Summary of the content on the page No. 1
L53L2/US GB 1995, 11, 1
INSTRUCTION MANUAL
VCC-3912
COLOR CCD Camera
Summary of the content on the page No. 2
L53L2/US GB 1995, 11, 1 SANYO INDUSTRIAL VIDEO COLOR VIDEO CAMERA LIMITED WARRANTY OBLIGATIONS In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Service Center at the user’s expense, unless specifically stated otherwise in this warranty. The names and addresses of Authorized Sanyo Service Centers may be obtained by writing to SFS Corporation, SFC’s warranty administrator, at any of the addresses listed below, or by calling (toll-free) 1-
Summary of the content on the page No. 3
L53L2/US GB 1995, 11, 1 ACCESSORIES CONTENTS 1 C mount adaptor (5 mm).................1 pc. ACCESSORIES....................................................1 The C mount adaptor must be used to be able to install a C mount lens on the INFORMATION TO USER ..................................2 camera. FEATURES..........................................................3 2 Lens iris plug (4-pin).........................1 pc. PRECAUTIONS...................................................4 3 AC adaptor ..
Summary of the content on the page No. 4
ENGLISH L53L2/US GB 1995, 11, 1 INFORMATION TO USER This equipment has been tested and Safety Guard found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. THIS SYMBOL INDICATES THAT These limits are designed to provide THERE ARE IMPORTANT reasonable protection against harmful OPERATING AND interference in a residential installation. MAINTENANCE INSTRUCTIONS This equipment generates, uses, and IN THE LITERATURE can radiate radio frequency energy and, A
Summary of the content on the page No. 5
L53L2/US GB 1995, 11, 1 FEATURES Electronic iris function Terminology explanation The electronic iris function regulates the About the DC type lenses electronic shutter speed. To the contrary of These lenses use a DC power supply electronic shutters with a fixed speed, the without amplifier circuits. They are also electronic iris modifies the shutter speed referred to as non internal amplifier type according to the CCD input. The electronic lens or coil type lens. iris will automatically control
Summary of the content on the page No. 6
L53L2/US GB 1995, 11, 1 PRECAUTIONS In case of problem Do not install close to stoves, or other heat generating devices, such as spotlights, etc., Do not use the camera if smoke or a or where it could be subject to direct strange odor comes from the unit, or if it sunlight, as that could cause deformation, seems not to function correctly. Disconnect discoloration or other damages. the power cord immediately, and consult your dealer (or a Sanyo Authorized Service Be careful when installing close
Summary of the content on the page No. 7
L53L2/US GB 1995, 11, 1 PREPARATION 2 3 2 1 1 2 A B Camera installation A: Lens mount cap Remove the lens mount cap before installing the lens (sold separately). Use with this camera a CS mount type auto-iris lens (for 1/3 inch). Auto-iris lenses regulate the amount of light entering the camera according to R1 R2 the brightness of the subject. C mount auto-iris lenses can also be used CAUTION: with the supplied adaptor (see page 7). When installing the camera support, B: Installation brack
Summary of the content on the page No. 8
L53L2/US GB 1995, 11, 1 1 (A) L 4 DC 3 VIDEO 2 Installation of a DC type lens (sold separately) LENS connector layout (A) 1/3 inch CS mount type 1:Brake coil (–) 2:Brake coil (+) (Flange-back: 12.5 mm) 3:Drive coil (+) 4:Drive coil (–) 1 Remove the lens mount cap. 2 1 2 1 2 Install the auto-iris lens onto the camera. Sanyo auto-iris lenses (sold separately) 4 3 4 3 VCL-CS8LY: Standard angle, f= 8 mm VCL-CS4LY: Wide angle, f= 4 mm 4 Set the A.I. LENS switch to the DC VCL-CS2LY: Ultra-wide a
Summary of the content on the page No. 9
