Summary of the content on the page No. 1
TigerStack 10G
Gigabit Ethernet Switch
◆ 24/48 auto-MDI/MDI-X 10/100/1000BASE-T ports
◆ 4 ports shared with 4 SFP transceiver slots
◆ Non-blocking switching architecture
◆ Support for a redundant power unit
◆ Spanning Tree Protocol, RSTP, and MSTP
◆ Up to 32 LACP or static 8-port trunks
◆ Layer 2/3/4 CoS support through eight priority queues
◆ Layer 3/4 traffic priority with IP Precedence and IP DSCP
◆ Full support for VLANs with GVRP
◆ IGMP multicast filtering and snooping
◆ Support for jumbo f
Summary of the content on the page No. 2
Summary of the content on the page No. 3
TigerStack 10G Installation Guide From SMC’s Tiger line of feature-rich workgroup LAN solutions 38 Tesla Irvine, CA 92618 October 2004 Phone: (949) 679-8000 Pub. # 150200048900A
Summary of the content on the page No. 4
Information furnished by SMC Networks, Inc. (SMC) is believed to be accurate and reliable. However, no responsibility is assumed by SMC for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SMC. SMC reserves the right to change specifications at any time without notice. Copyright © 2004 by SMC Networks, Inc. 38 Tesla Irvine, CA 92618 All rights res
Summary of the content on the page No. 5
LIMITED WARRANTY Limited Warranty Statement: SMC Networks, Inc. (SMC) warrants its products to be free from defects in workmanship and materials, under normal use and service, for the applicable warranty term. All SMC products carry a standard 90-day limited warranty from the date of purchase from SMC or its Authorized Reseller. SMC may, at its own discretion, repair or replace any product not operating as warranted with a similar or functionally equivalent product, during the applicable
Summary of the content on the page No. 6
WARRANTIES EXCLUSIVE: IF AN SMC PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, CUSTOMERS SOLE REMEDY SHALL BE REPAIR OR REPLACEMENT OF THE PRODUCT IN QUESTION, AT SMCS OPTION. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. SMC NEITHER ASSUMES NOR AUTHORIZES
Summary of the content on the page No. 7
COMPLIANCES FCC - Class A This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio communications. It has been tested and found to comply with the limits for a Class A computing device pursuant to Subpart B of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. Operation of this equi
Summary of the content on the page No. 8
COMPLIANCES CE Mark Declaration of Conformance for EMI and Safety (EEC) SMC contact for these products in Europe is: SMC Networks Europe, Edificio Conata II, o a Calle Fructuós Gelabert 6-8, 2 , 4 , 08970 - Sant Joan Despí, Barcelona, Spain. This information technology equipment complies with the requirements of the Council Directive 89/336/EEC on the Approximation of the laws of the Member States relating to Electromagnetic Compatibility and 73/23/EEC for electrical equipment used within ce
Summary of the content on the page No. 9
COMPLIANCES Taiwan BSMI Class A Australia AS/NZS 3548 (1995) - Class A SMC contact for products in Australia is: SMC Communications Pty. Ltd. Suite 18, 12 Tryon Road, Lindfield NSW2070, Phone: 61-2-94160437 Fax: 61-2-94160474 Safety Compliance Warning: Fiber Optic Port Safety When using a fiber optic port, never look at the transmit laser while CLASS I it is powered on. Also, never look directly at the fiber TX port and LASER DEVICE fiber cable ends when they are powered on. Avertissment: Por
Summary of the content on the page No. 10
COMPLIANCES Power Cord Safety Please read the following safety information carefully before installing the switch: WARNING: Installation and removal of the unit must be carried out by qualified personnel only. The unit must be connected to an earthed (grounded) outlet to comply with international safety standards. Do not connect the unit to an A.C. outlet (power supply) without an earth (ground) connection. The appliance coupler (the connector to the unit and not the wall plug) must have
Summary of the content on the page No. 11
COMPLIANCES Power Cord Set Europe The supply plug must comply with CEE7/7 (SCHUKO). The mains cord must be or marked and be of type HO3VVF3GO.75 (minimum). IEC-320 receptacle. Veuillez lire à fond l'information de la sécurité suivante avant d'installer le Switch: AVERTISSEMENT: Linstallation et la dépose de ce groupe doivent être confiés à un personnel qualifié. Ne branchez pas votre appareil sur une prise secteur (alimentation électrique) lorsqu'il n'y a pas de connexion
Summary of the content on the page No. 12
COMPLIANCES Cordon électrique - Il doit être agréé dans le pays dutilisation Danemark: La prise mâle dalimentation doit respecter la section 107-2 D1 de la norme DK2 1a ou DK2 5a. Suisse: La prise mâle dalimentation doit respecter la norme SEV/ASE 1011. Europe La prise secteur doit être conforme aux normes CEE 7/7 (SCHUKO) LE cordon secteur doit porter la mention ou et doit être de type HO3VVF3GO.75 (minimum). Bitte unbedingt vor dem Einbauen des Switches die folgenden Si
Summary of the content on the page No. 13
COMPLIANCES Warnings and Cautionary Messages Warning: This product does not contain any serviceable user parts. Warning: Installation and removal of the unit must be carried out by qualified personnel only. Warning: When connecting this device to a power outlet, connect the field ground lead on the tri-pole power plug to a valid earth ground line to prevent electrical hazards. Warning: This switch uses lasers to transmit signals over fiber optic cable. The lasers are compliant with the requi
Summary of the content on the page No. 14
COMPLIANCES Purpose This guide details the hardware features of the switch, including Its physical and performance-related characteristics, and how to install the switch. Related Publications The following publication gives specific information on how to operate and use the management functions of the switch: The SMC8724M, SMC8748M Management Guide Also, as part of the switchs firmware, there is an online web-based help that describes all management related features. x
Summary of the content on the page No. 15
TABLE OF CONTENTS 1 About the TigerStack 10G . . . . . . . . . . . . . . . . . . . . . . 1-1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Switch Architecture . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-2 Management Options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 Description of Hardware . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3 10/100
Summary of the content on the page No. 16
TABLE OF CONTENTS Installing an Optional SFP Transceiver into the Switch . . . . . . . 3-7 Connecting Switches in a Stack . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-8 Stacking Topologies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-9 Connecting to a Power Source . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-10 Connecting to the Console Port . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-11 4 Making Network Conn
Summary of the content on the page No. 17
TABLE OF CONTENTS APPENDICES: A Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .A-1 Diagnosing Switch Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-1 Power and Cooling Problems . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-2 In-Band Access . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 18
TABLE OF CONTENTS xiv
Summary of the content on the page No. 19
TABLES Table 1-1 Port Status LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5 Table 1-2 System Status LEDs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-6 Table 3-1 Wiring Map for Serial Cable . . . . . . . . . . . . . . . . . . . . . . . . 3-11 Table 4-1 Maximum 1000BASE-T Gigabit Ethernet Cable Length . . 4-6 Table 4-2 Maximum 1000BASE-SX Fiber Optic Cable Distance . . . . 4-6 Table 4-3 Maximum 1000BASE-LX Fiber Optic Cable Length . . . . . 4-7 Tab
Summary of the content on the page No. 20
TABLES xvi
