Kenwood TM-D700A, TM-D700E user manual

User manual for the device Kenwood TM-D700A, TM-D700E

Device: Kenwood TM-D700A, TM-D700E
Category: Car Stereo System
Manufacturer: Kenwood
Size: 2.68 MB
Added : 10/25/2014
Number of pages: 99
Print the manual

Download

How to use this site?

Our goal is to provide you with a quick access to the content of the user manual for Kenwood TM-D700A, TM-D700E. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Kenwood TM-D700A, TM-D700E.

For your convenience

If looking through the Kenwood TM-D700A, TM-D700E user manual directly on this website is not convenient for you, there are two possible solutions:

  • Full Screen Viewing - to easily view the user manual (without downloading it to your computer), you can use full-screen viewing mode. To start viewing the user manual Kenwood TM-D700A, TM-D700E on full screen, use the button Fullscreen.
  • Downloading to your computer - You can also download the user manual Kenwood TM-D700A, TM-D700E to your computer and keep it in your files. However, if you do not want to take up too much of your disk space, you can always download it in the future from ManualsBase.
Kenwood TM-D700A, TM-D700E User manual - Online PDF
Advertisement
« Page 1 of 99 »
Advertisement
Print version

Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Kenwood TM-D700A, TM-D700E but the selected pages only. paper.

Summaries

Below you will find previews of the content of the user manuals presented on the following pages to Kenwood TM-D700A, TM-D700E. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.

Abstracts of contents
Summary of the content on the page No. 1

INSTRUCTION MANUAL
144/440 MHz FM DUAL BANDER
TM-D700A
144/430 MHz FM DUAL BANDER
TM-D700A
144/430 MHz FM DUAL BANDER
TM-D700E
KENWOOD CORPORATION
© B62-1228-20 (K,E,M)
09 08 07 06 05 04 03 02 01

Summary of the content on the page No. 2

• Is capable of receiving packet data on one band while THANK YOU! receiving audio on the other band. We are grateful you decided to purchase this • Enhanced Programmable Memory (PM) channels KENWOOD FM transceiver. KENWOOD always store virtually entire current operating environments provides Amateur Radio products which surprise and for your quick recall. excite serious hobbyists. This transceiver is no • Contains a total of 200 memory channels to program exception. This time KENWOOD present

Summary of the content on the page No. 3

NOTICES TO THE USER PRECAUTIONS One or more of the following statements may be applicable: Please observe the following precautions to prevent fire, personal injury, and transceiver damage: FCC WARNING • When operating mobile, do not attempt to configure This equipment generates or uses radio frequency energy. Changes or your transceiver while driving because it is simply modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instru

Summary of the content on the page No. 4

CONTENTS SUPPLIED ACCESSORIES ...................................... 1 CHAPTER 4 OPERATING BASICS CONVENTIONS FOLLOWED IN THIS MANUAL....... 1 SWITCHING POWER ON/OFF ............................... 19 CHAPTER 1 PREPARATION ADJUSTING VOLUME ............................................ 19 MOBILE INSTALLATION ........................................... 2 SELECTING A BAND .............................................. 19 Main Unit Installation............................................. 2 SELECTING

Summary of the content on the page No. 5

PROGRAM SCAN ................................................... 52 STORING ODD-SPLIT REPEATER 1 FREQUENCIES....................................................... 36 Setting Scan Limits ............................................. 52 2 RECALLING A MEMORY CHANNEL ....................... 37 Using Program Scan ........................................... 53 MHz SCAN .............................................................. 53 3 CLEARING A MEMORY CHANNEL ......................... 37 NAMING A M

Summary of the content on the page No. 6

CHAPTER 16 WIRELESS REMOTE CONTROL DISPLAY DIMMER .................................................. 65 (U.S.A./ CANADA ONLY) AUTO DIMMER CHANGE ....................................... 65 PREPARATION ....................................................... 74 DISPLAY CONTRAST ADJUST ............................... 65 CONTROL OPERATION.......................................... 75 POSITIVE/ NEGATIVE REVERSAL ......................... 65 CHAPTER 17 SKY COMMAND 2 2 2 2 2 BLANKING A BAND DISPLAY .....

Summary of the content on the page No. 7

SUPPLIED ACCESSORIES CONVENTIONS FOLLOWED IN THIS MANUAL A market area code (K, E, or M4) can be found on the The writing conventions described below have been label attached to the package box. followed to simplify instructions and avoid unnecessary repetition. Accessory Part Number Quantity Microphone Instruction What to do K: MC-53DM T91-0615-XX 1 Press [KEY].e Press and releas KEY. E/ M4: MC-45 T91-0396-XX 1 DX C power cable E1 30-2111-X Press Press and hold KEY for 1 second or [KEY] (1 s).

Summary of the content on the page No. 8

PREPARATION 1 2 Position the transceiver, then insert and tighten MOBILE INSTALLATION the supplied hexagon SEMS screws and flat This transceiver asks you to install the front panel and washers. There are 2 screws and 2 washers main unit at separate positions. Select safe, convenient supplied for each side of the bracket. locations inside your vehicle that minimize danger to • Double check that all hardware is tightened to your passengers and yourself while the vehicle is in prevent vehicle vib

Summary of the content on the page No. 9

4 Position the grooves on the front panel over the n Front Panel Installation bracket tabs. 1 Assemble the mounting brackets using the 1 supplied 2 hexagon SEMS screws and 2 flat washers. • Do not completely tighten the screws in this step. Bracket tab SEMS screw 5 Slide the front panel down until its locking tab clicks. • The tab on the front panel must be completely locked 2 Peel off the paper backing from the rear of the by the bracket; otherwise vehicle vibration may bracket. cause the front

Summary of the content on the page No. 10

FIXED STATION INSTALLATION MODULAR PLUG CABLE CONNECTION When placing the main unit on such a surface as a desk Use the supplied modular plug cable to connect the front 1 top, use the supplied cushions to prevent the surface panel to the main unit. Connect the 4-pin plug to the from being scratched. Attach the 4 pieces of cushions to front panel and 6-pin plug to the main unit. the specified positions on the rear of the main unit. Note: The 6-pin plug is wider than the 4-pin plug. Note: Atta

Summary of the content on the page No. 11

2 After the cable is in place, wind heat-resistant tape DC POWER CABLE CONNECTION around the fuse holder to protect it from moisture. Tie down the full run of cable. 1 n Mobile Operation 3 To prevent the risk of short circuits, disconnect The vehicle battery must have a nominal rating of 12 V. other wiring from the negative (–) battery terminal Never connect the transceiver to a 24 V battery. Be before connecting the transceiver. sure to use a 12 V vehicle battery that has sufficient current ca

Summary of the content on the page No. 12

2 Connect the transceiver’s DC power connector to n Fixed Station Operation the connector on the DC power cable. In order to use this transceiver for fixed station 1 • Press the connectors firmly together until the locking operation, you will need a separate 13.8 V DC power tab clicks. supply that must be purchased separately. The recommended current capacity of your power supply is 12 A. 1 Connect the DC power cable to the regulated DC power supply and check that polarities are correct (Red: p

Summary of the content on the page No. 13

n Replacing Fuses ANTENNA CONNECTION If the fuse blows, determine the cause, then correct Before operating, you must first install an efficient, 1 the problem. After the problem is resolved, replace well-tuned antenna. The success of your installation will the fuse. If newly installed fuses continue to blow, depend largely on the type of antenna and its correct disconnect the power cable and contact your installation. The transceiver can give excellent results if authorized KENWOOD dealer or

Summary of the content on the page No. 14

ACCESSORY CONNECTIONS UP DC 8 V, 200 mA max. GND 1 n External Speakers STBY (PTT) GND (MIC) If you plan to use external speakers, choose MIC NC: No connection speakers with an impedance of 8 W . The external DWN speaker jacks accept a 3.5 mm (1/8") mono (2- conductor) plug. Recommended speakers include For the U.S.A./ Canada version, a microphone hanger is the SP-50B. supplied. Attach the hanger to an appropriate position using the screws included in the screw set. Microphone hanger Microphon

Summary of the content on the page No. 15

YOUR FIRST QSO YOUR FIRST QSO If you tend to discard instruction manuals along with the Switch ON the DC power supply, then 2 packaging material .....please don’t. The 7 steps given here will press the PWR switch. get you on the air in your first QSO right away. So, you can enjoy the exhilaration that comes with opening a brand new transceiver. Turn the VOL and SQL controls to approximately 9 o’clock. After trying the rig for a while, settle back in your most comfortable operating chair with

Summary of the content on the page No. 16

GETTING ACQUAINTED e e e e e M R b u o t tn FRONT PANEL Selects the Memory Recall mode {page 37}. In this Note: This section describes only the main functions of the front panel 3 controls and buttons. For the functions not described here, you will find mode you can change memory channels, using the explanations in the appropriate sections of the manual. Tuning control or Mic [UP]/ [DWN]. Also starts Memory Scan {page 50}. r r r r r T u n n ig c o n o r tl When turned, selects: • Operating f

