Summary of the content on the page No. 1
INSTRUCTION BOOK
FOR ELECTROLUX
COOKER HOOD
CH 710
UK
cod. 436002549_01 - 050128
Summary of the content on the page No. 2
Summary of the content on the page No. 3
Thank you for buying a Electrolux product. To enable you to use your appliance effectively and safely, please read this instruction book carefully before using the appliance and retain for future reference. If you require guidance in the use of the appliance or require further in- formation on Electrolux Products, please contact our Customer Care Department. For general enquiries concerning your Electrolux appliance or for further information, visit our website at http://www.electrolux.co.uk
Summary of the content on the page No. 4
IMPORTANT SAFETY INFORMATION These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Installation Child Safety • Any installation work must be undertaken by a quali- fi ed electrician or a competent person. • This appliance is designed to be operated by adults. Chil
Summary of the content on the page No. 5
YOUR APPLIANCE
OPERATING INSTRUCTIONS This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Cooker Hood Controls The cooker hood functions are controlled by four push button switches located centrally in the control fascia. L Turns the worktop lighting On and Off S Mains light - illumination indicates fan motor is running V1 Turns the fan motor On and Off at low speed, suitable for one pan or whe
Summary of the content on the page No. 6
To Operate Select the required fan speed and light if required. Recirculation In the recirculation mode the contaminated air enters the cooker hood through the grease fi lters. The air is cleaned by passing through the charcoal fi lters before being passed back into the kitchen through the grilles in either side of the chimney stack. Extraction In the extraction mode the contaminated air enters the cooker hood passing through the grease fi lters and is passed out through the ducting into the atmosp
Summary of the content on the page No. 7
MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fi re hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent. Never use scouring pads or abrasive cleaners. Never use excessive amounts of water when cleaning particularly around the control panel. Metal Grease Filters The grease fi lters absorb
Summary of the content on the page No. 8
Position the new charcoal fi lter in the position marked and while holding the fi lter replace the fi xing hooks as illustrated. This appliance can be a possible fi re hazard if the grease and charcoal fi lters are not cleaned and replaced as recommended. Changing the Light Bulb Remove the screw fi xing the lighting support. Pull the lighting support downwards. Remove the light bulb by unscrewing it anticlockwise. Insert the new light bulb into the lighting support and screw it clock
Summary of the content on the page No. 9
SOMETHING NOT WORKING If, having followed these instructions carefully, your cooker hood fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start • Check the hood is connected to the electricity supply. • Make sure the switch is in the ‘ON’ position. The cooker hood is not working effectively • The fan speed is set high enough for the task • The grease fi lter is clean. • The kitchen is adequately vented to
Summary of the content on the page No. 10
GUARANTEE CONDITIONS We Electrolux, undertake that if within twenty four months of the date of the purchase this Electrolux built-in applian- ce or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF ANY CHARGE for labour, materials or carriage on condition that: • The appliance has been correctly installed and used only on the electrical supply stated on the rating plate. • The applia
Summary of the content on the page No. 11
INSTALLATION INSTRUCTIONS It is dangerous to alter the specifi cations or attempt to modify this product in any way. Technical Information DIMENSIONS HEIGHT OF CANOPY: 54 mm HEIGHT OF CHIMNEY: (UPPER SECTION) 465 mm (LOWER SECTION) 740 mm WIDTH OF CANOPY : 598 mm DEPTH OF CANOPY: 520 mm ELECTRICAL SUPPLY
Summary of the content on the page No. 12
INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood. Installation Requirements Before installation check the wall to which the cooker hood is to be fi tted for electric cables, water pipes or gas. This cooker hood is designed to
Summary of the content on the page No. 13
INSTALLING THE COOKER HOOD Clearance Height The cooker hood is designed to be fi tted over a cooking appliance at the clearance heights stated, providing the maximum output of the appliance beneath does not exceed the maximums quoted in the Technical Speci- fi cations. If the output of the appliance below the cooker hood exceeds the maximum outputs quoted, please refer to Hob the cooker manufacturer’s installation instructions. A clearance height of 650mm (25 1/2 ”) is required when A: Built
Summary of the content on the page No. 14
INSTALLING THE COOKER HOOD Fitting the Wall Brackets Wall marking: • Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. • Draw a horizontal line at 650 mm above the hob. • Place bracket 7.2.1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre (notch) with the vertical reference line. • Mark the wall at the centres of the holes in the brack
Summary of the content on the page No. 15
INSTALLING THE COOKER HOOD Fitting the Hood Body Before starting to fi x the hood body, tighten the two screws Vr located on the top of the hood body. Hook the hood body onto the two 4.2x44.4mm screws item 12a. Fully tighten the screws item 12a. Using a screw driver and spirit level, adjust the screws item Vr until the hood body is level. Extraction The cooker hood is more effective when used in the extraction mode (ducted to the outside). Venting kits may be purchased through y
Summary of the content on the page No. 16
INSTALLING THE COOKER HOOD Extraction The charcoal fi lter is not required in this mode and should be removed. Ducting The ducting used must be Ø150mm (6ins), or Ø125mm (5ins) in diameter. If possible duct through the wall immediately above the hood body. For the best performance use the shortest possible duct run and the minimum number of bends. Where fl exible ducting is fi tted it should not be turned through very tight bends as this may impair the performance of the hood.
It is
Summary of the content on the page No. 17
INSTALLING THE COOKER HOOD Fitting the Chimney Stack The chimney consists of two sections. The lower chimney measures 740mm and the upper chimney (with the recirculation grilles on either side) measures 465mm. The overall installed measurement is min. 870 - max 1200mm. UPPER CHIMNEY To fi t the upper chimney section item 2.1 expand the chimney slightly to allow it to be fi tted over the brackets item 7.2.1 as illustrated. When installed in the recirculation mode ensur
Summary of the content on the page No. 18
Summary of the content on the page No. 19
Summary of the content on the page No. 20
55 - 77 High Street - Slough BERKSHIRE SL1 1DZ © Electrolux plc 2002
