ADC MM701G user manual

User manual for the device ADC MM701G

Device: ADC MM701G
Category: Switch
Manufacturer: ADC
Size: 3.93 MB
Added : 9/5/2014
Number of pages: 168
Print the manual

Download

How to use this site?

Our goal is to provide you with a quick access to the content of the user manual for ADC MM701G. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with ADC MM701G.

For your convenience

If looking through the ADC MM701G user manual directly on this website is not convenient for you, there are two possible solutions:

  • Full Screen Viewing - to easily view the user manual (without downloading it to your computer), you can use full-screen viewing mode. To start viewing the user manual ADC MM701G on full screen, use the button Fullscreen.
  • Downloading to your computer - You can also download the user manual ADC MM701G to your computer and keep it in your files. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
ADC MM701G User manual - Online PDF
Advertisement
« Page 1 of 168 »
Advertisement
Print version

Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual ADC MM701G but the selected pages only. paper.

Summaries

Below you will find previews of the content of the user manuals presented on the following pages to ADC MM701G. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.

Abstracts of contents
Summary of the content on the page No. 1

Megabit Modem MM701G and MM702G
User Manual
Version 2.1.12.x
Catalog Number
MM701G-UM-01

Summary of the content on the page No. 2

Copyright April 2003 © 2003 ADC DSL Systems, Inc. All Rights Reserved. Information contained in this document is company private to ADC DSL Systems, Inc., and shall not be modified, used, copied, reproduced or disclosed in whole or in part without the written consent of ADC DSL Systems, Inc. Trademark Information ADC is a registered trademark of ADC Telecommunications, Inc. Megabit Modem is a registered trademark of ADC DSL Systems, Inc. No right, license, or interest to such trademarks is g

Summary of the content on the page No. 3

About This User Manual ABOUT THIS USER MANUAL ® ® Use this manual to install, configure, and manage the ADC Megabit Modem MM701G and MM702G. These modems can be used in two types of applications: • as an endpoint (CPE) to a DSLAM for Internet and other broadband connection through a service provider  as a LAN extension by implementing a point-to-point connection with another modem of the same model (MM701G to MM701G or MM702G to MM702G) To complete an endpoint installation for an MM701G o

Summary of the content on the page No. 4

Document Conventions DOCUMENT CONVENTIONS Notes contain information about special circumstances. Cautions indicate the possibility of personal injury or equipment damage. The following convention is used to identify the sequence of Web pages and/or menus you navigate to access the feature configuration. The top grey bar indicates that the configuration parameter is System accessed from menu bar on the System Status page. For example, select System on the menu bar, then select Password from t

Summary of the content on the page No. 5

Table of Contents TABLE OF CONTENTS Chapter 1: Installing the Modem ...........................................................................................1 Unpack the Modem ............................................................................................................1 Determine What You Need ................................................................................................ 2 Attach Feet to the Modem .............................................................

Summary of the content on the page No. 6

Table of Contents Chapter 5: Configuring System Parameters .......................................................................39 Before You Begin. . . .........................................................................................................39 Assigning User Access ......................................................................................................40 Add a Default Gateway.......................................................................................

Summary of the content on the page No. 7

Table of Contents Chapter 9: Managing the Modem ........................................................................................81 View System Status...........................................................................................................82 View Modem Status............................................................................................82 View System Log................................................................................................84 View

Summary of the content on the page No. 8

Table of Contents Saving the Current Configuration....................................................................................131 Updating System Software ..............................................................................................132 Viewing System Information...........................................................................................133 Rebooting the Modem .................................................................................................

Summary of the content on the page No. 9

PWR LINK TX RX COL SYNC TX RX MAR INSTALLING THE MODEM 1 The MM701G and MM702G are versatile, high-speed modems that connect an Ethernet LAN to one or more service providers using G.shdsl transmission technology. The connections provide instant and high-speed broadband access to the Internet or to other types of Wide Area Networks (WANs). The MM701G and MM702G provide:  configuration either as a point-to-point LAN extension or as an end-connection to a DSLAM (see page iii for the proces

Summary of the content on the page No. 10

Determine What You Need STEP 2—DETERMINE WHAT YOU NEED In addition to what is shipped with the modem, you need the following hardware and software to complete the installation and configuration. Equipment: Requirement: PC Hardware:  Ethernet NIC Card (10 Mbps) installed in each PC and other network equipment that will be connected to the LAN. Verify if the NIC in the device which directly connects to the modem LAN port is half- or full-duplex. The modem LAN port must be set to the same tra

Summary of the content on the page No. 11

Chapter 1: Installing the Modem STEP 4—CONNECT CABLES Install cables for the Ethernet port (“Connect the 10Base-T Port” below). Then check LED status on page 5. Connect the 10Base-T Port Set the modem MDI/MDI-X switch for the 10Base-T port to allow the modem to connect directly to other network devices such as a PC, hub, switch, or router. M0325-A 1 Set the modem MDI/MDI-X switch to one For connection to of the following: devices such as a PC Ethernet NIC  MDI-X when connecting to a devic

