Summary of the content on the page No. 1
Basic Useful
Introduction Quick Start Setup Connections Appendix
Operation Features
DATA PROJECTOR
MODEL
PG-F320W
OPERATION MANUAL
Summary of the content on the page No. 2
IMPORTANT • For your assistance in reporting the loss Model No.: or theft of your Projector, please record the Model and Serial Number located on the bottom of the projector and retain this Serial No.: information. • Before recycling the packaging, please ensure that you have checked the con- tents of the carton thoroughly against the list of “Supplied accessories” on page 11. ii
Summary of the content on the page No. 3
SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporat- ing a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted. In the unlikely event of the socket outlet in your home not being comp
Summary of the content on the page No. 4
The supplied CD-ROM contains operation instructions in English, German, French, Spanish, Italian, Dutch, Swedish, Portuguese, Chinese and Korean. Carefully read through the operation instructions before operating the projector. Die mitgelieferte CD-ROM enthält Bedienungsanleitungen in Englisch, Deutsch, Französisch, Spanisch, Italienisch, Niederländisch, Schwedisch, Portugiesisch, Chinesisch und Koreanisch. Bitte lesen Sie die Bedienungsanleitung vor der Verwendung des Projektors sorgfältig durc
Summary of the content on the page No. 5
Introduction Before using the projector, please read this operation manual carefully. Introduction ENGLISH There are two important reasons for prompt warranty registration of your new SHARP Projector, using the REGISTRATION CARD packed with the projector. 1. WARRANTY This is to assure that you immediately receive the full benefit of the parts, service and labor warranty applicable to your purchase. 2. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptly receive any safety notification of
Summary of the content on the page No. 6
INFORMATION This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the operation manual, may cause harmful interference to radio communications. Operat
Summary of the content on the page No. 7
Introduction Useful Features How to Read this Operation Manual ■ The specifications are slightly different, depending on the model. However, you can connect and operate all models in the same manner. ••• In this operation manual, the illustration and the screen display are simplified for explanation, and •• may differ slightly from the actual display. Using the Menu Screen ENTER button Adjustment buttons (P/R/O/Q) MENU/HELP button ENTER button Adjustment buttons (P/R/O/Q) Buttons used in RETURN
Summary of the content on the page No. 8
Contents Preparing Introduction Useful Features How to Read this Operation Manual .... 3 Operating with the Remote Control .... 33 Contents ............................................... 4 Displaying and Setting the Break Timer........................................ 33 IMPORTANT SAFEGUARDS ............... 6 Displaying the Pointer .......................... 33 How to Access the PDF Operation Using the Spot Function ...................... 33 Manuals ............................................ 1
Summary of the content on the page No. 9
Introduction Setting up the Projector Network Environment (“Network” menu) ........ 49 Setting a Password .............................. 49 DHCP Client Setting ............................. 50 TCP/IP Setting ...................................... 50 Confirming the Projector Information... 50 Troubleshooting with the “Help” Menu ...................................... 51 Utilizing the “Help” Menu Functions .... 51 Reference Appendix Maintenance ....................................... 52 Cleaning a
Summary of the content on the page No. 10
IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to assure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use and servicing. 1. R
Summary of the content on the page No. 11
Introduction 15. Overloading 19. Replacement Parts Do not overload wall outlets, extension cords, or When replacement parts are required, be sure integral convenience receptacles as this can the service technician has used replacement result in a risk of fire or electric shock. parts specified by the manufacturer or have the same characteristics as the original part. 16. Object and Liquid Entry Unauthorized substitutions may result in fire, Never push objects of any kind into this product electr
Summary of the content on the page No. 12