Summary of the content on the page No. 17

!1 !1 !1 !1 !1 C T R L b u o ttn Selects the band that you can control using the front panel buttons or the microphone keys {page 17}. !2 !2 !2 !2 !2 V O L c o n r to s l B /A N D S E L b u o t tn s 3 When turned, adjusts the level of receive audio from the speaker {page 19}. Turn the left control (band A) or the right control (band B) depending on which band you want to operate. y y y y y F ( F u n c o itn b ) u o ttn When pressed, these buttons select the desired TX Allows you to select the d

Summary of the content on the page No. 18

MAIN UNIT- FRONT y y y y y R E S E T b u o ttn Press for 1 second or longer to perform Full Reset {page 41}. No confirmation message appears. Use this switch when the microcomputer and/or the memory chip malfunction because of ambient factors. 3 Note: With the transceiver power ON, do not connect cables to or remove from the front panel of the main unit. MAIN UNIT- REAR q q q q q C O M c o n n e c t o r Accepts a DB-9 female connector for connecting to a computer. See the separate manual, “S

Summary of the content on the page No. 19

t t t t t CALL key MICROPHONE y y y y y VFO key MC-53DM MC-45 u u u u u MR key 2 1 2 1 Identical to the front panel CALL, VFO and MR DWN UP buttons. These keys can be reprogrammed, if 3 3 7 7 8 8 desired {page 62}. 3 MIC 5 5 i i i i i PF key CALL VFO MR PF LOCK 6 Depending on which function you select in Menu 1–8–1 6 ELECTRET CONDENSER MIC MADE IN JAPAN 4 4 (PF1), the function of this key differs. Refer to “PROGRAMMABLE FUNCTION (PF) KEYS” {page 62}. o o o o o DTMF keypad (MC-53DM only) The

Summary of the content on the page No. 20

INDICATORS What You What You Press to Ref. Indicator Selected Cancel Page On the display you will see various indicators that show Locked-out what you have selected. memoryU1 se Menu 1–4–3. 5 channel What You What You Press to Ref. 3 Indicator Selected Cancel Page Auto Band [F], [A.B.C.] 66 [TONE], [TONE], Change Tone function 30 [TONE] Transceiver [F], [MHz] 67 Lock CTCSS [TONE], [TONE] 55 [MHz]+ POWER DCS [TONE] 57 All-control Lock 67 ON, then [F], [MHz] [F], [SHIFT], [F], Speaker Mute [MUTE]


Alternative user manuals
# User manual Category Download
1 Kenwood 25th Anniversary Products XXV-03A User manual Car Stereo System 60
2 Kenwood CarPortal KOS-L432 User manual Car Stereo System 3
3 Kenwood CASSETTE RECEIVER KRC-PS978R User manual Car Stereo System 4
4 Kenwood ADVANCED INTEGRATION A/V CONTROLLER KOS-V500 User manual Car Stereo System 3
5 Kenwood CD-RECEIVER KDC-126 User manual Car Stereo System 14
6 Kenwood CD-RECEIVER KDC-2026 User manual Car Stereo System 5
7 Kenwood CD-RECEIVER KDC-226 User manual Car Stereo System 41
8 Kenwood AMPED XR-S17P User manual Car Stereo System 6
9 Kenwood CD-RECEIVER KDC-5070R User manual Car Stereo System 27
10 Kenwood CASSETTE RECEIVER KRC-878R User manual Car Stereo System 17
11 Kenwood CASSETTE RECEIVER KRC-778RV User manual Car Stereo System 26
12 Kenwood B64-1627-00 User manual Car Stereo System 21
13 Kenwood CD RECEIVER KDC-4060RG User manual Car Stereo System 11
14 Kenwood CD-RECEIVER KDC-W6031 User manual Car Stereo System 48
15 Kenwood CASSETTE RECEIVER B64-1612-00 (EN) User manual Car Stereo System 9
16 Sony Bluetooth 4-158-429-31(1) User manual Car Stereo System 14
17 Sony CDX GT430IP User manual Car Stereo System 23
18 Sony Bluetooth 3-299-319-12 (1) User manual Car Stereo System 22
19 Sony CDX 757MX User manual Car Stereo System 38
20 Sony CDX GT54UIW User manual Car Stereo System 55