Summary of the content on the page No. 1
™
Ceiling DocCam II User Manual
ClearOne Communications, Inc. ~ 1825 Research Way, Salt Lake City, UT 84119 ~ tel 1-800-945-7730 ~ fax 1-800-933-5107
Summary of the content on the page No. 2
1 ii Ceiling DocCam II — Table of Contents Ceiling DocCam II — Introduction Table of Contents Introduction Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 The Ceiling DocCam™ II is a ceiling-mounted document camera that displays images on monitors, plasma screens, video projectors and videoconferencing systems. It is ideal for Services and support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 3
3 2 Ceiling DocCam II — Introduction Ceiling DocCam II — Introduction Unpacking Important safeguards Ensure that you received the following parts: • Read and understand all instructions before using. • Do not operate the Ceiling DocCam II if the power cord is damaged or if the Ceiling DocCam II has been dropped or damaged. A qualified service technician must examine the Ceiling DocCam II before operating. • Do not attempt to take the Ceiling DocCam II apart.There are no user-serviceable compone
Summary of the content on the page No. 4
5 4 Ceiling DocCam II — Introduction Ceiling DocCam II — Introduction Front and back wall plate connections Product overview Camera enclosure E B 15 VDC C B Composite C Video F S-video D A RS-232 E A Figure 3. Front and back wall plate A. RJ-45 Connector. The RJ-45 jack connects to the RJ-45 connector on the camera enclosure using a Cat. 5 cable. G B. 15 VDC.The 15 VDC power supply jack. D Figure 2. Front and back of camera enclosure and trim ring C. Composite. This output jack allows the Ceil
Summary of the content on the page No. 5
7 6 Ceiling DocCam II — Introduction Ceiling DocCam II — Installation Remote Installation M Before you install FLIP PWR The following equipment is needed for proper installation: A L DISPLAY B K • String or plumb bob FREEZE AUTO ZOOM FOCUS IN • Utility knife C CAM LASER • Flathead screwdriver D ZOOM J OUT Be sure to check above the ceiling tile where you plan to install the camera to make sure the area is clear and that there is enough room for the Ceiling DocCam II and all of its PRESETS comp
Summary of the content on the page No. 6
9 8 Ceiling DocCam II — Installation Ceiling DocCam II — Installation To mount the camera Connecting cables 1. Attach a string or plumb bob to A single RJ-45 cable connects to the back of the wall plate providing S-video, composite the ceiling tile with a thumb video, power and RS-232 control.The front of the wall plate provides the break-out tack. connections for S-video, composite video, power and RS-232 control.The wall plate may be attached to a standard single gang wall box or placed in an
Summary of the content on the page No. 7
11 10 Ceiling DocCam II — Installation Ceiling DocCam II — Installation Programming presets Configuring for remote controls Presets are used to program defined positions of the camera into a simple, one button preset. The Ceiling DocCam II can be programmed to work with the remotes listed below. DIP You can switch easily from a zoomed in position on a small document to a zoomed out switches on the camera enclosure must be configured in order to work with these remotes. position for documents
Summary of the content on the page No. 8
