Summary of the content on the page No. 1
Operating and Installation
Instructions
Ventilation System
DA 289-4
To prevent accidents en - US, CA
and machine damage,
read these instructions
before
installation or use. M.-Nr. 06 713 760
Summary of the content on the page No. 2
Contents IMPORTANT SAFETY INSTRUCTIONS Functional description Guide to the hood Operation Turning on the fan .................................................10 Selecting the power level............................................10 Delayed Shut Down................................................12 Turning off the fan .................................................12 Turning the lighting on/off ...........................................13 Dimming the lighting ................................
Summary of the content on the page No. 3
IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is designed to vent ~ This appliance is intended for cooking smoke and odors only. residential use only. Use the Be certain your appliance is ~ appliance only for its intended properly installed and grounded by a purpose. The manufacturer cannot qualified technician. be held responsible for damages To guarantee the electrical safety of this caused by imprope
Summary of the content on the page No. 4
IMPORTANT SAFETY INSTRUCTIONS This equipment is not designed for Use ~ maritime use or for use in mobile Do not allow children to play with or ~ installations such as recreational operate the appliance or its controls. vehicles or aircraft. However, under Supervise its use by the elderly or certain conditions it may be possible for infirm. an installation in these applications. Please contact the nearest Miele dealer Do not flambé or grill with an open ~ or the Miele Technical Service flame bene
Summary of the content on the page No. 5
IMPORTANT SAFETY INSTRUCTIONS , WARNING - TO REDUCE , WARNING TO REDUCE THE RISK OF INJURY THE RISK OF A COOKTOP TO PERSONS IN THE EVENT OF A GREASE FIRE: RANGE TOP GREASE FIRE, Never leave surface units ~ OBSERVE THE FOLLOWING: unattended at high settings. Boilovers SMOTHER FLAMES with a close ~ cause smoking and greasy spillovers fitting lid, cookie sheet, or metal tray may ignite. Heat oils slowly on low or then turn off the burner. medium settings. BE CAREFUL TO PREVENT BURNS. Always turn th
Summary of the content on the page No. 6
IMPORTANT SAFETY INSTRUCTIONS Installation Any fittings, sealant, or materials ~ used to install the ductwork must be , WARNING ~ made of approved non-flammable To reduce the risk of fire only use materials. metal ductwork. Never connect an exhaust hood to ~ Provided a larger distance is not ~ an active chimney, dryer vent, vent flue, given by the manufacturer of the or room ventilating ductwork. Seek cooktop, follow the recommended professional advice before connecting minimum safety distances
Summary of the content on the page No. 7
Functional description The ventilation hood works by air extraction. The air is drawn in and cleaned by the grease filter and directed outside. The hood comes equipped with a non-return flap. This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur. When the hood is turned on, the air pressure of the exhaust fan automatically opens the flap blowing the inside air and cooking odors outside. 7
Summary of the content on the page No. 8
Guide to the hood 8
Summary of the content on the page No. 9
Guide to the hood a Chimney extension h Light button This button dims the light or turns it on b Chimney and off. The lighting can be used independently c Canopy of the fan. d Control panel i On/Off button e Overhead lighting j Fan power selection Four fan speed selection f Grease filter k Delayed Shut Down g Air intake panel This button activates the Delayed Shut Down feature. The fan can be set to turn off automatically after either 5 or 15 minutes. l Grease filter button The indicator next th
Summary of the content on the page No. 10
Operation Turning on the fan Automatically switching back the intensive power level The intensive level "4" can be programmed to automatically switch back to level "3" after 10 minutes. ^ Press the On/Off button. ^ Turn the fan and the lights off. ^ Press and hold the "Delay Shut down" Selecting the power level button for 10 secs. The first indicator lights. ^ Use the "–/+" controls to select the desired power level. ^ Press the following buttons one after + = increases the fan speed another, –
Summary of the content on the page No. 11
Operation Fan performance The maximum air flow capacity is 625 cfm. Factors such as narrow duct diameter and bends will affect this If the power level indicators "1" and "4" value. flash the automatic switch back is not Level 1 operates at 40% capacity activated. Level 2 operates at 60% capacity ^ To activate the automatic switch back Level 3 operates at 80% capacity press the "+" button. Level 4 operates at 100% capacity The power level indicators "1" and "4" light continuously. ^ To save the s
