Extron electronic IR 501 user manual

Summary of the content on the page No. 1

Operations
Unmute an output
Press the UNMUTE button to unmute all video and audio outputs.
All of the switcher’s Output LEDs flash on for a second.
User’s Guide
Troubleshooting
If the switcher does not properly respond to IR remote control
functions, check the following:
 You may be too far from the switcher. The maximum operating
range is 30 feet.
 You may be too far to the side of the switcher. The remote
control must be pointed within 30 degrees of the switcher’s IR
sensor for best result

Summary of the content on the page No. 2

Operations Introduction 2 +10 button — The +10 button About this User’s Guide is used with the other I/O This user’s guide covers the Extron IR 501 Small Matrix Infrared buttons to select numbers (IR) Remote Control, part #70-336-01. The IR 501 is an optional higher than 0 through 9. remote control that works with Extron matrix switchers. The remote control can duplicate most of the matrix switcher’s front Enter button — The Enter 3 panel control functions and some of RS-232 control functions.

Summary of the content on the page No. 3

Operations Indications 8 10 Switcher Indications Sample Operations It is not the purpose of this manual to define The following examples show operations with specific MAV SERIES AV MATRIX SWITCHER I/O the switcher’s front panel indications, but two input, output, and preset numbers. Use your own IR +dB of the switcher’s LEDs indicate operation by -dB numbers as desired. AUDIO SETUP the IR 501 remote control (figure 3). The switcher’s Power LED flashes whenever the switcher Other indications are

Summary of the content on the page No. 4

Operations View ties Presets View a tie by input selection Save a preset INPUT 1. Create all desired ties. 1. Press the button to specify an input to view the tied output(s). The switcher's Video LED and Audio LEDs light. 2. Press the SAVE button to specify a save preset operation. To view video and audio ties, skip step 2. PRESET 3. Press the button to specify preset mode. The switcher's Preset LED blinks and, for preset numbers that 2. If desired, specify video-only or audio-only to view: