Summary of the content on the page No. 1
Rugged Case - Chalice .fm Page 1 Monday, March 19, 2007 10:09 AM
Fujitsu Computer Systems Corporation
Rugged Tablet Case
User’s Guide
INSTRUCTIONS
These instructions provide details on using the rugged
tablet case with your Fujitsu LifeBook notebook when
it is in tablet mode. The case provides added protec-
tion when transporting, using, or storing the note-
book.
We recommend that you read these instructions prior
to using the case with your computer.
Package Contents
Included in the pa
Summary of the content on the page No. 2
Rugged Case - Chalice .fm Page 2 Monday, March 19, 2007 10:09 AM D-rings Pen Holder* (2 places} Built-in microphone access Fingerprint sensor access Port/slot access System status/ Application power/suspend/ button access resume button access Figure 1. Rugged tablet case - Front The pen which came with the system is too small to fit snugly in the pen slot, so a full-size pen is included with the case. The pen holder on the top front of the case should be used to store the pen. When the
Summary of the content on the page No. 3
Rugged Case - Chalice .fm Page 3 Monday, March 19, 2007 10:09 AM Case handle PC Card access Hand strap slots Figure 2. Rugged tablet case - back Installing the hand strap The hand strap is designed to let you hold your system securely when it is installed in the case. Use of the hand strap is highly recommended. The hand strap consists of two parts, each of which has a Velcro strip on one end and a retaining bar at the other. Note that the longer of the two strips (with the “fuzzy” Vel
Summary of the content on the page No. 4
Rugged Case - Chalice .fm Page 4 Monday, March 19, 2007 10:09 AM 2. Insert the shorter of the two pieces of the hand strap into the bottom slots with the Velcro “hooks” strip fac- ing up. (Figure 3) Pull it through until the retaining bar is snug against the case. Retaining bar Retaining bar Longer Velcro strip (“fuzzy” side facing Shorter Velcro strip down) (“hooks” facing up) Figure 3. Inserting hand strap halves 3. Insert the longer piece of the hand strap into the top slot with the
Summary of the content on the page No. 5
Rugged Case - Chalice .fm Page 5 Monday, March 19, 2007 10:09 AM Installing the system To install your system into the rugged tablet case, perform the following steps: 1. Position the case face down (the same orientation as when you installed the hand strap). 2. Position the system in tablet mode with the display fac- ing down, and hold it by the edge opposite the battery. Battery Rigid edge Figure 4. Inserting the system in the case 3. Insert the battery edge of the system into the wide,
Summary of the content on the page No. 6
Rugged Case - Chalice .fm Page 6 Monday, March 19, 2007 10:09 AM Flexible edge Figure 5. Enclosing the system Figure 6. System in case 6
Summary of the content on the page No. 7
Rugged Case - Chalice .fm Page 7 Monday, March 19, 2007 10:09 AM Using the hand strap When you want to hold the case using the elastic hand strap, first separate the two halves. Place your hand in a comfort- able position on the bottom of the system and re-secure the strap against the back of your hand. When not using the hand strap, attach it snugly against the back of the computer. Installing the handle To install the handle, perform the following steps: 1. Insert one end of the handle
Summary of the content on the page No. 8
Rugged Case - Chalice .fm Page 8 Monday, March 19, 2007 10:09 AM 5. Repeat the procedure above with the other end of the handle. Figure 8. Inserting strap into buckle. Figure 9. Pulling strap through buckle 8
Summary of the content on the page No. 9
Rugged Case - Chalice .fm Page 9 Monday, March 19, 2007 10:09 AM Figure 10. Tightening the strap Installing the shoulder strap To install the shoulder strap, open the spring-loaded clips on both ends and attach one to each of the D-rings (Figure 11). Figure 11. Installing the shoulder strap 9
Summary of the content on the page No. 10
Rugged Case - Chalice .fm Page 10 Monday, March 19, 2007 10:09 AM Installing the pen tether To install the pen tether, insert one end into one of the D- rings, then feed it through the loop on the other end. Pull it snug against the D-ring. Feed the loose end of the tether through the hole on the end of the pen, slide the loop over the tip of the pen, then down the barrel. Pull it snugly to tighten the loop. Caring for the rugged tablet case The case is made of rugged materials, and is d
Summary of the content on the page No. 11
Rugged Case - Chalice .fm Page 11 Monday, March 19, 2007 10:09 AM 11
Summary of the content on the page No. 12
Rugged Case - Chalice .fm Page 12 Monday, March 19, 2007 10:09 AM 1250 E. Arques Avenue (M/S 122), Sunnyvale, California 94085 For more information, call 1-877-372-3473 or visit our Web site at: us.fujitsu.com/computers For technical support call: 1-800-8fujitsu (1-800-838-5487) or e-mail us at: 8fujitsu@us.fujitsu.com Fujitsu, the Fujitsu logo, and LifeBook are registered trademarks of Fujitsu, Ltd. All other trademarks mentioned herein are the property of their respec- tive owners. Produ
