Summary of the content on the page No. 1
1-BIT DIGITAL AUDIO SYSTEM
MODEL
SD-EX200
OPERATION MANUAL
SD-EX200_sec TINSZ0523AWZZ
Summary of the content on the page No. 2
SD-EX200 SPECIAL NOTES NOTE This equipment has been tested and found to comply with the limits for a Class B dig- ital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not in- stalled and used in accordance with the instructions, may cause harmful interference to radio communications. However, the
Summary of the content on the page No. 3
SD-EX200 IMPORTANT SAFETY INSTRUCTIONS 1 Read Instructions - All the safety and operating instructions should 10 Ventilation - Slots and openings in the cabinet are provided for venti- be read before the product is operated. lation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or cov- 2 Retain Instructions - The safety and operating instructions should be ered. The openings should never be blocked by placing the pro
Summary of the content on the page No. 4
SD-EX200 IMPORTANT SAFETY INSTRUCTIONS (continued) 15 Outdoor Antenna Grounding - If an outside antenna or cable system 19 Object and Liquid Entry - Never push objects of any kind into this is connected to the product, be sure the antenna or cable system is product through openings as they may touch dangerous voltage points grounded so as to provide some protection against voltage surges and or short-out parts that could result in a fire or electric shock. Never spill built-up static charges. Ar
Summary of the content on the page No. 5
SD-EX200 Notes Contents Page General Information ENERGY STAR® Program Information Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 As an ENERGY STAR® Partner, SHARP has determined that this product Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 meets the ENE
Summary of the content on the page No. 6
SD-EX200 Introduction Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. SD-EX200 1-Bit Digital Audio System consisting of SD-EX200 (main unit) and CP-EX200 (speaker system). Accessories Please confirm that the following accessories are included. Remote control 1 "AA" size battery (UM/SUM-3, R6, HP-7 or similar) 2 RRMCG0375AWSA UBATU0001AWZZ Speaker wire 2
Summary of the content on the page No. 7
SD-EX200 Precautions Hold the AC power plug by the head when removing it General from the AC outlet, as pulling the cord can damage in- Please ensure that the equipment is positioned in a well-ventilated area and en- ternal wires. sure that there is at least 4" (10 cm) of free space along the top and sides of the equipment. Do not remove the outer cover, as this may result 4" (10 cm) in electric shock. Refer internal service to your lo- cal SHARP service facility. 4" (10 cm) 4"
Summary of the content on the page No. 8
SD-EX200 Controls and indicators Front panel 1 2 3 Reference page 1. CD Cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16 2. Remote Sensor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11 3. Timer Set Indicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .23 4. Headphone Jack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25 5. CD Stop Button
Summary of the content on the page No. 9
SD-EX200 Side panel Left side Right side Reference page 1. FM 75 Ohms Antenna Jack . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12, 13 1 2. AM Antenna Ground Terminal . . . . . . . . . . . . . . . . . . . . . . . . . . 12, 13 3. AM Antenna Terminal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12, 13 2 4. Auxiliary Input Jacks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 5. Digital Output Jack . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 10
SD-EX200 Controls and indicators (continued) Remote control Reference page 1 1. Remote Control Transmitter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11 2. CD Play/Pause Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16 3. CD Stop Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16 11 4. Cursor/Tuner Preset Buttons . . . . . . . . . . . . . . . . . . . . . . . . . . .15, 21 5. CD Track Down or Fast
Summary of the content on the page No. 11
SD-EX200 Remote control Battery installation Test of the remote control Check the remote control after verifying all the connections (see pages 12 - 13). 1 Remove the battery cover. Point the remote control directly at the remote sensor on the unit. 2 Insert the supplied batteries according to the direction indicated in The remote control can be used within the range shown below: the battery compartment. Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy the When
Summary of the content on the page No. 12
