Summary of the content on the page No. 1
Instruction Manual
For the digital camera
CAMEDIA C-5050ZOOM
Waterproof Case
PT-015
Thank you for buying the Waterproof Case PT-015.
Please read this instruction manual carefully and use the product safely and
correctly.
Please keep this instruction manual for reference after reading it.
Wrong use may cause damage to the camera on the inside from water
leakage, and repair may not be possible.
Before use, perform an advance check as described in this manual.
Summary of the content on the page No. 2
Introduction Unauthorized copying of this manual in part or in full, except for private use, is prohibited. Unauthorized reproduction is strictly prohibited. Our company shall not be responsible in any way for lost profits or any claims by third parties in case of any damage occurring from unsuitable use of this product. Our company shall not be responsible for damage, lost profits, etc. caused by loss of image data because of defects, disassembly, repair or modification of this product b
Summary of the content on the page No. 3
WARNING 1. Keep this product out of the reach of babies, infants, and children. There is the possibility of occurrence of the following types of accidents. • Injury by dropping onto the body from a height. • Injury from parts of the body getting caught in parts which open and close. • Swallowing of small parts. Please consult a physician immediately if any parts have been swallowed. • Triggering of the flash in front of the eyes may cause permanent vision impairment etc. 2. Do not store with a b
Summary of the content on the page No. 4
6. When using this product, install the O-ring for the front lid and the O-ring for the rear lid. 7. If the camera on the inside should become wet because of water leakage etc., immediately wipe off all moisture and confirm the operation. 8. Please remove the O-ring when traveling by air. Otherwise air pressure may make it impossible to open the Case. 9. For safe use of the digital camera in this product, please read the "Instruction Manual" for the digital camera carefully. 10. When sealing thi
Summary of the content on the page No. 5
For Prevention of Water Leakage Accidents When water leakage occurs while this product is being used, repair of the camera housed in this product may become impossible. Please observe the following cautions for use. 1. When sealing this product, make sure that no hairs, fibers, sand particles or other foreign matter stick not only to the O-ring, but also to the contact surface (flat part of the front cover). Even a single hair or a single grain of sand may cause water leakage. Please check with
Summary of the content on the page No. 6
8. When the O-ring contact surface is pressed strongly from the outside of the Case, or when the Case is twisted, the waterproof function may be lost. Take care not to exert excessive force. 9. Please use the Case after performing the advance test and the final check. 10. If you should notice drops of water or other signs of water leakage while taking pictures, immediately stop the dive, remove any water from the camera and the product, test according to the item "Final check", and confirm wheth
Summary of the content on the page No. 7
Do not use the following chemicals for cleaning, corrosion prevention, prevention of fogging, repair or other purposes. When these are used for the Case directly or indirectly (with the chemicals in vaporized state), they may cause cracking under high pressure or other problems. Chemicals which cannot be used Explanation Do not clean the Case with alcohol, gasoline, thinner Volatile organic solvents, or other volatile organic solvents or with chemical chemical detergents detergents etc. Pure w
Summary of the content on the page No. 8
Contents Introduction E-1 Please read the following items before use E-1 For safe use E-1 Batteries E-3 For Prevention of Water Leakage Accidents E-4 Handling the Product E-5 E-22 Contents E- E-7 7- -8 8 1.Preparations E- E-9 9 Check the contents of the package. E-9 Names of the parts E-10 Install the strap. E-11 E-23 Master the basic operation. E-11 Holding the Case E-11 How to Press the Shutter E-12 How to Use the Mode Dial E-12 How to Use the Zoom Lever E-13 Setting the Zoom Lever E-13 E-
Summary of the content on the page No. 9
Perform the final checks. E-20 Visual Inspection E-20 Try to move the mode dial E-20 Final Test E-21 4. Taking Pictures Under Water E- E-22 22 How to Use the Hand Strap E-22 Take pictures carefully. E-22 Confirm the picture on the LCD monitor E-22 Quietly press the shutter lever. E-22 Cautions when using the flash E-22 5. Handling After Shooting E- E-23 23 Wipe off any waterdrop. E-23 Take out the digital camera. E-24 Wash the Case with pure water. E-25 Dry the Case. E-25 6. Maintaining th
Summary of the content on the page No. 10
1. Preparations Check the contents of the package. Check that all accessories are in the box. Contact your dealer if accessories should be missing or damaged. Grease for 5 Silica gel LCD hood silicon O-ring packs (on the body) Case body LCD hood strap Hand strap Balance weight (Check that the O-ring is normal.) Pick for O-ring removal Instruction manual (this manual) Warranty card Please read before use Instruction Manual For the digital camera LIMITED WARRANTY CAMEDIA C-5050ZOOM This limited w
Summary of the content on the page No. 11