13 12 Ceiling DocCam II — Operation Ceiling DocCam II — Operation Viewing areas Operation Viewing area depends on the distance between the ceiling and the table. Use the following Using your codec remote tables to determine the maximum and minimum viewing areas of the Ceiling DocCam II for distances of 5.5', 6.5' and 7.5'. (Most tables are about 2.5' and ceiling heights vary between The only function you can control on the Ceiling DocCam II from your codec remote is the 8', 9' and 10'). If the
Summary of the content on the page No. 9
15 14 Ceiling DocCam II — Troubleshooting Ceiling DocCam II — Appendix Appendix Troubleshooting Specifications Problem Try this Dimensions (Height x Diameter) Verify that the Cat. 5 is connected between the RJ-45 jack on the back of Lens (Horizontal Angle) Enclosure: 4.5" x 6.5" (11.43 x 16.51 cm) the camera module enclosure and the RJ-45 jack on the back of the wall 45 degrees (wide end) to 1 plate. Ceiling cutout: 3 /2" (8.9 cm) diameter 2.0 degrees (telescopic end) Trim ring: 5.5" (14 cm) di
Summary of the content on the page No. 10
17 16 Ceiling DocCam II — Appendix Ceiling DocCam II —Appendix Warranty NO OTHER WARRANTY, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MER- ClearOne Communications, Inc. (Manufacturer) warrants that this product is free of defects in both CHANTABILITY OR FITNESS FOR ANY PARTICULAR USE, APPLIES TO THE PRODUCT. materials and workmanship. Should any part of this product be defective, the Manufacturer agrees, MANUFACTURER’S MAXIMUM LIABILITY HEREUNDER SHALL BE THE AMOUNT PAID at its option, to: BY T
Summary of the content on the page No. 11
19 18 Ceiling DocCam II — Appendix Ceiling DocCam II — Appendix 89/336/EEC "Electromagnetic Compatibility (EMC) Directive": FCC Part 15/ICES-003 Compliance EN 55022: 1994 (Emissions) Specification for limits and methods of measure This equipment has been tested and found to comply with the limits for a Class A digital device, ment of radio interference characteristics of pursuant to Part 15 of the FCC rules and Industry Canada ICES-003.These limits are designed to information technology equipm
Summary of the content on the page No. 12
21 20 Ceiling DocCam II — Appendix Ceiling DocCam II — Appendix • Error message RS-232 control information When a command or inquiry command could not be executed or failed, an error message is Note: For best performance of the VISCA commands, set DIP switches to the ClearOne returned instead of the completion message. configuration when the camera is connected to the control port of a codec. 90 61 01 FF Message length error (>14 bytes) Overview of VISCA 90 61 02 FF Syntax Error 90 61 03 FF Co
Summary of the content on the page No. 13
23 22 Ceiling DocCam II — Appendix Ceiling DocCam II — Appendix VISCA Camera-Issued Messages Command List ACK/Completion Messages Command Set Command Command Packet Comments Camera Power On 81 01 08 01 01 FF Power on Off 81 01 08 01 00 FF Power off Command Messages Comments Laser Power On 81 01 08 02 01 FF Power on ACK z0 4y FF Returned when the command is accepted. Off 81 01 08 02 00 FF Power off (y:Socket No.) Momentary 81 01 08 02 02 XX FF XX=time on from Completion z0 5y FF Returned when th
Summary of the content on the page No. 14
25 24 Ceiling DocCam II — Appendix Ceiling DocCam II — Appendix Command Packet Command Set Command Comments Command Set Command Command Packet Comments Reset 81 01 04 0C 00 FF Gain Setting CAM _AF Mode Normal AF 81 01 04 57 00 FF AF Movement Mode CAM_ Gain 81 01 04 57 01 FF Up 81 01 04 0C 02 FF Interval AF Down 81 01 04 0C 03 FF Zoom Trigger AF 81 01 04 57 02 FF Direct 81 01 04 4C 00 00 0p 0q FF pq: Gain Position Active/Interval Time 81 01 04 27 0p 0q 0r 0s FF pq: Movement Time rs: Interval