Observe the following safeguards when setting up your projector. Caution concerning the lamp unit When using the projector in high-altitude ■ Potential hazard of glass par- areas such as mountains (at altitudes of ticles if lamp ruptures. In case approximately 1,500 meters (4,900 feet) of lamp rupture, contact your or more) nearest Sharp Authorized ■ When you use the projector in high-altitude Projector Dealer or Service areas with thin air, set “Fan Mode” to “High”. Center for replacement. Negl
Summary of the content on the page No. 13
Introduction Temperature monitor function Caution regarding usage of the projector ■ If you are not to use the projector for a long time or before moving the projector, make certain you unplug the power cord from the wall outlet, and disconnect any other cables ■ If the projector starts to overheat due to setup connected to it. problems or blockage of the air vents, “ ” and ■ If the power cord is unplugged while the “ ” will illuminate in the lower left corner cooling fan is running, some parts
Summary of the content on the page No. 14
How to Access the PDF Operation Manuals PDF operation manuals in several languages are included in the CD-ROM. To uti- ® ® lize these manuals, you need to install Adobe Reader on your computer (Win- ® ® dows or Macintosh ). ® ® Please download Adobe Reader from the Internet (http://www.adobe.com). Accessing the PDF Manuals ® ® For Windows : For Macintosh : 1 Insert the CD-ROM in the CD-ROM drive. 1 Insert the CD-ROM in the CD-ROM drive. 2 Double click the “My Computer” icon. 2 Double click the “
Summary of the content on the page No. 15
Introduction Accessories Supplied accessories Two R-6 batteries RGB cable Lens cap (attached) (“AA” size, UM/SUM-3, (10' (3.0 m)) HP-7 or similar) Remote control DIN-D-sub RS-232C adaptor Storage case 57 (5 / " (15 cm)) 64 Power cord* (1) (2) (3) (4) For U.S. and For Europe, For U.K. and For Australia, New Canada, etc. except U.K. Singapore Zealand and Oceania (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m))
Summary of the content on the page No. 16
Part Names and Functions Numbers in Z refer to the main pages in this operation manual where the topic is explained. Projector Top View Power 26 26 Lamp indicator indicator 55 55 Temperature warning 55 indicator STANDBY/ON 26 button For turning the power on and VOL (Volume) buttons 30 putting the (–O/Q+) projector into For adjusting the standby mode. speaker sound level. INPUT buttons (P/R) ENTER button 30 39 For switching input For setting mode. items selected or adjusted on MENU/HELP 39 the me
Summary of the content on the page No. 17
Introduction Numbers in Z refer to the main pages in this operation manual where the topic is explained. Rear View Terminals S-VIDEO input terminal MONITOR OUT terminal 22 23 Terminal for connecting (Output terminal for computer RGB, video equipment with an component and DVI analog signals. Shared S-video terminal. for COMPUTER/COMPONENT and DVI-I) Terminal for connecting a monitor. USB terminal 35 Terminal connecting DVI-I input terminal 21 with the USB terminal Terminal for DVI 22 on the compu
Summary of the content on the page No. 18
Part Names and Functions (Continued) STANDBY button ON button 26 26 For turning the power For putting the projector on. into the standby mode. FREEZE button 34 COMPUTER, DVI, 30 For freezing images. S-VIDEO, VIDEO buttons AV MUTE button 30 For switching to the For temporarily respective input modes. displaying a black screen and turning BREAK TIMER button 33 off the sound. For displaying the break time. VOL +/– (Volume) 30 buttons MAGNIFY buttons 34 For adjusting the For enlarging/reducing speak
Summary of the content on the page No. 19
Introduction Inserting the Batteries Pull down the tab on the cover and remove the cover 1 towards the direction of the arrow. Insert the batteries. 2 • Insert the batteries making sure the polarities correctly match the m and n marks inside the battery compartment. Insert the lower tab of the cover into the opening, 3 and lower the cover until it clicks in place. Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below. Caution • Danger of explosion
Summary of the content on the page No. 20
Quick Start This section shows the basic operation (projector connecting with the computer). For details, see the page described below for each step. Setup and Projection In this section, connection of the projector and the computer is explained using one example. 3 8 STANDBY button STANDBY/ON 8 button ON button 3 INPUT buttons 6 ENTER button 4 COMPUTER button 6 Adjustment buttons 5 (P/R/O/Q) 5 KEYSTONE button 4 ENTER button Zoom ring 4 Focus ring 4 Adjustment buttons 5 (P/R/O/Q) KEYSTONE button
