Summary of the content on the page No. 1
MP6312i
Instruction Manual
Summary of the content on the page No. 2
Summary of the content on the page No. 3
MP6312i INTRODUCTION Congratulations on your purchase of the Jensen MP6312i Mobile Receiver. • Chassis Mounted Rear Auxiliary Inputs It’s a good idea to read all of the instructions before beginning the General installation. We recommend having your Jensen MP6312i installed by a • Infrared Remote Control reputable installation shop. • Programmable Volume Control Features • Three Preset EQ Curves • Loudness CD / MP3 / WMA • Rotary Encoder Audio Control • ID3 Tag Compatible • 12/24 Hour Clock •
Summary of the content on the page No. 4
M MP6212 P6212 M MOSFET OSFET P POWERED OWERED PTY PTY / CH/CA CH/CAT T SCAN AS D DN N U UP P MP6312i INSTALLATION This unit is designed for installation in cars, trucks and vans with an existing 2. Remove Transport Screws radio opening. In many cases, a special installation kit will be required to mount the radio to the dashboard. These kits are available at electronics TRANSPORT supply stores and car stereo specialty shops. Always check the kit SCREWS HALF application before purchasing t
Summary of the content on the page No. 5
MP6312i 4. Place the radio in front of the dashboard opening so the wiring can be ISO Installation brought through the mounting sleeve. Follow the wiring diagram This unit has threaded holes in the chassis carefully and make certain all connections are secure and insulated side panels which may be used with the with wire nuts or electrical tape. See “Wiring” on page 5. After original factory mounting brackets of some completing the wiring connections, turn the unit on to confirm operation
Summary of the content on the page No. 6
MP6312i Technical Assistance If you require assistance, contact Technical Support at 1-800-323-4815 from 8:30am to 7:00pm EST Monday through Friday and from 9:00am to 5:00pm EST on Saturday. 4
Summary of the content on the page No. 7
MediaLink MP6312i WIRING NOTE: The amplifier in this MediaLink Connector radio is only designed for use Satellite Radio In with four speakers. Never Antenna combine (bridge) outputs for Connect the antenna plug use with two speakers. Never from the existing antenna ground negative speaker cable (some vehicles Fuse (15 amp fast blow ATO) leads to chassis ground. require an adaptor). Failure to wire exactly as shown may cause electrical Satellite Radio Audio In damage to the radio. NOTE:
Summary of the content on the page No. 8
MP6312i FRONT PANEL RELEASE The front panel release button (4) releases the mechanism that holds the front panel to the chassis. Detaching the Front Panel To detach the front panel, first press the front panel release button to release the left side of the panel. Next, grasp the released side and pull it off the chassis. After removing the front panel, store it in the supplied carrying case to protect it from dirt and damage. Re-attaching the Front Panel To re-attach the front panel, make s
Summary of the content on the page No. 9
T T T T C C C C L L L L E E E E E E E E S S S S H H H H S S S S PU PU PU PU MP6312i OPERATION Power Press the power button (2) to turn the unit on. Press and hold the power button again to turn the unit off. NOTE: LCD panels may take longer to respond when subjected to cold SAT MP6312i READY temperatures for an extended period of time. In addition, the visibility MOSFET POWERED PTY of the numbers on the LCD may decrease slightly. The LCD display / CH/CAT will return to normal when the temper
Summary of the content on the page No. 10
MP6312i Equalizer Selector Frequency Spacing The equalizer function applies preset sound effects to the unit’s audio This option allows you to select the appropriate frequency spacing for your output signal. Press EQ (16) to step through the following equalizer options: area. “U.S.A.” is the default setting. Turn the rotary encoder to select “ROCK”, “HIP-HOP”, “DANCE”, and “EQ OFF”. “EUROPE”. When the equalizer function is activated, the most recently selected bass/ Local/Distant Reception
Summary of the content on the page No. 11
MP6312i TUNER OPERATION The MP6312i allows you to receive channels in U.S.A. or EUROPE mode. Preview Scan See “Frequency Spacing” on page 8 to learn how to change the tuner Press the SCAN button (14) to scan all strong stations in the current band. options. The unit will stop at each station for five seconds before continuing to the next station. Press SCAN again to stop scanning and listen to the current station. Automatic Store (AS) Select six strong stations and store them in the current
Summary of the content on the page No. 12
