Summary of the content on the page No. 1
Storage Device Division
MK6017MAP
(HDD2155)
HARD DISK DRIVE
PRODUCT SPECIFICATION
Rev 00
October 2000
DOCUMENT NUMBER
14603
Summary of the content on the page No. 2
360014937 2.5 inch Disk Drives MK6017MAP Product Specification ’ Copyright ©2000 Toshiba corporation. All rights reserved. - 502 -
Summary of the content on the page No. 3
360014937 ＳＡＦＥＴＹ ＳＡＦＥＴＹ ＳＡＦＥＴＹ ＳＡＦＥＴＹ The hard disk drive and product specifications contain essential information for the protection of users and others from possible injury and property damage and to ensure correct handling. Please check that you fully understand the definition of the following messages (signs and graphical symbols) before going on to read the text, and always follow the instructions. Please describe requirements in the instruction manual of the product in which t
Summary of the content on the page No. 4
360014937 USAGE RESTRICTIONS Since the drive is not designed or manufactured to be used for a system including equipment (*1) directly linked with human life, etc., Toshiba Corporation shall not be liable for this type of use. *1: Equipment directly linked with human life, etc. corresponds to the following. Medical equipment such as life support systems, equipment used in operations etc. When the drive is to be used for a system including equipme
Summary of the content on the page No. 5
360014937 SAFETY Do not disassemble, remodel or repair. Disassembly, remodeling or repair may cause injury, failure, or data loss. Do not drop. Dropping may cause injury. Do not touch sharp edges or pins of the drive. Sharp protrusions etc. may cause injury. Hold the drive by both sides when carrying it. Copyright © 2000 Toshiba corporation. All rights reserved. - 505 -
Summary of the content on the page No. 6
360014937 SAFETY Observe the following to prevent failure, malfunction or data loss. NOTE Follow the specifications for 6. POWER SUPPLY (page516), 8. ENVIRONMENT (page 522, 523), etc. when using. Failure to do so may cause damage to the drive. Observe cautions in 7.4 MOUNTING INSTRUCTION (page517) and 9.6 LOAD / UNLOAD (page525 ) when handling, setting up, or using the drive. Take anti-static measures in order to avoid damage to the drive when handling it. The drive
Summary of the content on the page No. 7
360014937 TABLE OF CONTENTS 1. SCOPE......................................................................................................................................................................... 511 2. GENERAL DESCRIPTION....................................................................................................................................... 511 3. KEY FEATURES.............................................................................................................
Summary of the content on the page No. 8
360014937 10.3.5 Signal Description.....................................................................................................................................531 10.4 HOST INTERFACE TIMING ...................................................................................................................................533 10.4.1 Program I/O Write Timing.........................................................................................................................533 10.4.2
Summary of the content on the page No. 9
360014937 10.9.1 Security mode default setting..................................................................................................................... 609 10.9.2 Initial setting of the user password............................................................................................................ 609 10.9.3 Security mode operation from power-on ................................................................................................... 610 10.9.4 Password lost...
Summary of the content on the page No. 10
360014937 Table of Figures FIGURE 1 MK6017MAP DIMENSIONS.............................................................................................................................519 FIGURE 2 MOUNTING RECOMMENDATION......................................................................................................................521 FIGURE 3 ATA INTERFACE CONNECTOR........................................................................................................................
