Summary of the content on the page No. 1
KTS-MP400MR
KTS-300MR
CD-RECEIVER
INSTRUCTION MANUAL
AMPLI-TUNER-LECTEUR DE CD
MODE D’EMPLOI
REPRODUCTOR DE DISCOS COMPACTOS RECEPTOR DE FM/AM
MANUAL DE INSTRUCCIONES
Take the time to read through this instruction manual.
Familiarity with installation and operation procedures will help
you obtain the best performance from your new CD-receiver.
For your records
Record the serial number, found on the back of the unit, in the space
provided below. Refer to the model and serial numbers whenever
Summary of the content on the page No. 2
Contents Warning 3 HD Radio control features 20 Tuning Safety precautions 4 Auto Memory Entry Notes 6 Menu system 22 Menu System About CDs 7 Touch Sensor Tone Manual Clock Adjustment Notes on playing MP3/WMA 8 Selectable Illumination Contrast Adjustment General features 10 Dimmer Power System Q Setting Selecting the Source Switching preout Volume Built-in Amp Mute Setting Attenuator SIRIUS ID (ESN) display System Q Dual Zone System Audio Control Dual Zone System Setting Switching Display B.M.S.
Summary of the content on the page No. 3
2Warning 2CAUTION NOTE Use of controls or adjustments or performance of This equipment has been tested and found to procedures other than those specified herein may comply with the limits for a Class B digital device, result in hazardous radiation exposure. pursuant to Part 15 of the FCC Rules. These limits In compliance with Federal Regulations, following are designed to provide reasonable protection are reproductions of labels on, or inside the product against harmful interference in a re
Summary of the content on the page No. 4
Safety precautions 2WARNING 2CAUTION To prevent injury or fire, take the To prevent damage to the machine, take following precautions: the following precautions: • Insert the unit all the way in until it is fully locked • Make sure to ground the unit to a negative 12V in place. Otherwise it may fall out of place when DC power supply. jolted. • Do not open the top or bottom covers of the unit. • When extending the ignition, battery, or ground • Do not install the unit in a spot exposed to dire
Summary of the content on the page No. 5
About CD players/disc changers NOTE connected to this unit • If the unit fails to operate properly, press the Reset Kenwood disc changers/ CD players released in button. If the unit still fails to operate properly 1998 or later can be connected to this unit. after the Reset button has been pressed, contact Refer to the catalog or consult your Kenwood your local Kenwood dealer for assistance. dealer for connectable models of disc changers/ • Press the reset button if the disc auto changer
Summary of the content on the page No. 6
Notes Cleaning the Unit About SIRIUS Satellite radio tuner If the faceplate of this unit is stained, wipe it with a Refer to the instruction manual of SIRIUS Satellite dry soft cloth such as a silicon cloth. radio tuner KTC-SR901/SR902/SR903 (optional If the faceplate is stained badly, wipe the stain off accessory), when connected, for the operation with a cloth moistened with neutral cleaner, then method. wipe neutral detergent off. • Refer to the sections of A models for operations. • Apply
Summary of the content on the page No. 7
About CDs Handling CDs Removing CDs • Don’t touch the recording surface of the CD. When removing CDs from this unit pull them out horizontally. CDs that can’t be used • CDs that aren’t round can’t be used. • CD-R and CD-RW are easier to damage than a normal music CD. Use a CD-R or a CD-RW after reading the caution items on the package etc. • Don’t stick tape etc. on the CD. • CDs with coloring on the recording surface or that Also, don’t use a CD with tape stuck on it. are dirty can’t be use
Summary of the content on the page No. 8
Notes on playing MP3/WMA (KTS-MP400MR only) KTS-MP400MR can play MP3 (MPEG1, 2 Audio When you use your CD writer to record MP3/WMA Layer 3)/WMA. Note, however, that the MP3/WMA up to the maximum disc capacity, disable additional recording media and formats acceptable are writing. For recording on an empty disc up to the limited. When writing MP3/WMA, pay attention to maximum capacity at once, check Disc at Once. the following restrictions. Acceptable media • Play mode may not be possible when
Summary of the content on the page No. 9
MP3/WMA playing order When selected for play, Folder Search, File Search, When a File Search is executed with file ¡$ or for Folder Select, files and folders are accessed being played ... in the order in which they were written by the CD Operation of writer. (Current file: ¡$) the button Because of this, the order in which they are expected to be played may not match the order in 4 Button Beginning of file ¡$ ➜ ¡# which they are actually played. You may be able to ¢ Button ¡% ➜ ¡& set t
Summary of the content on the page No. 10
General features Power Volume Turning ON the Power Increasing Volume Press the [POWER] button. Press the [u] button. Turning OFF the Power Decreasing Volume Press the [POWER] button. Press the [d] button. Attenuator Selecting the Source Turning the volume down quickly. Press the [TU/SR] button. Press the [MUTE] button. Source required Display Each time the button is pressed, the Attenuator Tuner or HD Radio (Optional accessory) "TUNER" or "HD Radio" turns ON and OFF. SIRIUS t