L53L2/US GB 1995, 11, 1 PREPARATION 1 DC VIDEO 2 L 4 5 3 Installation of a VIDEO type lens (sold separately) LENS connector layout 1/2 or 2/3 inch C mount type 1:+12 V DC (50 mA max.) (Flange-back: 17.526 mm) 2:Not used 1 Remove the lens mount cap. 3:Video output (1.0 Vp-p, high impedance) 4:Ground (for video signal and DC power) 2 Attach the supplied C mount adaptor to the auto-iris lens. 2 1 2 1 3 Install the auto-iris lens onto the camera. CAUTION: Do not use a lens if the length “L” is 4 3 4
Summary of the content on the page No. 10
L53L2/US GB 1995, 11, 1 CONNECTIONS 1 4 (A) 2 (Video signal connections) : VIDEO IN : VIDEO OUT Basic connection for monitoring or recording The peripheral devices (VCR, monitor, Coaxial cable type and maximum etc.) and cables are sold separately. length Cable type RG-59U, 100 m maximum. 1 Make the video signal connection Cable type RG-39U, 200 m maximum. between the camera and the monitor or CAUTION: time lapse VCR. The RG-59U type cable should not be 2 Connect DC connecting c
Summary of the content on the page No. 11
L53L2/US GB 1995, 11, 1 CONNECTIONS A B (Video signal connections) : VIDEO IN : VIDEO OUT : CAMERA IN Multiple camera connections The following two connections can be used when using 4 monitoring cameras. The power connection is as described on page 8, and should be realized for each camera. The peripheral devices (VCR, monitor, multi-video processor, camera switcher, etc.) and cables are sold separately. A) Connection using a multi-video processor. To use one monitor divid
Summary of the content on the page No. 12
L53L2/US GB 1995, 11, 1 SETTINGS F: High speed D: Electronic iris (See page 11) The switches setting illustrated electronic shutter E: Backlight compensation are the factory default settings. setting (See page 12) (See page 11) B: Lens Iris L VR401 E E A ON S V EI E ON L OFF 12 3 4 LH ON DC W OFF F RB B VIDEO ON L M BLC A. I. LENS VR403 VR402 C: White balance (See page 11) A:Flange-back adjustment B: Lens iris adjustment If the pick-up surface is not correctly
Summary of the content on the page No. 13
L53L2/US GB 1995, 11, 1 SETTINGS If used under fluorescent light, the C: White balance adjustment image may flicker. In such a case, change to incandescent lighting or set Normally the WB (white balance) switch is the EI/BLC switch to the OFF position set to the A (automatic) position and the and use an auto-iris lens. white balance is adjusted automatically. If a manual white balance adjustment is When shooting bright subjects, pay attention to the light angle in order to necessary, follow
Summary of the content on the page No. 14
L53L2/US GB 1995, 11, 1 If using a VIDEO type auto-iris lens Table B The ALC volume on the lens should be Electronic Shutter Switch position turned all the way to Av (Average). Speed If the backlight compensation function 1/60 sec. ON does not compensate properly for the (OFF/OFF/OFF/OFF) conditions, set using the LEVEL volume on the lens. 1/100 sec. ON (ON/OFF/OFF/OFF) CAUTION: The electronic iris function and the 1/250 sec. ON backlight compensation function cannot (OFF/OFF/ON/OFF) operate
Summary of the content on the page No. 15
L53L2/US GB 1995, 11, 1 TROUBLESHOOTING Before taking the camera for repairs, please check below to make sure that the camera is used correctly. If it still does not perform correctly, please consult your dealer or a Sanyo Authorized Service Center. No picture on the monitor screen Is the power turned on to all connected devices? Is the voltage correct? Are all the signal connecting cables correctly connected? Is the lighting sufficient? Has the lens cap been removed? Is the lens type
Summary of the content on the page No. 16
L53L2/US GB 1995, 11, 1 SPECIFICATIONS Camera Color system : NTSC color TV system (525 TV lines, 60 fields/sec.) Interlace : PLL 2:1 interlace Image device : 1/3 inch interline transfer CCD Picture elements : 537 (H) x 505 (V) Effective picture elements : 510 (H) x 492 (V) Synchronizing system : Internal sync Resolution : 330 TV lines horizontally, 350 TV lines vertically Video output level : 1.0 Vp-p/75 ohms, composite Video S/N ratio : More than 46 dB Minimum required illumination (incandesce
