Summary of the content on the page No. 1
use
hp LaserJet 1005 series
Summary of the content on the page No. 2
blank.fm Page 2 Thursday, October 10, 2002 9:27 AM
Summary of the content on the page No. 3
HP LaserJet 1005 Series Printer User Guide
Summary of the content on the page No. 4
© Copyright Hewlett-Packard Company 2003 Warranty Trademark Credits ® ® All Rights Reserved. Reproduction, The information contained in this document is Microsoft , MS Windows, Windows , and ® adaptation, or translation without prior written subject to change without notice. MS-DOS are U.S. registered trademarks of permission is prohibited, except as allowed Microsoft Corporation. Hewlett-Packard makes no warranty of any under the copyright laws. ® kind with respect to this information. ENER
Summary of the content on the page No. 5
Content 1 Getting started Review the package contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Prepare the location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Regulate the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Install the printer software . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 6
5 Managing the print cartridge Using HP print cartridges. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 HP policy on non-HP print cartridges . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 Storing print cartridges . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34 Print cartridge life expectancy . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 7
Appendix B Media specifications Printer media specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74 Supported media sizes (printer) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 74 Guidelines for using media . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 75 Paper. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 8
6 Content ENWW
Summary of the content on the page No. 9
Getting started 1 This chapter provides the following instructions for installing the software and setting up the printer: ● Review the package contents ● Prepare the location ● Regulate the environment ● Install the printer software ● Open the print cartridge door ● Remove the left cover ● Connect the printer cable ● Prepare the print cartridge ● Install the print cartridge ● Load the paper input tray ● Connect the power cord ● Troubleshooting the printer ● Installation is complete ENWW 7
Summary of the content on the page No. 10
Review the package contents 2 1 4 3 6 5 Make sure that all of the parts are included. 1 Printer 2 Print cartridge (in protective bag) 3 Getting Started Guide 4 Software and electronic user guide (on one CD-ROM) 5 Power cord 6 Paper input tray Prepare the location 486 mm (19.1 in.) Place the printer on a sturdy, level surface. Allow space for ventilation. Allow space behind the printer for output from the straight-through output door. 8 Chapter 1 Getting started ENWW 253 mm (10.0 in.)
Summary of the content on the page No. 11
Regulate the environment Do not place the printer in direct sunlight. Make sure that the environment is free from abrupt temperature or humidity changes. ● Temperature – 50° to 91° F (10° to 32.5° C) ● Relative humidity – 20% to 80% Install the printer software To install the printer software from the CD 1 Select Install from the autorun screen. If autorun does not occur, in the Windows system tray, click Start, click Run, type x:\setup (where x is the letter of the CD-ROM drive), and click O
Summary of the content on the page No. 12
Open the print cartridge door Firmly grasp the left and right sides, and pull the print cartridge door toward you. Remove the left cover Pull out on the rear of the cover, and rotate it away from the printer. Connect the printer cable Plug the printer cable into the printer (A). Plug the printer cable into the PC (B). 10 Chapter 1 Getting started ENWW
Summary of the content on the page No. 13
Prepare the print cartridge Remove the print cartridge from the plastic bag. To remove the mylar tape, break the tab on the left, and pull the tape completely out. Install the print cartridge Insert the print cartridge into the printer, making sure that the print cartridge is in position. ENWW Install the print cartridge 11
Summary of the content on the page No. 14
Load the paper input tray 3 3 1 4 2 1 Slide the paper input tray in and down at an angle until it fits securely in the printer. 2 Slide the media guides out and back to accommodate the media. 3 Place the media in the paper input tray. Slide the media guides until they are flush with the media. 4 Install the paper input tray cover. Connect the power cord Plug the power cord into the printer (A). Plug the power cord into the power receptacle (B). 12 Chapter 1 Getting started ENWW
Summary of the content on the page No. 15
Troubleshooting the printer If the top status light is on, the printer is ready to print. If no status lights are on, check the power cord and the printer cable connections. CAUTION Before you connect the cable to the printer, always unplug the printer. Otherwise, the printer might be damaged. Installation is complete Congratulations! Your HP LaserJet 1005 Series Printer is ready to use. If you had any problems, see Troubleshooting the printer or go to HP’s support Web site at http://www.hp.c
Summary of the content on the page No. 16
14 Chapter 1 Getting started ENWW
Summary of the content on the page No. 17
Getting to know the printer 2 This chapter provides information on the following topics: ● Identifying the printer’s components ● Turning the power off ● Understanding voltage conversions ENWW 15
Summary of the content on the page No. 18
Identifying the printer’s components 7 1. Status lights 2. Paper input tray 1 3. Long media support for the paper input tray 4. Side media guides for the paper input tray 5. Print cartridge door 6. Output bin 7. Long media extension (output bin) 2 6 3 4 5 8 8. Media jam release levers 9. Straight-through output door 10. Power switch 11. Power receptacle 12. USB port 13. Parallel port 14. Left cover 9 10 11 12 13 14 16 Chapter 2 Getting to know the printer ENWW
Summary of the content on the page No. 19
Status lights The status lights produce patterns that identify the printer’s status. Ready light (green) Attention light (amber) ● Ready light: Indicates that the printer is ready to print or the printer is processing data. ● Attention light: Indicates that the paper input tray is empty, the print cartridge door is open, the print cartridge is missing, or another type of error occurred. Note See Status light patterns for a description of the light patterns. Printer paper input tray The en
Summary of the content on the page No. 20
Printer media guides The paper input tray has a long media support and side media guides. Media guides ensure that the media is correctly fed into the printer and that the print is not skewed (crooked on the media). When loading media, adjust the media guides to match the width and length of the media that you are using. Printer output paths Output bin The output bin is located on the top of the printer. Printed media is collected here in the correct sequence when the straight-through
