Summary of the content on the page No. 1
Culligan Water
Tower™
Drinking Water
System Owners
Guide
Summary of the content on the page No. 2
NOTICE: This system is intended for use on potable water supplies or disinfected water containing Culligan Water cysts. Do not use where water is microbiologically unsafe or with water of unknown quality without Tower™ adequate disinfection before or after the system. Systems certified for cyst reduction may be used CWT35ST.3.0 on disinfected water that may contain filterable cysts. 2
Summary of the content on the page No. 3
Safety/Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Table of Contents System Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Introduction About Your System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 System Component Description . . . . . . . . . . . . . . . . . . . . . . . . . .5 Application Guidelines . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Certified
Summary of the content on the page No. 4
System Flow Sequences . . . . . . . . . . . . . . . . . .Sediment Filter, Activated Carbon Filter, Reverse System Osmosis Membrane, Storage Tank, Polishing Filter, Specifications Dispensing Faucet. Sediment Filter . . . . . . . . . . . . . . . . . . . . . . . . .Spun Polypropylene Type Carbon Filter . . . . . . . . . . . . . . . . . . . . . . . . . .Activated Carbon Block Reverse Osmosis Membrane . . . . . . . . . . . . . . .Thin Film Composite Type 3 Gallon 1 System DPR* to Storage Tank 11.0 (4
Summary of the content on the page No. 5
Thank you for choosing a Culligan Water Tower™ drinking water system. Your new system is Introduction ® designed to bring you years of healthful, deliciously crystal-clear Culligan water. With its special faucet installed on your sink, it’s like getting bottled water straight from your kitchen tap. With the Culligan Water Tower drinking water system, you’ll get a continuous supply of clear, refreshing water for drinking and cooking. But Culligan improves a lot more than just water. Crystal clear
Summary of the content on the page No. 6
Polishing Filter The Culligan Water Tower™ drinking water system includes a second activated carbon filter in the manifold as added assurance that your water will be crystal clear. ® ® Culligan Smartap Water Quality Monitor and Faucet The special drinking water faucet mounts conveniently on your kitchen sink. A simple twist of the handle is all it takes to enjoy refreshing Culligan drinking water. ® Your Culligan Water Tower incorporates a proven performance indicator. The patented Smartap Water
Summary of the content on the page No. 7
Influent Water Characteristics 1 Pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .35-100 psi (242-690 kPa) Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40-100°F (4-38°C) 2 Total Dissolved Solids (TDS) . . . . . . . . . . . . . . . . . . . . . . . .0-2000 ppm (0-2000 mg/L) pH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3.0 - 11.0 3 Chlorine . . . . . . . . . . . .
Summary of the content on the page No. 8
This Owner’s Guide provides visual assembly reference only (Figure 2). Since specialized skills are Installation required in the assembly of the drinking water system, we recommend that you contact your local ® independently operated Culligan dealer to complete this installation. Component Location Product Water Faucet Faucet may be located in any convenient location. Make sure underside of location is free of obstruc- tion. ™ Culligan Water Tower Module* Module may be installed under sink or in
Summary of the content on the page No. 9
Service Schedule Servicing your When properly maintained, your Culligan Water Tower™ drinking water system will give you years of system dependable service. This reverse osmosis system contains a replaceable treatment component, criti- cal for the effective reduction of total dissolved solids. The product water should be tested periodi- cally to verify the system is performing properly. Use the following as a guide to get the most out of your system. Service frequency may vary depending on your
Summary of the content on the page No. 10
If you wish to service your system, the filters are available from your Culligan dealer. To locate your nearest Culligan dealer, call (800) 285-5442, or visit our website at www.culligan.com. See the Parts List at the end of this section for replacement numbers. Cartridge Conditioning The activated carbon, reverse osmosis, and polishing filter cartridges must be conditioned as follows prior to installation into the Culligan Water Tower™ drinking water system. Your Culligan Man™ can do these impo
Summary of the content on the page No. 11
