PYLE Audio PYLE PRO PMX602M user manual

Summary of the content on the page No. 1

Owner’s Manual


PMX402M 4 CHANNELS
PMX602M 6 CHANNELS
PMX802M 8 CHANNELS
www.pyleaudio.com

Summary of the content on the page No. 2

FEATURES Balanced microphone inputs, high impedance microphone/line Inputs and Tape/CD inputs. All may be used simultaneously reverb built in with individual control on each channel line out for connection to external amplifiers record out jack for taping performances R.F interference protection on all inputs and outputs. The family of products built-in high-quality, high-effect of MP3 players can play in the USB disk MP3 format songs. Blue backlit LCD display screen can display

Summary of the content on the page No. 3

A. FRONT PANEL SECTION FEATURES 1. BALANCE INPUT (MIC) Electronic Balanced inputs acceptable a standard XLR male connector. It is designed to accept a balanced low impedance input signal, Phantom power (15 volts) for condenser microphones is always on and available. It has an input impedance of 1K ohm. The connector is wired as: Pin= shield ; Pin3= negative(cold). 2. BALANCE INPUT(LINE) Electronic Balanced inputs acceptable a standard 1/4 ＂ jacks connector. It is designed to ac

Summary of the content on the page No. 4

7. GRAPHIC EQUALIZER 2 ×5-band equalizer is provided for tone control over each frequency , and for precise high quality sound by final tone control. It can control main channel and record channel.( 60,250,1K,2K,8KHz ) shelving at +/-12dB. 8. LCD DISPLAY(There are three states show) a. Machine became the first LCD display screen information are the trademarks of products, USB version, and initial system. b. The second message is to remind the screen insert USB disk, or disk is no

Summary of the content on the page No. 5

d. Up This is a multi-function control, In the state of play, press the button, Will play the next song; Press the button for a long time, can adjust the LCD backlight brightness. e. EQ This is a conventional keys, press the first choice of a EQ, a total of 11 EQ, are Natural, Rock, Pop, Class, Jazz, Blue, Hall, Bass, Soft, Country, and Opera. 10.POWER LED It lights when power switch turn on. 11. PHANTOM LED The LED +15V will be turned on when start working. 12. PHANTOM POWER SW

Summary of the content on the page No. 6

B. BACK PANEL SECTION FEATURES 1. SPEAKER JACK (LEFT/RIGHT) These are 2 conductor 1/4” speaker outputs. Each one is rated at 8 ohm minimum impedance. Total minimum load for the amplifier is 4 ohms. You may connect either 1-4 ohm. 1-8 ohm or 2-8 ohm speaker cabinets. Do not below rated minimum impedance. 2. SEND/RETURN Using by this jack, you can use stereo 1/4 ＂jacks connector send internal signal which before power amplifier to external effects processing, after processing ret

Summary of the content on the page No. 7

7. CHANGE-OVER SWITCH This device is used to 110V/220V or 115V/230V voltage conversion. 8. AC POWER CORD/FUSE HOLDERS AC 220 ～240V 60Hz or 110-120V 60Hz ,Check the power voltage of supply with silk-screen of the panel before connections. When occur a problem on this appliance, the fuse will be cut off, power to prevent form a problem. C. CONNECTIONS You will need a lot of cables for different purposes – see the following figures to make sure you have got the right ones. Unbalanced

Summary of the content on the page No. 8

Bandwidth 20Hz to 20kHz_+ 1dB Input Impedance: Lo-Z Mic 1K ohms Hi-Z Mic/Line 33K ohms Tape playback 10K ohms Input level: Lo-Z Mic -50dB Hi-Z Mic/Line -20dB Tape playback -10dB Rec output level +22dB(max) MODEL NO PMX402M PMX602M PMX802M CHANNELS 4CHANNE