Dacor DR30GIFS user manual

Summary of the content on the page No. 1

DR30GS, DR30GFS, DR30GIS, DR30GIFS
Document # PG05-007 Revised 04/04/13 Page 1/5

™
Distinctive 30” Wide PLANNING
All Gas Ranges GUIDE
All tolerances ±1/16” (±1.6 mm) unless otherwise noted.
warning
• Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
• This appliance must be installed in accordance with the
accompanying installation instructions.
46 3/4” (118.7 cm) Front of open door
NOTE: Models

Summary of the content on the page No. 2

DR30GS, DR30GFS, DR30GIS, DR30GIFS Document # PG05-007 Revised 04/04/13 Page 2/5 Distinctive 30” Wide PLANNING All Gas Ranges GUIDE All tolerances +1/16” (+1.6 mm), -0 unless otherwise noted. B ■ Failure to meet or exceed the maximum and minimum dimensions/clearances stated may result in a fire hazard. ■ The range should be placed away from drafts that may be caused by doors, windows and heating and air conditioning outlets. ■ To eliminate the risk of burns or fire by reaching over heat

Summary of the content on the page No. 3

DR30GS, DR30GFS, DR30GIS, DR30GIFS Document # PG05-007 Revised 04/04/13 Page 3/5 Distinctive 30” Wide PLANNING All Gas Ranges GUIDE Self-r imming installation, custom Cutout Options (Models Dr 30gi S and Dr 30gi FS Only) nOTE: The diagrams below are for installations that require custom cutouts. See page 5/5 for installation in standard 30 inch wide cutout. All tolerances +1/16” (+1.6 mm), -0 unless otherwise noted. For all self-rimming installations: Countertop height: 34 3/4” (88.3 cm)

Summary of the content on the page No. 4

DR30GS, DR30GFS, DR30GIS, DR30GIFS Document # PG05-007 Revised 04/04/13 Page 4/5 Distinctive 30” Wide PLANNING All Gas Ranges GUIDE r aised Vent (Self-r imming) installation Cutout Options (Models Dr 30gi S and Dr 30gi FS Only) All tolerances +1/16” (+1.6 mm), -0 unless otherwise noted. 3/8” min. (1.0 cm) flat countertop For all installations with a raised vent: overhang required behind cutout Countertop height: 34 3/4” (88.3 cm) min. 36 7/8” (93.7 cm) max. Wall 29 1/2” (7

Summary of the content on the page No. 5

DR30GS, DR30GFS, DR30GIS, DR30GIFS Document # PG05-007 Revised 04/04/13 Page 5/5 PLANNING Distinctive 30” Wide GUIDE All Gas Ranges Self-r imming installation, Standard Cutout r equirements (Models Dr 30gi S and Dr 30gi FS Only) 10” min. (25.4 cm) Non-combustible to any combustibles rear wall required above counter both sides 24 3/8” 30” (76.2 cm) min. countertop/cabinet opening (61.9 cm) Cabinet face below countertop Countertop front St ANDARD WIDth cUt OUt FOR m ODEL DR30DI[F]S SELF-RImm