Summary of the content on the page No. 12

DSL LINE POWER CONSOLE 10BASE-T MDI MDI-X Connect Cables DSL line port Wall jack with DSL service 10Base-T port PC, hub or other network device M0152-B Power connector Ensure that the NIC in the PC and the modem LAN port are both set to either half- or full-duplex for the transmission direction(s). If you need to change the modem LAN port setting to match the NIC, follow the procedures in “Manage DSL” on page 118 (half-duplex is the default). 2 Connect the cables to the modem rear panel as s

Summary of the content on the page No. 13

Chapter 1: Installing the Modem LED Status Indications The following indicates the operational status provided by front panel LEDs. LED State Description PWR On green Modem has power. Off Modem does not have power. LAN LINK On green A PC, hub, or other network device is connected to the modem 10Base-T interface. Off No device is connected to the modem 10Base-T interface. TX Flashing green Modem is transmitting data to devices on the LAN. Off Modem is not transmitting data to the LAN. RX Flashi

Summary of the content on the page No. 14

Connect Cables 6 MM701G and MM702G User Manual

Summary of the content on the page No. 15

ACCESSING THE WEB INTERFACE FOR MODEM MANAGEMENT 2 Use the Web interface as the most comprehensive and convenient way to set up and manage the modem. This chapter provides steps to help you access the Web interface pages for configuration and management of the modem. Access to the command-line interface is available through the modem console port or over a network using a telnet session. Not all configuration and management features, however, are supported through the command-line interfac

Summary of the content on the page No. 16

Assign IP Addresses Use the following steps to set up a management PC to be on the same subnet with the modem. (The example shows instructions for a PC that is running Microsoft Windows 98 SE; instructions for other operating systems may differ slightly.) 1 From the Windows desktop, click Start, Settings, Control Panel to open the Control Panel dialog. 2 From the Control Panel dialog, double-click the Network icon (shown to the right). The Network dialog is displayed. 3 From the Configurati

Summary of the content on the page No. 17

Chapter 2: Accessing the Web Interface for Modem Management STEP 2—SET UP THE WEB BROWSER To access and view the modem Web pages, set up features for the Web browser. The Web browser must have cache settings enabled to allow the Web browser to compare its cached Web page against the modem Web page every time it is accessed, providing current information. Also, it is preferable to disable proxies. (The example below shows setup for the Internet Explorer Web browser; instructions for other We

Summary of the content on the page No. 18

Set Up the Web Browser 5 Click the Connections tab, then click LAN Settings to open the LAN Settings dialog. 6 In the Proxy Server section of the dialog, do one of the following:  If the management PC is not connected to an intranet and is connected only to the modem, clear the Use a proxy server box.  If the management PC is connected to the modem and also connected to an intranet (with an assigned proxy server) using a hub, do the following: – select the Use a proxy server box – click Adv

Summary of the content on the page No. 19

Chapter 2: Accessing the Web Interface for Modem Management STEP 3—ACCESSING THE MODEM WEB PAGES Use the following steps to access the login page, enter the Web interface, and navigate the Web pages. This login is for the system administrator responsible for configuring and managing the modem. 1 Do one of the following to access the modem Web pages:  If you did not change the modem 10Base-T port IP address (page 7), type http://10.0.0.1 in the Location Bar field of the Web browser (shown be

Summary of the content on the page No. 20

Accessing the Modem Web Pages The System Status page is displayed and functions as a home page with a menu bar. This menu bar provides navigation to all Web pages used for configuration and management. Additionally, the System Status page provides a status of the current modem configuration. See “View System Status” in Chapter 9, “Managing the Modem” for more information about this System Status page. 12 MM701G and MM702G User Manual


Alternative user manuals
# User manual Category Download
1 ADC Below Ground HDSLx 8-Slot Repeater Housing Radiator II User manual Switch 0
2 ADC FireWire Patch Panel IEEE 1394a User manual Switch 1
3 ADC and V35 User manual Switch 1
4 ADC DS1 VDSL-Grade Transport System Cable 103326AE User manual Switch 1
5 ADC ADX Active Digital Cross-Connect ADX200 User manual Switch 2
6 ADC ADX Active Digital Cross-Connect ADX201 User manual Switch 10
7 ADC InterReach Office 105880AE User manual Switch 0
8 ADC LoopStar 745P User manual Switch 0
9 ADC AVIDIA SWD4573I1 User manual Switch 0
10 ADC Migration Modules DSX-3 User manual Switch 1
11 ADC LoopStar 745 User manual Switch 1
12 ADC CUDA 3 User manual Switch 0
13 ADC Micro BS Plus UltraWAVE User manual Switch 0
14 ADC ICX-250 User manual Switch 0
15 ADC PowerWorx Circuit Breaker Panel With Reset User manual Switch 3
16 Sony 4-296-436-11 (2) User manual Switch 0
17 3Com 10/100BASE-TX User manual Switch 61
18 3Com 2226-SFP User manual Switch 688
19 3Com 16985ua.bk User manual Switch 10
20 3Com 10BASE-T User manual Switch 4