MP6312i • Religious Music • Religious Talk • Personality • Public • College • Weather • Emergency Test • Emergency To search for stations in a PTY category: 1. Press the PTY button (15) to view the current PTY category. 2. Use the TUNE/TRACK >>| or |<< buttons (17) to move through the list of available categories. 3. After 2 seconds of inactivity, the radio will automatically scan and play the first station it locates in the selected category. NOTE: PTY is a new broadcast technology that may
Summary of the content on the page No. 13
MP6312i CD PLAYER OPERATION Insert and Eject CD Insert a CD, label side up. To stop CD play and eject the CD, press the eject button (1). NOTE: The unit is designed for play of standard 5” (12 cm.) compact SAT MP6312i READY discs only. Do not attempt to use 3” (8 cm.) CD singles in this unit, MOSFET POWERED PTY either with or without an adaptor, as damage to the player and/or the / CH/CAT disc may occur. Such damage will not be covered by the warranty on SCAN AS iPod this product. DN UP Pau
Summary of the content on the page No. 14
MP6312i MP3/WMA OPERATION MP3 and WMA (Windows Media Audio) music files are digital audio files • Transfer bit rate : 8 - 320 kbps that are compressed to allow more files on a single CD. This unit can play • Sampling frequency: 8, 11.025, 12, 16, 22.05, 24, 32, 44.1, 48 kHz MP3/WMA directly from files contained on a CD-R/RW using the buttons on When using a CD writer to record MP3/WMA up to the maximum disc the receiver (or optional remote control) as described below. Many types of capacity,
Summary of the content on the page No. 15
MP6312i As a result, the order in which they are expected to be played may not match the order in which they are actually played. You may be able to set the order in which MP3/WMA files are to be played by writing them onto a medium such as a CD-R with their file names beginning with play sequence numbers such as "01" to "99". For example, a medium with the following SAT MP6312i READY folder/file hierarchy is subject to Folder Search, File Search or Folder Select MOSFET POWERED PTY as show
Summary of the content on the page No. 16
MP6312i Navigating Folders Navigation Search Press the folder UP (21) button (also the “5” button) to advance 10 songs. 1. Press the AS button (13) twice. The LCD will display "Navigate". Press the folder DN (20) button (also the “6” button) to move 10 songs in 2. Turn the rotary encoder (5) to navigate through all folders and sub- reverse. folders on the disc. The folder names will be displayed on the LCD. • Press the MENU button (5) for more than three seconds to play the Press and hold t
Summary of the content on the page No. 17
MP6312i SATELLITE RADIO OPERATION Selecting a Station ® Listeners can subscribe to XM Radio on the Web by visiting Press the TUNE/TRACK >>| or |<< button (17) to change to another www.xmradio.com, or by calling (800) 967-2346. Customers should station. Press and hold the TUNE/TRACK >>| or |<< button for more than have their Radio ID ready (see “Displaying the Identification (ID) one second to fast forward or fast reverse through the stations. Code”). Customers can receive a limited number o
Summary of the content on the page No. 18
MP6312i NOTE: If the channel is unauthorized or invalid, “CH Unavail” appears on the LCD and the unit returns to the input interface after 2 seconds. Category Tuning Mode To select stations in a specific category, perform the following steps. 1. Press the AS button (13) twice. “CATEGORY” appears on the screen. 2. Turn the rotary encoder to move through the available categories. 3. Press the MENU button (5) to select the displayed category. 4. Once a category is selected, turn the rotary encode
Summary of the content on the page No. 19
MP6312i IPOD OPERATION • CMPOSER Press the MENU button (5) to select an option. At any point, you can press the 6 UP button (21) to return to the previous option. Some search categories require multiple selections before accessing a track, depending on the file structure on your iPod and availability of items SAT MP6312i READY MOSFET POWERED in a particular search category. For example, after selecting GENRE you PTY / CH/CAT may be required to select GENRE > ARTIST > ALBUM > SONG before SCA
Summary of the content on the page No. 20
MP6312i REMOTE CONTROL The remote control will allow you to control the basic functions of the Replacing the Battery MP6312i. When the range of operation of the card remote control becomes short or stops functioning, replace the battery with a new lithium battery. Be sure to observe the proper polarity, as indicated below. (CR2025) MUTE SRC VOL SEL AMS MENU SEARCH TA AF/REG EQ BAND 1 2 4 1 2 3 /TOP INT RPT RDM DISP 5 6 Operating Range The remote control sensor (19) is located to the right of t