SD-EX200 System connections Speaker connection AM loop antenna FM antenna Make sure to unplug the AC power cord before connecting the speaker wires. Connect the speaker wires to the speakers first, then to the unit. This prevents short circuit between and terminals. Connect the wire with the black line to the (-) and the transparent one to the (+). Right speaker Left speaker Right speaker Left speaker Bass Reflex Duct Transparent Black line Black line Transparent 3 1 2 Transparent
Summary of the content on the page No. 13
SD-EX200 Outdoor FM or AM antenna: Antenna connection Use an outdoor FM or AM antenna if you require better reception. Consult your Supplied FM antenna: dealer. Connect the FM antenna wire to the FM 75 OHMS Outdoor FM antenna Outdoor AM antenna jack and position the FM antenna wire in the direction where the strongest signal can be received. 49 feet (15 m) 75 ohm coaxial cable Supplied AM loop antenna: Connect the AM loop antenna wire to the AM and GND terminals. Position the AM loop
Summary of the content on the page No. 14
SD-EX200 General control Volume control Press the VOLUME (+ or -) button to increase or decrease the volume. ..... 0 1 2 39 40 Bass control 1Press the BASS/TREBLE button to select "BASS". 2Within 3 seconds, press the VOLUME (+ or -) button to adjust the bass. -5 +5 Treble control 1Press the BASS/TREBLE button to select "TREBLE". To turn the power on 2Within 3 seconds, press the VOLUME (+ or -) button to adjust the treble. Press the ON/STAND-BY button to turn the power on. If the
Summary of the content on the page No. 15
SD-EX200 Setting the clock By setting the unit to the correct time, you can use it not only as a clock but also for timer playback. 5 Press the CURSOR ( or ) but- ton to adjust the hour and then press the ENTER button. Press the CURSOR ( or ) button once to advance the time by 1 hour. Hold it down to advance continuously. When the 12-hour display is selected, "AM" will change automatically to "PM". 6 Press the CURSOR ( or ) but- ton to adjust the minutes and then press the ENTER button. Pr
Summary of the content on the page No. 16
SD-EX200 Listening to a CD This system can also play audio CD-R and CD-RW discs, but cannot record. Some audio CD-R and CD-RW discs may not be playable due to the state of disc or 1 Press the ON/STAND-BY button to turn the power on. the device that was used for recording. 2 Press the button. 3 Press the button to open the CD cover. 4 Place a CD on the spindle. Face the label side toward you. Place a CD on the spindle properly to avoid scratches. Click sound Label side up 5 Press the but
Summary of the content on the page No. 17
SD-EX200 Advanced CD Playback To remove the CD To locate the beginning of a track 1While in the stop mode, press the button. To move to the beginning of the next track: 2Press the CD eject button and remove the CD. 3Press the button to close the CD cover. Press the button during playback. You can skip to any track by pressing the button repeatedly until the desired track number appears. To restart the track being played: Press the button during playback. Push You c
Summary of the content on the page No. 18
SD-EX200 Advanced CD Playback (continued) Direct play Repeat or random play By using the direct buttons, the desired tracks can be played. You can select one of the CD playback mode; "Repeat play", "Random play" and "Normal play". Press the direct buttons to select the desired track. The direct buttons will allow you to select and play any track from 1 to 10 automati- 1 When in the CD mode, press the PLAY MODE button repeatedly to cally. select the playback mode. To select a track bet
Summary of the content on the page No. 19
SD-EX200 Adding tracks to the program: Programmed play If a program has been previously stored, the "MEMORY" indicator will be displayed. You can choose up to 20 selections for playback in the order you like. Then follow steps 1 - 5 to add tracks. The new tracks will be stored after the last track of the original program. 1 Press the button. To check which tracks are programmed: 2 Press the MEMORY button to enter the programming save mode. While the unit is stopped in the programmed play
Summary of the content on the page No. 20
SD-EX200 Listening to the radio Manual or Auto tuning 1 Press the ON/STAND-BY button to turn the power on. 2 Press the TUNER (BAND) button repeatedly to select the desired frequency band. FM stereo FM monaural AM 3 Press the TUNING ( or ) button to tune in to the desired station. You can tune in to the desired station by pressing the or button on the remote control. Manual tuning: Press the TUNING button as many times as required to tune in to the desired sta- tion. Auto tuning: When th