Note: Use hand pump to avoid damaging tank. Verify product water faucet is open before pro - ceeding. Use caution when working with/inside enclosure. Wiring therein connects monitor com - ponents. If wires, circuit board, or connections are damaged and/or wetted, monitor will not function. Item callouts refer to Figure 5 unless otherwise noted. 4. Remove enclosure front panel by pressing in push-in tabs and pull cover back. (Figure 4) Figure 4 5. Remove each filter housing (Item 30) by turning i
Summary of the content on the page No. 12
Figure 5 12. Place a small amount of O-ring lubricant on surface of filter housing O-ring. Install O-ring into housing. TO SANITIZE THE SYSTEM: Complete Steps 13-33. TO INSTALL FILTERS: Complete Steps 20-33. CAUTION: Wear safety glasses while performing this procedure. CAUTION: Read “WARNINGS” information on bleach container before using con- tents. Handle sanitizing solution carefully. Avoid contact with unprotected areas. 13. Mix sanitizing solution of 1.5 ml (1/3 teaspoon) of household bleac
Summary of the content on the page No. 13
Note: Tighten filter housings by hand only. Do not use tools as they will over-tighten and dam - age housings. 15. Slowly open source water supply valve. 16. Close product water faucet as soon as water begins to flow from spout. 17. Wait 5 minutes, then close source water supply valve. 18. Wait 25 minutes, then open product water faucet. Let water flow to drain until system is drained (flow stops), then close faucet. Note: Remove filter housings only after water flow stops. 19. Remove filter hou
Summary of the content on the page No. 14
TO RE-SET MONITOR or TO CHANGE BATTERY: Perform Steps 24-27 Refer to Figure 6 for component location. Use caution when working inside enclosure. Wiring therein connects monitor components. If wires, circuit board, or connections are damaged and/or wetted, monitor will not function. Connect battery to monitor after system has been in production mode for at least 5 minutes. This ensures sensing switch is in proper position to record data. 24. Disconnect battery. The connection is a snap type conne
Summary of the content on the page No. 15
30. Open product water faucet. Let water flow until all air has been expelled from the system. 31. Close product water faucet. Wait 30 minutes, check connections for leaks, and correct if neces- sary. Icemaker/Extra point of use: Check lines for leaks. 32. Allow storage tank to fill overnight. DO NOT USE FIRST FULL STORAGE TANK OF WATER 33. Discard (to drain) first full tank of water by opening product water faucet until water flow stops, then close faucet. This flushes sanitizing solution from
Summary of the content on the page No. 16
Troubleshooting Water Volume and Quality Guide Symptom Condition Action No product water Water supply is turned OFF Turn water ON Not enough Low water pressure Check source water line pressure product water Inlet water supply valve is blocked Clear restriction Storage tank valve is closed Open storage tank valve Storage tank is depleted Increase product water storage capacity and/or install membrane with higher output rating Clogged pre-filter cartridge(s) Replace pre-filter cartridge(s) Storage
Summary of the content on the page No. 17
Leakage Symptom Probable Cause Solution Leak at fitting Tubing not pushed completely Push tube into fitting past into fitting O-ring seal Defective tube Cut damaged area from tube or replace tube Tubing makes too tight a bend Run the tubing to reduce the bend near fitting Leak at filter O-ring has not seated properly Remove O-ring and inspect housings O-ring groove for debris. Clean groove, lube and reseat O-ring O-ring has nicks or scratches Replace O-ring Leak from air gap Restricted drain tub
Summary of the content on the page No. 18
Parts List Item Description Part No. 1 Culligan Faucet, Chrome body/spout 11403430 Culligan Faucet, White body/spout 11403431 Culligan Faucet, Almond body/spout 11403433 Culligan Faucet, Black body/spout 11403434 Culligan Faucet, Satin body/spout 11403436 Culligan Faucet, Black body/Polished spout 11403439 2 Battery, 9-volt alkaline 31300001 4 Bracket, Mounting 21100101 5 Screw, Mounting Bracket 32701002 6 Flow Control, Green Tape 40600037 ® 7 Cartridge, Sediment Culligan 01013028 ® 8 Cartridge,
Summary of the content on the page No. 19
Culligan Water Tower™ Service Log Service Log Model Serial No. Date Installed ( ) - For Service Call Culligan at: Cartridge(s) Changed Activated Activated Date Sediment Pre-Carbon RO Post-Carbon Serviced Filter Filter Membrane Filter Sanitized 19
Summary of the content on the page No. 20
Arsenic (abbreviated As) is found naturally in some well water. Arsenic in water has no color, taste or Arsenic Fact Sheet odor. It must be measured by a lab test. Public water utilities must have their water tested for arsenic. You can get the results from your water utility. If you have your own well, you can have the water tested. The local health department or the state environmental health agency can provide a list of certified labs. The cost is typically $15 - $30. Information about arseni
