Summary of the content on the page No. 1
8490 D
Cooker hood
Operating and Installation Instructions
Summary of the content on the page No. 2
Contents Safety instructions ..................................................... 2 Description of the cooker hood ................................... 3 Using the cooker hood ............................................... 4 Maintenance and cleaning .......................................... 6 What to do if .............................................................. 8 Service and Spare Parts ............................................. 9 Customer Care .......................................
Summary of the content on the page No. 3
Use of cooker hood ● This appliance is for domestic use only in a normal household. ● Never leave any deep-frying, melting fat, paraffin or any other inflammable liquid unattended on the hob. In the event of fire: Immediately switch off the cooker hood and the cooker. Note! Cover the fire. Never use water. ● Never do any flambé cooking underneath the cooker hood. It can cause a fire. Remember that overheated fat may spontaneously ignite. Never leave the frying pan unattended. ● It is essential
Summary of the content on the page No. 4
Using the cooker hood The control panel T1: Main switch on/off (Activating and deactivating the stand-by mode) T2: Sensor switch enable/disable T3: Lamps on/off D1: Filter saturation indicator D2: Motor speed display 1-2-3-P (intensive) D1-D2: Minute count down display (delayed switch off) T4: Motor speed T5: Intensive speed on/off T6: Switch for delayed switch off SENSOR: Display for enabled sensor switch Fig. 2 Function at displayed ”SENSOR” ● If the hand is moved over the sensor or the knob T
Summary of the content on the page No. 5
Delayed switch off ● The delayed switch off can be activated with knob T6 while the motor is running ● The display shows remaining minutes until the motor and lamps (if on) are switched off ● The switch off delay is depending on motor speed: Speed 1: 20 minutes Speed 2: 15 minutes Speed 3: 10 minutes Intensive speed: 5 minutes Filter saturation indicator: ● If the display shows the letter ”F”, it means that the grease filters should be cleaned (after running 40 hours) ● If the display shows the
Summary of the content on the page No. 6
Maintenance and cleaning Before doing any maintenance work on the hood, disconnect it from the main supply by disconnecting the plug from the wall socket or unscrewing the fuse. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products. Cleaning the grease filters Clean the filter every month or every other month according to how much the hood is used. The cleaner the filters, the more grease they collect
Summary of the content on the page No. 7
After approximately three years of use, the KF8 filter should be replaced with a new, as the odour reduction capacity will be reduced. To remove the filter (Fig. 4): ● Remove the grease filters. ● Press the red buttons (A), lower the front of the carbon filter. ● Remove the carbon filter. ● Replace in reverse order. Fig. 4 Clean the filters regularly. The grease that collects in the filters and the duct could ignite if a hot plate is left on (or if overheating occurs). Changing the light
Summary of the content on the page No. 8
What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. The cooker hood is not working The fan speed is set high enough effectively... for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the charcoal filter is
Summary of the content on the page No. 9
Service and spare parts In the event of your apppliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning 08705 929 929 Your call will be automatically routed to the Service Centre covering your post code area. Please ensure that you have read the section „What to do if....“ as the engineer will make a charge if the fault is not a mechanical or electrical breakdown even the appliance is under warranty. Please note that proof of
Summary of the content on the page No. 10
Guarantee conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation.The guarantee does not cover commercial use. 2. The guarantee covers all parts or components which fail due to faulty workmanship or faulty materials. The guarantee does not cover appliances where
Summary of the content on the page No. 11
Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home.They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances. France Senlis +33 (0) 44 62 29 29 Germany Nürnberg +49 (0) 911 323 2600 Italy Pordenone +39 (0) 1678 47053 Sweden Stockholm +46 (0) 8 738 7910 UK Slough +44 (0) 1753 219899 Technical data Model 8490 D Size Height 820-1370 mm Width 898 mm Depth 480 mm Lig
Summary of the content on the page No. 12
Installation Unpacking Check that the cooker hood is not damaged. Transportation damages should immediately be reported to the transport company. Damages, faults and missing parts should immediately be reported to the retailer. Dispose carefully of the packaging material so that it is out of the way of small children. Position The cooker hood should be mounted freely hanging on the wall. The cooker hood must be at least 50 cm above electric hobs or electric ranges, or at least 65 cm above gas bu
Summary of the content on the page No. 13
Mounting the cooker hood - Fig. 7 Position the template on the wall and mark the position, and drill the holes (2 x Ø 8 mm).Mount the two rawl plugs with the hooks (3) Hang the hood on the hooks and level it with the adjustment screws (4) Remove the grease filters (5) and mark for the two screws (6). Remove the hood and drill the holes (2 x Ø 8 mm). Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it horizontally with the screws (8) and secure it with the screws (9) Mount th
Summary of the content on the page No. 14
12 12 Fig. 7 14
Summary of the content on the page No. 15
Exhaust tube Power outlet Electric hob 500 mm Gas hob 650 mm Charcoal and oil 700 mm Wall bracket Electric hob 500 mm Gas hob 650 mm Charcoal and oil 700 mm Fig. 8 15
Summary of the content on the page No. 16
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG LI1IAE