Summary of the content on the page No. 15
27 26 Ceiling DocCam II — Appendix Ceiling DocCam II — Appendix Command Set Command Command Packet Comments Command Set Command Command Packet Comments CAM_PrivacyZone SetMask 81 01 04 76 mm nn mm: Mask Settings CAM_Stablizer On 81 01 04 34 02 FF Vibration Correction 0p 0p 0q oq 0r 0r 0s 0s FF nn 00: Modify, 01: New On/Off pp: X, qq: Y, rr: W, ss: H Off 81 01 04 34 03 FF Display 81 01 04 77 pp pp pp pp FF Mask Display On/Off CAM_Memory Reset 81 01 04 3F 00 0p FF p: Memory Number pp pp pp pp : M
Summary of the content on the page No. 16
29 28 Ceiling DocCam II — Appendix Ceiling DocCam II — Appendix Inquiry Command Inquiry Command Command Packet Inquiry Packet Comments CAM_SpotAE PosInq 81 09 04 29 FF 90 50 0p 0q 0r 0s FF pq: X position Inquiry Command Command Packet Inquiry Packet Comments rs: Y position Camera Power 81 09 08 01 FF 90 50 00 FF Off CAM_ApertureInq 81 09 04 42 FF 90 50 00 00 0p 0q FF pq: Aperture Gain On 90 50 01 FF 81 09 04 61 FF CAM_LR_Reverse 90 50 02 FF On ModeInq Laser Power 81 09 08 02 FF 90 50 00 FF Off 9
Summary of the content on the page No. 17
31 30 Ceiling DocCam II — Appendix Ceiling DocCam II — Appendix Block Inquiry Command List Lens Control System Inquiry Commands ... Command Packet 8x 09 7E 7E 00 FF Byte Bit Comments Byte Bit Comments Byte Bit Comments Byte Bit Comments 0 7 7 0 7 0 7 0 6 6 Destination Address 0 6 0 6 0 5 5 0 5 0 5 4 4 0 0 4 0 4 0 4 8 12 3 3 3 3 0 2 2 Source Address Zoom Position (LH) 2 2 0 Focus Position (HH) 1 1 1 1 0 0 0 0 0 0 0 Completion Message (50h) 7 7 0 7 0 7 0 6 6 0 1 0 6 6 0 5 5 0 0 5 0 5 DZoomMode 1:
Summary of the content on the page No. 18
33 32 Ceiling DocCam II — Appendix Ceiling DocCam II — Appendix Camera Control System Inquiry Commands ... Command Packet 8x 09 7E 7E 01 FF Byte Bit Comments Byte Bit Comments Byte Bit Comments Byte Bit Comments 7 7 0 7 0 7 0 0 6 6 Destination Address 0 6 0 6 0 5 5 0 5 0 5 0 4 4 0 4 0 4 0 4 8 12 3 3 3 3 0 2 2 Source Address B Gain (H) 2 2 0 Focus Position (HH) 1 1 1 1 0 0 0 0 0 0 0 Completion Message (50h) 7 7 0 7 0 7 0 6 6 0 1 6 0 6 0 5 5 0 0 0 5 5 DZoomMode 1: Separate 0:Combine 0: 0: 1: 1 4
Summary of the content on the page No. 19
35 34 Ceiling DocCam II — Appendix Ceiling DocCam II — Appendix Other Inquiry Commands ... Command Packet 8x 09 7E 7E 02 FF Byte Bit Comments Byte Bit Comments Byte Bit Comments Byte Bit Comments 0 7 7 0 0 7 7 6 6 0 6 0 6 0 Destination Address 0 5 5 0 0 5 5 4 4 0 0 4 4 4 0 8 12 3 3 3 3 2 2 Source Address 2 2 B Gain (H) Exposure Mode Gain Position 1 1 1 1 0 0 0 0 0 Completion Message (50h) 0 7 7 0 7 7 0 6 6 0 1 0 6 6 0 5 5 0 0 5 5 0 0 1 4 5 4 0 1 0 9 4 13 4 3 3 3 3 0 Spot AE 1: On 0: Off 2 2 0 2
Summary of the content on the page No. 20
37 36 Ceiling DocCam II — Appendix Ceiling DocCam II — Appendix Enlargement Function Query Command ... Command Packet 8x 09 7E 7E 03 FF Byte Bit Comments Byte Bit Comments Byte Bit Comments Byte Bit Comments 0 7 0 7 7 0 7 0 6 6 0 6 0 6 Destination Address 5 0 5 5 0 5 0 4 4 8 0 12 0 4 4 0 0 4 3 3 3 0 3 2 SpotAE Position (X) 2 0 2 2 Source Address AF Activation Time (H) 1 1 0 1 1 0 0 0 0 0 0 7 7 0 0 Completion Message (50h) 7 0 7 0 6 6 0 6 0 6 1 0 5 5 0 5 0 5 0 0 9 4 13 4 0 4 0 1 4 5 1 3 3 0 3 3 0