Summary of the content on the page No. 11
System Q Balance "Balance" Left 15 — Right 15 Fader "Fader" Rear 15 — Front 15 You can recall the best sound setting preset for Sub woofer level*1 "SW Level" –15 — +15 different types of music. Front High Pass Filter*2 "HPF F" Through/100/125/ 170 Hz 1 Select the source to set Rear High Pass Filter*2 "HPF R" Through/200 Hz Press the [TU/SR] or [CD/CH] button. Front/Rear High Pass "HPF" Through/100/125/170 Filter*3 Hz 2 Select the Sound type Sub woofer Low Pass "LPF SW" 50/80/120/THRU Hz Press
Summary of the content on the page No. 12
General features In Auxiliary input source Switching Display Information Switching the information displayed. Auxiliary input name Press the [DISP] button. Clock Each time the button is pressed the display switches as shown below. In Tuner source • * If the contents of the information cannot be displayed, Play time or Frequency is displayed. Information Display • Album name cannot be displayed in WMA file. Station name or Frequency "SNPS"* Frequency "BAND+FREQ" Clock Station/Disc Naming (SNP
Summary of the content on the page No. 13
• Memory numbers Subwoofer Output - FM: 32 stations Turning the Subwoofer output ON or OFF. - AM: 16 stations - Internal CD player: 30 discs Press the [SW] button for at least 1 second. - External CD changer/ player: Varies according to the Each time the button is pressed Subwoofer CD changer/ player. Refer to the CD changer/ player output switches ON or OFF. manual. When it’s ON, "Sub-W ON" is displayed. • The title of station/CD can be changed by the same operation used to name it. •
Summary of the content on the page No. 14
Tuner features Band display Frequency display Preset station number ST indicator Tuning Tuning Mode Selecting the station. Choose the tuning mode. Press the [AUTO] button. 1 Select tuner source Each time the button is pressed the Tuning Press the [TU/SR] button. mode switches as shown below. Select the "TUNER" display. Tuning mode Display Operation 2 Select the band Auto seek "Auto 1" Automatic search for a station. Press the [FM] or [AM] button. Preset station seek "Auto 2" Search i
Summary of the content on the page No. 15
Station Preset Memory Putting the station in the memory. 1 Select the band Press the [FM] or [AM] button. 2 Select the frequency to put in the memory Press the [4] or [¢] button. 3 Put the frequency in the memory Press the desired [1] — [6] button for at least 2 seconds. The preset number display blinks 1 time. On each band, 1 station can be put in the memory on each [1] — [6] button. Auto Memory Entry Putting stations with good reception in the memory automatically. 1 Select the band for Aut
Summary of the content on the page No. 16
CD/MP3/WMA/External disc control features Release lever Disc number Playing CD & MP3/WMA Release lever 0/3(IN) indicator • Do not use the unit with the CD door in the open condition. If it’s used in the open position water can enter the inside part and cause damage. • When a disc is inserted, the "0"/ "3"(IN) indicator is ON. CD door When a disc is inserted Press the [CD/CH] button. When there is no disc inserted Select the "CD" display. 1 Slide the Release lever. Pause and
Summary of the content on the page No. 17
Eject the disc Fast Forwarding and Reversing 1 Slide the Release lever. Fast Forwarding Pull down the CD door to open it. Hold down on the [¢] button. 2 Eject the disc Release your finger to play the disc at that point. Press the [0] button. Reversing 3 Close the CD door Hold down on the [4] button. Press the CD door in the center when closing. Release your finger to play the disc at that point. • 3 in. (8cm) disc can’t be played. Using an adapter and inserting them into this unit can cause dam
Summary of the content on the page No. 18
CD/MP3/WMA/External disc control features Track/File/Disc/Folder Repeat Random Play Replaying the song, disc in the Disc changer or Play all the songs on the disc or MP3/WMA folder MP3/WMA folder you’re listening to. in random order. Press the [REP] button. Press the [RDM] button. Each time the button is pressed the Repeat Play Each time the button is pressed Random Play switches as shown below. turns ON or OFF. When it’s ON, "Random ON" is displayed. In CD & External disc source Repeat play D
Summary of the content on the page No. 19
Function of the KTS-MP400MR Text/Title Scroll Function of MP3/WMA Scrolling the displayed CD text, or MP3/WMA text. Folder Select Press the [DISP] button for at least 1 second. Quickly selecting the folder you want to listen to. 1 Enter Folder Select mode Press the [F.SEL] button. "Select Mode" is displayed. During Select mode the folder information is displayed as shown below. Folder name display Displays the current folder name. 2 Select the folder level Press the [FM] or [AM] button. With th
Summary of the content on the page No. 20
HD Radio control features Band display Frequency display Preset station number ST indicator Tuning Selecting the station. • When you connect an HD Radio, Tuner features of the unit are disabled and switched to HD Radio tuner 1 Select HD Radio source features. A portion of the setting methods including Press the [TU/SR] button. the Tuning Mode will change. Select the "HD Radio" display. • With the HD Radio tuner, you can use the similar functions to and
