Summary of the content on the page No. 1
NDA-24318
ISSUE 1
STOCK # 200818
®
IPTRK Circuit Card System Manual
NOVEMBER, 2000
NEC America, Inc.
Summary of the content on the page No. 2
LIABILITY DISCLAIMER NEC America, Inc. reserves the right to change the specifications, functions, or features, at any time, without notice. NEC America, Inc. has prepared this document for use by its employees and customers. The information contained herein is the property of NEC America, Inc. and shall not be reproduced without prior written approval from NEC America, Inc. ® term® NEAX and D are registered trademarks of NEC Corporation. ® Cisco is a registered trademark of Cisco Systems, Inc.
Summary of the content on the page No. 3
ISSUE No. ISSUE No. PAGE No. PAGE No. 123 4567 8 12 345 678 i 1 35 1 36 1 ii 1 37 1 iii 1 iv 1 38 1 39 1 1 1 40 1 2 1 3 1 41 1 4 1 42 1 43 1 5 1 6 1 44 1 7 1 45 1 46 1 8 1 9 1 47 1 10 1 48 1 49 1 11 1 12 1 50 1 13 1 14 1 15 1 16 1 17 1 18 1 19 1 20 1 21 1 22 1 23 1 24 1 25 1 26 1 27 1 28 1 29 1 30 1 31 1 32 1 33 1 34 1 ISSUE 1 ISSUE 2 ISSUE 3 ISSUE 4 DATE NOVEMBER, 2000 DATE DATE DATE ISSUE 5 ISSUE 6 ISSUE 7 ISSUE 8 DATE DATE DATE DATE NEAX2400 IPX Revision Sheet 1/1 IPTRK Circuit Card System Ma
Summary of the content on the page No. 4
NDA-24318 ISSUE 1 NOVEMBER, 2000 NEAX2400 IPX IPTRK Circuit Card System Manual TABLE OF CONTENTS Page CHAPTER 1 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1. GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 2. SERVICE FEATURES TO BE PROVIDED . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Summary of the content on the page No. 5
LIST OF FIGURES Page Figure 1-1 Example Network Configuration via Intranet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Figure 1-2 Outer View of IPTRK Circuit Card Furnished with a Sub Board (PZ-8VCTB) . . . . . . . . . . . . . . 1 Figure 1-3 Block Diagram - CCIS Networking via IP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Figure 1-4 Block Diagram - CCIS Networking via IP [Point-to-Multipoint Connection] . . . . . . . .
Summary of the content on the page No. 6
LIST OF TABLES Page Table 1-1 Specification of IP Trunk . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Table 2-1 Lamp Indication Meanings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Table 2-2 Switch Setting Meanings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Table 2-3 PAD Values of µ-law Pattern 1 /
Summary of the content on the page No. 7
This page is for your notes. LIST OF TABLES NDA-24318 Page iv Issue 1
Summary of the content on the page No. 8
LAN LAN INTRODUCTION CHAPTER 1 INTRODUCTION 1. GENERAL This manual explains the installation of the following IPTRK circuit cards, which are used to send/receive voice or FAX (G3) information via the Intranet. Although PA-8IPTB is equipped with a total of eight ports, an optional sub board (PZ-8VCTB) provides an additional eight ports, when mounted on a PA-8IPTB main board. • PA-8IPTB (with eight ports) PZ-8VCTB (optional daughter board provides an additional eight ports to PA-8IPTB) IP Packet
Summary of the content on the page No. 9
