Xantech 490-95 user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS
MODEL 490-95
MICRO LINK™ “PLASMA FRIENDLY” INFRARED RECEIVER
TABLE OF CONTENTS
INTRODUCTION ............................................................................................................................................................. 1
Features ...................................................................................................................................................................... 1
Specifications .......................

Summary of the content on the page No. 2

Page 2 Model 490-95 INSTALLATION These units, equipped with a 7-foot cable and 3.5 mm stereo mini plug, are intended to be plugged directly into the "IR RCVR" or "AUX" jack on Xantech Connecting Blocks, such as the CB12(included), CB60, 789-44, 791-44, etc. The 490- 95 should be used in installations where the connecting block is within reach of the 7-foot cable -- such as when installing the 490-95 in a cabinet where the controlled equipment is behind closed doors. PLACEMENT Placement

Summary of the content on the page No. 3

 (( 3 "455"56 04"7 8  $% %$ Model 490-95 Page 3 APPLICATION WIRING A typical system, with a 490-95, 781RG Power Supply and 283M Emitter plugged into a 789-44 Connecting Block, is shown in Figure 3: 1. Plug in the 2.1mm Coaxial power plug of the 781RG Power Supply (not included) into the jack labeled 12VDC on the 789-44 Connecting Block. 2. Plug the AC end of the 781RG power Supply into an ‘un-switched’ 120v AC Line outlet. 3. Plug the 3.5mm stereo mini plug from the 4

Summary of the content on the page No. 4

 "     9            !    Page 4 Model 490-95     %#&  1  ! '  2 #: + (   ()* 0+0 +    + "#$   ,  ! - $/          1     !67   -8.+/  "#$%& 28 $'(  ,, (     )**+,&-*./),0