weight The printed circuit boards in the TM-1020 series have been arranged based on a new design philosophy. This creates modular electronics for the camera, giving it flexibility. In addition, the use of miniature solid-state components results in a compact, lightweight camera that is 44mm x 44mm x 64mm in dimensions, and weighs only 149 grams. • Imager The TM-1020 series uses a progressive-scan
Summary of the content on the page No. 13
Page 3 TM-1020 Series Progressive Scan Shutter Cameras - Internal shutter speed with Slow mode. The speed control varies from 1/125 to 1/1,000 sec. The video signal starts with internal V reset timing related to shutter speed. • Output The TM-1020 series has an 8-bit RS-644 digital output for interfacing with external image- processing systems (TM-1020-15 is RS-422 only) with RS-644 digital output available as an option. Camera Link models are designated by the letters “CL” at the end of the c
Summary of the content on the page No. 14
4 7 6 5 3 4 3 2 2 1 1 Page 4 TM-1020 Series Progressive Scan Shutter Cameras 1.4 System Configuration FIGURE 1. TM-1020 Series System Configuration Figure 1 below presents a typical system configuration for the LVDS/RS-422 version. UP 0 0 DOWN SHUTTER MODE 30DG-02 DIGITAL 1 9 2 8 10 3 11 12 7 4 6 5 RS-232B-12 cable in POWER VIDEO CS-232E kit BNC cable 12-pin connectors Analog video Computer with frame-grabber board PD-12 (series) power supply OR 12P-02S Power and Ext. Sync FIGURE 2. CL (
Summary of the content on the page No. 15
Page 5 TM-1020 Series Progressive Scan Shutter Cameras 2 Installation The following instructions are provided to help you to set up your camera quickly and easily. We suggest that you read through these instructions before you unpack and set up your camera system. 2.1 Getting Started 2.1.1 Unpacking Instructions We recommend that you save the original packing cartons for the cameras and accessories in case you need to return or exchange an item. We also recommend that you bench-test any equip
Summary of the content on the page No. 16
Page 6 TM-1020 Series Progressive Scan Shutter Cameras For optimal performance, JAI, Inc. recommends using a cooling fan to set up a positive air flow around the camera and following the precautions below. • Mount the camera on a large heat sink (camera bracket) made out of conductive material like alu- minum. • Make sure the flow of heat from the camera case to the bracket is not blocked by a non-conductive material like plastic. • Make sure the camera has enough open space around it to fac
Summary of the content on the page No. 17
Page 7 TM-1020 Series Progressive Scan Shutter Cameras 2.2.2 (b) 12-Pin Connector (Camera Link Version) The CL versions have a 12-pin Hirose connector for power input and signal integration. Pin #1 is Ground and pin #12 is +12V DC. The pin-out table is shown below. For TM-1020-15CL, serial communication camera control is done via the Camera Link connector on the rear panel of the camera. TABLE 2. 12-Pin Connector (CL Version) 1 9 2 8 Pin Description Pin Description 10 1 GND 7 VD in 3 7 11
Summary of the content on the page No. 18
Page 8 TM-1020 Series Progressive Scan Shutter Cameras 2.2.2 (c) Digital Output Connector (LVDS/RS-422 only) The LVDS/RS-422 version has a 31-pin AirBorn connector (MP211-031-113-4300) on the rear panel to output 8-bit, RS-644 video data. The TM-1020-15 is 8-bit, RS-422 video data. The connector pin-out is shown in the figure below. FIGURE 3. Rear Panel View of Digital Connector 1 16 31 17 1 TABLE 3. 31-Pin Connector (MP211-031-113-4300) Pin# Description I/O Pin # Description I/O 1 CLK+ Out
Summary of the content on the page No. 19
Page 9 TM-1020 Series Progressive Scan Shutter Cameras The CL version has a 26-pin connector on the rear panel to output Camera Link data. The connector pin-out is shown in Table 4 on page 9. 13 1 26 14 TABLE 4. Connector and Pin-out Configurations Camera Link Connector Pin # Description I/O Pin # Description I/O 1 GND 14 GND (Shield) 2 Tx OUT 0- Out 15 Tx OUT 0+ Out 3 Tx OUT 1- Out 16 Tx OUT 1+ Out 4 Tx OUT 2- Out 17 Tx OUT 2+ Out 5 Tx CLK OUT - Out 18 Tx CLK OUT+ Out 6 Tx OUT 3- Out 19 Tx OU
Summary of the content on the page No. 20
190±5mm 75mm±5mm Page 10 TM-1020 Series Progressive Scan Shutter Cameras 2.2.3 Shutter Speed Control Dial (LVDS/RS-422 version) Shutter speed can be selected by switching the shutter dial to the appropriate setting (0 through 9). The factory default settings correspond to the shutter speeds as shown in Table 5 below. TABLE 5. Shutter Speed Control Dial Manual Async 0 no shutter no shutter 1 1/60 1/16,000 2 1/125 1/8,000 3 1/250 1/4,000 4 1/500 1/2,000 5 1/1000 1/1,000 6 1/2,000 1/500 7 1/4,000