INTRODUCTION Table 1-1 Specification of IP Trunk (Continued) FUNCTION SPECIFICATION REMARKS G3 FAX (V.17, V.21, V.27ter, V.29, V.33) is available FAX FAX Relay (T.30) Super G3 (V.34, etc.) is not available Note 1 INTER-OFFICE SIGNAL LINK NEAX2400 IPX → NEAX2400 IPX FCCS MP MP: Point-to-Multipoint CCIS MP 2 NEAX2400 IPX → NEAX2000 IVS CCIS MP Jitter Dynamic Jitter Buffer Buffer Value (40 ~ 300 ms) LAN Interface 10 BASE-T (100 BASE-TX) ® QoS (Quality of Service) WFQ by ToS Use Cisco router Ec
Summary of the content on the page No. 10
INTRODUCTION Figure 1-3 represents a block diagram example of CCIS Networking via IP [C-163]. For more detailed information, see CHAPTER 3. Node A Node B Both Speech and Signal IPTRK IPTRK Router Router IPTRK POWER Intranet POWER IPTRK Both Speech and Signal CPU CPU Router POWER Node C Symbols: IPTRK: IP Trunk : Ethernet cable IPTRK IPTRK Both Speech and Signal CPU Figure 1-3 Block Diagram - CCIS Networking via IP Note: As shown, the IPTRK circuit cards in the self-node and its connected node
Summary of the content on the page No. 11
To IPTRK of Node C INTRODUCTION Figure 1-4 represents a block diagram example of CCIS Networking via IP [C-163] when an IPTRK circuit card in Node A is connected to the IPTRKs of Node B and C (Point-to-Multipoint connection). For more detailed information, see CHAPTER 3. Point-to-Multipoint Connection Node A Node B To IPTRK of Node B IPTRK IPTRK Router Router Intranet POWER POWER Both Speech and Signal Both Speech and Signal CPU CPU Router POWER Node C IPTRK Both Speech and Signal Symbols: IPTRK
Summary of the content on the page No. 12
INTRODUCTION Figure 1-5 represents a block diagram example of FCCS Networking via IP [F-36]. For more detailed information, see CHAPTER 3. Node A Node B IPTRK Both Speech and Signal Both Speech and Signal IPTRK IPCON IPCON FCON Router Router FCON POWER POWER Intranet IPTRK IPTRK IPCON IPCON FCON FCON FCCS Signal HUB HUB FCCS Signal CPU CPU LANI LANI Router POWER Both Speech and Signal Node C IPTRK IPCON FCON IPTRK IPCON FCON Symbols: IPTRK: IP Trunk LANI: LAN Interface (PZ-PC19) :10 BASE-T Cable
Summary of the content on the page No. 13
INTRODUCTION 3. HOW TO FOLLOW THIS MANUAL AND RELATED REFERENCE MANUALS This manual describes only items related to the IPTRK circuit cards. Therefore, if you need details on the NEAX2400 IPX, the FCCS network, or the CCIS network, please refer to the related manual. Configuration of this manual and related reference manuals are shown below. 3.1 How to Follow This Manual CHAPTER 1 INTRODUCTION This chapter explains the purpose of this manual. CHAPTER 2 CIRCUIT CARD EXPLANATIONS This chapter
Summary of the content on the page No. 14
Ethernet Cable CIRCUIT CARD EXPLANATIONS CHAPTER 2 CIRCUIT CARD EXPLANATIONS 1. GENERAL This chapter provides detailed explanations for the following circuit cards: PA-8IPTB PZ-8VCTB 2. PA-8IPTB (IPTRK Circuit Card) 2.1 General Function PA-8IPTB is a Line/Trunk circuit card that is used for providing CCIS/FCCS service via the Intranet, and to send/receive voice or FAX (G3) information over IP. PA-8IPTB is equipped with a total of eight ports, however, an optional sub board (PZ-8VCTB) provide
Summary of the content on the page No. 15
