ProMaster 300C user manual

Summary of the content on the page No. 1

300C Studio Flash



OWNER’S MANUAL

Summary of the content on the page No. 2

Specifications: Safety Precautions 1. Before using the flash, make sure that your lighting Power Supply: AC100 130volt 50/60Hz equipment is plugged into a 110 volt AC power source. Do Strobe output: 300WS not use any power supply other than the AC specification Guide No. (ISO100): 54m indicated on your equipment. Cooling Fan: Built-in Mini Fan Cooler 2. Do not expose the equipment to sunlight, moisture, dust, Power Setting: 1/32 to 1/1 continuously dirt, rain or water.

Summary of the content on the page No. 3

(1) AC Power Supply Socket Light Body & Rear Control Panel (2) Safety Fuse (3) Synch Cord Socket (4) General power supply on/off switch (5) Modeling Lamp on/off switch (6) Power setting for modeling lamp on/off switch (7) Recharge Ready-Light (8) Slave Sensor (9) Handle Grip (10) Audio signal for recharge ready on/off switch (11) Lock/Release Bolt for reflector & softbox connector (12) Test button (13) Output Power Setting for flash/ modeling lamp (14) Hand Wheel for ang

Summary of the content on the page No. 4

4. Synch Cord 9. Replacing flash tube Link the studio flash to your camera with a synch cord to Wear gloves whenever removing the flash or modeling lamp. trigger the light. You may also use the built-in slave sensor to When replacing the flash tube, first remove the modeling lamp, trigger your flash. then insert the flash tube. DO NOT TOUCH the anode OR 5. Audio Signal cathode of the flash tube. Setting the audio signal button (10) to the ON (I) position will activate an audio signal to