Summary of the content on the page No. 11
360014937 1. SCOPE This document describes the specifications of the following model, MK6017MAP of 2.5- inch type Winchester disk drives. . Factory Number Sales Number HDD2155 MK6017MAP 2. GENERAL DESCRIPTION The MK6017MAP which is noted hereinafter as MK6017MAP or as the drive comprises a series of intelligent disk drives . The drive features an ATA-2 / 3 / 4 /5 interface embedded controller that requires a simplified adapter board for interfacing to an AT or AT compatible bus
Summary of the content on the page No. 12
360014937 SAFETY Do not disassemble, remodel or repair. Disassembly, remodeling or repair may cause injury, failure, or data loss. NOTE There is a certain probability of the drive causing failure including data error or data loss. Take preventive steps such as backing up data etc. without exception in order to prevent loss etc. in cases where data loss may result in loss or damage. Do not touch the top cover since application of force to it may cause damage to t
Summary of the content on the page No. 13
360014937 3. KEY FEATURES • High capacity in smallest size . 2.5inch-type 1platters accommodating formatted capacity of 6.007GB, . Slim ( 9.5 mm in height ) and light (92 gram in weight) design. • Fast access and fast transfer rate . Quick spin up of Spindle Motor 4 sec. . Average access time 13 msec enabled by optimized balance of a head actuator assembly and an efficiently designed magnet of rotary VCM. . Bus transfer rate up to 66.7 megabytes per second and disk transfe
Summary of the content on the page No. 14
360014937 4. BASIC SPECIFICATION MODEL MK6017MAP Formatted Capacity( gigabytes ) 6.007 Servo design method Sector Servo Recording method 32/34 TC-MEEPR4+PP Recording density Track / mm (TPI ) 1667 (42.3k) Bit / mm ( BPI ) 20.8k (528k ) max. Flux change / mm ( FRPI ) 22.1k(561k ) max. Number of disks 1 Number of data heads 1 Number of user data cylinders 24,800 Bytes per sector 512 Copyright ©2000 Toshiba corporation. All rights reserved. - 514 -
Summary of the content on the page No. 15
360014937 5. PERFORMANCE Access time ( msec ) <*1> Track to track seek <*2> 3 Average seek <*3> 13 Max. seek <*4> 24 Rotation speed ( RPM ) 4,200 + 0.1% Average Latency Time ( msec ) 7.14 Internal Transfer rate ( Mbits / sec ) 133.0 253.5 Host Transfer rate ( Mbytes / sec ) Ultra DMA mode 66.7 PIO mode 16.6 Sector Interleave 1:1 Track skew Yes Buffer size ( Kbytes ) 256 Cache Read Ahead Cache Write Cache Start time <*5> 4 sec ( Typical ) ( Up
Summary of the content on the page No. 16
360014937 6. POWER REQUIREMENTS 6.1 Supply Voltage 6.1.1 Supply for Logic Allowable voltage 5V + 5% Allowable noise/ripple 100 mV p-p or less 6.1.2 Supply for Motor Allowable voltage 5V + 5% Allowable noise/ripple 100 mV p-p or less 6.2 Power Consumption Average (note 3) Maximum (note 4) Start 2.7 W Typical 5.6 W (note5) Seek (note 7) 2.3 W Typical 3.8 W (note6) Read
Summary of the content on the page No. 17
360014937 7. MECHANICAL SPECIFICATIONS 7.1 Dimension Width 69.85mm ( 2.75” ) Height 9.5 mm ( 0.37”) Depth 100.0 mm ( 3.94” ) Figure 1 and Table 7.4-1 show an outline of the drive. 7.2 Weight 92gram(Typ.) 94gram(max.) 7.3 Drive Orientation The drive can be installed in all axes (6 directions). 7.4 Mounting Instructions SAFETY NOTE Take anti-static measures in order to avoid damage to the drive when handling it. The drive uses parts susc
Summary of the content on the page No. 18
360014937 7.4.1 Screwing . . Four screws should be tightened equally with 0.3 N m ( 3 kgf cm ) torque. The depth should be 3.0 mm min. and 3.5 mm maximum. 7.4.2 Installation The drive should be mounted carefully on the surface of 0.1mm or less flatness to avoid excessive distortion. In order to prevent short-circuit under any circumstances, the space of 0.5mm or more should be kept under the PCB and the design have to be checked carefully (See fig. 2). Enough space should be kept
Summary of the content on the page No. 19
360014937 UNIT: mm MK6017MAP Dimensions Figure 1 Copyright © 2000 Toshiba corporation. All rights reserved. - 519 -
Summary of the content on the page No. 20
360014937 SFF-8200 Rev1.1(*) SFF-8201 Rev1.2 MK6017MAP SFF-8212 Rev1.2 (Differences only) Dimension Millimeters Inches Millimeters Inches A1 9.5 0.374 A2 0.20 0.008 A3 0.20 0.008 A4 69.85 2.750 A5 0.25 0.010 A6 101.85 max 4.010 max 100.00 ±0.41 3.973 ±0.016 A9 3.99 0.157 3.99 ±0.43 0.157 ±0.017 A10 10.14 0.399 10.14 ±0.51 0.399 ±0.020 A11 2.00 0.079 A12 2.00 0.079 A13 0.50 0.020 A14 0.05 0.002 A17 0.50 0.020 A18 0.05 0.002 A21 3.86 0.152