CIRCUIT CARD EXPLANATIONS 2.2 Mounting Location/Condition Mounting location/condition of this card is shown below. Mount this card in the following shaded slots: 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23 PIM Universal Slots Universal Slots Figure 2-2 PA-8IPTB Circuit Card Mounting Locations Mounting conditions of this card are as follows: When this card is used without a sub board (PZ-8VCTB), and mounted in any of the universal slots 05, 07, 09, 16, 18 or 20: Al
Summary of the content on the page No. 16
23 22 21 20 23 22 21 20 19 18 17 16 19 18 17 16 15 14 13 12 15 14 13 12 11 10 11 10 09 08 09 08 07 06 07 06 05 04 05 04 03 02 03 02 01 00 01 00 23 22 21 23 22 21 20 19 18 17 16 19 18 17 16 15 14 13 12 15 14 13 12 11 10 11 10 09 08 09 08 07 07 06 06 05 04 05 04 03 02 03 02 01 00 01 00 PWR PWR PZ-8VCTB CIRCUIT CARD EXPLANATIONS Ex. Slot 05 Examples of PA-8IPTB port accommodation: Ex. Slot 21 Not equipped with Sub Board (PZ-8VCTB) PA-8IPTB in a 16 port slot PA-8IPTB in
Summary of the content on the page No. 17
SW10 SW20 SW30 SUB3B SW40 SW50 SW60 SUB3A CIRCUIT CARD EXPLANATIONS 2.3 Face Layout of Lamps, Switches and Connectors The face layout of lamps, switches and connectors on this circuit card are shown below. For more detailed information, see Section 2.6 External Interfaces. OPE MB MBR BUSY SUBOPE3 SUBOPE2 SUBOPE1 SUBOPE0 L3 L2 L1 MODE IP-LRR IP-TXRX IP-LINK IP-COL IP-100M IPCON F-LRR F-TXRX F-LINK F-COL F-100M FCON Figure 2-4 Face Layout of PA-8IPTB IPTRK Circuit Card Note: When mounting the op
Summary of the content on the page No. 18
CIRCUIT CARD EXPLANATIONS Table 2-1 Lamp Indication Meanings (Continued) LAMP NAME COLOR MEANING OF INDICATION IP-LINK Green Lights when establishing a connection (physically) with the IP network. IP-TXRX Green Lights when sending/receiving data packets. IP-100M Green Lights when 100 Mbps interface is in use. IP-COL Yellow Lights when data packet collision is detected. F-LRR Green Lights when this card is used with FCCS network. F-LINK Green Lights when establishing a connection (physically)
Summary of the content on the page No. 19
CIRCUIT CARD EXPLANATIONS Table 2-2 Switch Setting Meanings (Continued) SWITCH SWITCH STANDARD SETTING MEANING NAME NUMBER SETTING ON External Ether 100 Mbps: Fixed Note 1 1 OFF × External Ether 10 Mbps: Fixed Note 1 ON Internal Ether 100 Mbps: Fixed Note 1 2 OFF × Internal Ether 10 Mbps: Fixed Note 1 PAD Pattern Selection SW10-3 SW10-4 SW10-5 PAD PATTERN SELECTION OFF OFF OFF Not used ON OFF OFF Not used OFF ON OFF µ-law Pattern 1 (for North America) ON ON OFF µ-law Pattern 2 (for North Ame
Summary of the content on the page No. 20
CIRCUIT CARD EXPLANATIONS Table 2-2 Switch Setting Meanings (Continued) SWITCH SWITCH STANDARD SETTING MEANING NAME NUMBER SETTING Designation of Flexible PAD Value Note 1 SW20 SW20 SW20 SW20 SW20 SW20 PAD -1 -2 -3 -4 -5 -6 VALUE OFF OFF OFF OFF OFF OFF 16 [dB] ON OFF OFF OFF OFF OFF 15 [dB] OFF ON OFF OFF OFF OFF 14 [dB] ON ON OFF OFF OFF OFF 13 [dB] OFF OFF ON OFF OFF OFF 12 [dB] ON OFF ON OFF OFF OFF 11 [dB] OFF ON ON OFF OFF OFF 10 [dB] 1~6 ON ON ON OFF OFF OFF 9 [dB] OFF OFF OFF ON OFF
