Summary of the content on the page No. 1
Crestron SRD-AMP-1
High-Gain Line Amplifier
Installation Guide
Summary of the content on the page No. 2
This document was prepared and written by the Technical Documentation department at: Crestron Electronics, Inc. 15 Volvo Drive Rockleigh, NJ 07647 1-888-CRESTRON All brand names, product names and trademarks are the property of their respective owners. ©2008 Crestron Electronics, Inc.
Summary of the content on the page No. 3
Crestron SRD-AMP-1 High Gain Line Amplifier Contents High Gain Line Amplifier: SRD-AMP-1 1 Introduction................................................................................................................................1 Block Diagrams ...........................................................................................................2 Specifications...............................................................................................................3 Included
Summary of the content on the page No. 4
Summary of the content on the page No. 5
Crestron SRD-AMP-1 High Gain Line Amplifier High Gain Line Amplifier: SRD-AMP-1 Introduction The SRD-AMP-1 is an inline amplifier intended for use in overcoming ® ® cable and splitter losses in a Crestron XM or SIRIUS satellite radio distribution network. It is rated to provide 16 dB (typical) of gain in the satellite radio band (2320-2345 MHz), and is powered from the DC bias voltage (4.5 VDC to 6.5 VDC nominal) provided by the antenna connection on the satellite radio tuner downstream
Summary of the content on the page No. 6
High Gain Line Amplifier Crestron SRD-AMP-1 Block Diagrams The following diagrams illustrate three typical installation configurations using the SRD-AMP-1 line amplifier. Single SRD-AMP-1 Installation Double SRD-AMP-1 Installation Triple SRD-AMP-1 Installation 2 • High Gain Line Amplifier: SRD-AMP-1 Installation Guide – DOC. 6720A
Summary of the content on the page No. 7
Crestron SRD-AMP-1 High Gain Line Amplifier Specifications Following are specifications for the SRD-AMP-1. SRD-AMP-1 Specifications SPECIFICATION DETAILS Gain 16 dB (Typical @ 4.5 VDC) Current consumption 10 milliamps @ 4.5 VDC Power passing Both directions Environmental temperature -40° to 150°F (-40° to 66°C) Humidity 0% to 98% RH (non-condensing) Overall dimensions: Height 0.64 in (1.63 cm) Width 3.25 in (8.26 cm) Depth 1.07 in (2.72 cm) Included Items The items includ
Summary of the content on the page No. 8
High Gain Line Amplifier Crestron SRD-AMP-1 Industry Compliance As of the date of manufacture, the SRD-AMP-1 has been tested and found to comply with specifications for CE marking and standards per EMC and Radiocommunications Compliance Labelling. Installation Refer to the illustrations on page 2, and, using the screws provided, orient and mount the amplifier(s) appropriately according to the distance between the antenna and the radio. Prepare and connect appropriate RG-6 and/or
Summary of the content on the page No. 9
Crestron SRD-AMP-1 High Gain Line Amplifier Problem Solving Troubleshooting The table after this paragraph provides corrective action for possible trouble situations. If further assistance is required, please contact a Crestron customer service representative. SRD-AMP-1 Installation Troubleshooting TROUBLE POSSIBLE CORRECTIVE ACTION CAUSES No signal Short circuits With radio on and all reception. Radio or antenna cables display shows: discontinuities connected at the radio, “Antenna
Summary of the content on the page No. 10
High Gain Line Amplifier Crestron SRD-AMP-1 SRD-AMP-1 Installation Troubleshooting (Continued) TROUBLE POSSIBLE CORRECTIVE ACTION CAUSES Limited Problem with Ensure that the tuner card reception or tuner card. is registered/activated. channels available for XM and/or SIRIUS tuners. Further Inquiries If you cannot locate specific information or have questions after reviewing this guide, please take advantage of Crestron's award winning customer service team by calling Crestron at 1-8
Summary of the content on the page No. 11
Crestron SRD-AMP-1 High Gain Line Amplifier Return and Warranty Policies Merchandise Returns / Repair Service 1. No merchandise may be returned for credit, exchange or service without prior authorization from CRESTRON. To obtain warranty service for CRESTRON products, contact an authorized CRESTRON dealer. Only authorized CRESTRON dealers may contact the factory and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying the nature of the problem, name and phon
Summary of the content on the page No. 12
Crestron Electronics, Inc. Installation Guide – DOC. 6720A 15 Volvo Drive Rockleigh, NJ 07647 (2021527) Tel: 888.CRESTRON 08.08 Fax: 201.767.7576 Specifications subject to www.crestron.com change without notice.