Summary of the content on the page No. 12
Operation Delayed Shut Down Turning off the fan If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. ^ Press the On/Off button to turn the fan off. The indicator goes out. Automatic Safety Shut Off ^ Press the Delayed Shut Down button The fan will turn off automatically 10 while the fan is still running. hours after the last button was activated. Press once = 5 min
Summary of the content on the page No. 13
Operation Turning the lighting on/off Dimming the lighting The overhead lighting can be turned on The brightness of the lighting can be and off independently of the fan. adjusted. ^ While the lighting is turned on, press the light button. The lighting will dim until the button is released. ^ Press the light button briefly to turn ^ If the button is pressed again, the on the lighting. lighting will brighten until the button is The light button indicator illuminates. released. ^ Press the light bu
Summary of the content on the page No. 14
Operation Grease filter timer Checking the grease filter timer A timer monitors the hours of fan To check the percentage of time operation. The indicator for the grease already used: filter will light after 30 hours of operation. The grease filter and air intake panel must then be cleaned. After the grease filter has been cleaned ^ Press the On/Off button to turn the and put in place, the grease filter timer fan on. must be reset. ^ Press the grease filter button. ^ To do this, press the grease
Summary of the content on the page No. 15
Operation Reprogramming the grease filter timer The grease filter timer is preset to 30 hours. This time can be lengthened or The indicator for the grease filter and shortened to 20, 30, 40 or 50 hours. one of the "–/+" indicators will flash. – A time of 20 hours should be The lit "–/+" indicator shows the programmed in kitchens with programmed time: frequent pan or deep frying. 1st indicator from the left = 20 hours – A time of 20 hours should also be 2nd indicator from the left = 30 hours prog
Summary of the content on the page No. 16
Cleaning and care Stainless steel Before cleaning or servicing the Stainless steel surfaces can be cleaned hood, disconnect it from the power using a non-abrasive stainless steel supply by either removing the fuse, cleaner. unplugging it from the outlet or manually "tripping" the circuit To help prevent resoiling, a conditioner breaker. for stainless steel can also be used. Apply sparingly with even pressure. Cleaning the casing Stainless steel colored controls ,Never use abrasive cleaners, Thes
Summary of the content on the page No. 17
Cleaning and care Grease filter and air intake Removing the air intake panel panel The reusable metal grease filter removes solid particles from the vented kitchen air (grease, dust, etc). The grease filter and the air intake panel should be cleaned every3-4 weeks or whenever the grease filter ^ To remove the air intake panel gently indicator lights. pull out and downward, shifting the lower part a bit to the right. Lift it out Keep the grease filter clean to of the latches. prevent a fire hazar
Summary of the content on the page No. 18
Cleaning and care Cleaning the grease filters ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays or limescale removers. They could destroy the filters. ^ In a dishwasher: place the filters vertically in the lower basket, making sure that the spray arm is not blocked. ^ Push the grease filter back in place. Use a hot temperature program, e.g. "Heavy Soil" or "Pots and pans". ^ Hook the air inta
Summary of the content on the page No. 19
Cleaning and care Changing the light bulbs Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, and they can burn your hands. Do not attempt to change the bulbs until they have had sufficient time to cool. ^ Pull the old bulb out of its socket using the enclosed lever. Replace it Do not touch the bulb surface. with a new one. Be careful not
Summary of the content on the page No. 20
After Sales Service Repairs MieleCare In the event of a fault which you cannot MieleCare, our Extended Service easily fix yourself, please contact the Contract program, gives you the Miele Technical Service Department. assurance of knowing that your appliance investment is covered by ^ When contacting the Technical 5 years of worry free ownership. Service Department, please quote MieleCare is the only Extended Service the model and serial number of your Contract in the industry that guarantees a