Names of the parts ❈ Palm grip Mode dial knob LCD hood Buckle stopper ❈ Power switch lever ❈ AEL/Erase button Buckle lock lever ❈ Dial knob ❈ LCD monitor button Buckle hook ❈ Custom/Print reservation button ❈ OK/Menu button O-ring ❈ Self-timer/Remote control/Rotation ❈ Arrow pad ❈ Diffuser and diffuser cover playback button Card switching button ❈ Hand strap ring Exposure meter/Protect button Rear lid ❈ Hand strap AF/Macro/MF button LCD hood strap ❈ Tripod seat Flash mode button Grease for silic
Summary of the content on the page No. 12
Install the strap. Install the strap on the Case body. Installation explanation Finished installation Hand strap ring Hand strap CAUTION : Please install the strap correctly as shown above. Our company shall bear no responsibility for damage etc. caused by dropping the Case because of incorrect installation of the strap. Master the basic operation. Please master the basic operation of the Case before taking pictures. Holding the Case Hold the Case securely with both hands, keep your elbows clos
Summary of the content on the page No. 13
How to Press the Shutter When pressing the shutter lever, press it gently, so that there will be no movement of the camera. Note: • When the shutter lever is operated with the index finger and the zoom lever with the middle finger, there is no need to change fingers. • When pressing the shutter lever, place the zoom lever at the neutral position. The shutter will not operate when the zoom lever is on the telephoto side or the wide-angle side. • For detailed operation of the shutter, refer to the
Summary of the content on the page No. 14
How to Use the Zoom Lever Zoom operation is possible by operating the zoom lever of this Case corresponding to the zoom lever of the digital camera in the Case. Setting the Zoom Lever When loading the digital camera in the Case, fit the projecting part of the zoom lever of the digital camera into the recessed part of the zoom lever on the inside of the Case. : • When loading the camera, confirm that the projecting part of CAUTION the zoom lever of the camera is properly set to the recessed part
Summary of the content on the page No. 15
2. Advance Check of the Case Advance test before use This Case has been the subject of thorough quality control for the parts during the manufacturing process and thorough function inspections during the assembly. In addition, a water pressure test is performed with a water pressure tester for all products to confirm that the performance conforms to the specifications. However, depending on the carrying and storage conditions, the maintenance status, etc., the waterproof function may be damaged.
Summary of the content on the page No. 16
3. Install the digital camera. Check the digital camera. Check the digital camera before loading it in the Case. Battery Confirmation As the LCD monitor is used for picture confirmation while taking pictures under water, the battery life becomes short. Confirm that the remaining battery capacity is sufficient. Do not use alkaline batteries, as it is quite possible that they will become unusable during a dive. Note: • In order to avoid losing shutter chances due to an exhausted battery, you shoul
Summary of the content on the page No. 17
Open the case Raise the buckle stopper (towards the shutter lever). With the buckle stopper raised, open the buckle opening lever. (When the buckle opening lever is operated with the stopper lowered, the stopper/buckle opening lever is damaged. Please handle with care.) Unhook the buckle hook and open the rear lid of the protector. Pull up the mode dial of the protector. Pull up the mode dial of the protector and hold it, so that it does not interfere with the mode dial of the digital camera.
Summary of the content on the page No. 18
Load the digital camera. Quietly load the digital camera into the Case, taking care that the projecting part of the zoom lever of the digital camera properly fits into the recessed part of the zoom lever of the Case.(Page 13) : • Confirm that the projecting part of the zoom lever of the CAUTION digital camera is set securely to the zoom lever notch on the inside of the protector. When the setting is not secure, the loading of the digital camera is not complete and closing of the rear lid of the
Summary of the content on the page No. 19
Insertion of silica gel Before sealing the Case, insert the accessory silica gel bag for prevention of fogging between the bottom of the camera and the Case. Insert the bag with the glued longer side to the inside. : • Insert the silica gel all the way at the specified location and CAUTION with the specified orientation. When the orientation is not correct, the silica gel bag will be caught when the Case is sealed and water leakage will be caused. • When it is tried to seal the Case with the bag
Summary of the content on the page No. 20
Check the loading status. Always perform the following final checks before sealing the Case. • Has the digital camera been loaded so that the zoom lever operates properly? • Has the silica gel been inserted all the way at the specified position? • Has the O-ring at the Case opening part been installed properly? • Are the O-ring and the O-ring contact surface on the front lid free of dirt and other foreign matter? Seal the Case. When the rear lid is closed (quietly, so that the O-ring will not co
