Summary of the content on the page No. 1
Kit No. 08E51-SHJ-100
08E55-SHJ-100
Security System Owner’s Manual
© 2004 American Honda Motor Co., Inc. - All Rights Reserved. 1
ODYSSEY
Summary of the content on the page No. 2
Contents Introduction ..................................................... 3 Arming Emergency Disarming Arming Methods ...................................... 10 During the Panic Alarm Activation ............ 4 Manual Arming (Remote Controlled) ...... 10 During the Entry Delay Time ..................... 4 Automatic Arming (Passive).................... 11 System Controls Alarm Mode Arming Mode (MANUAL AUTOMATIC). 5 Alarm Triggered Mode ............................. 13 Arming Mode (AUTOMATIC MAN
Summary of the content on the page No. 3
Introduction Congratulations on your purchase of this Honda Security System. Due to the expertise required to properly install the Honda Security Your Honda Security System is the product of years of research and System, we highly recommend that the installation be performed by development. It will give you many years of reliable performance, your Honda dealer. Proper wiring and component placement are protection, and convenience. essential for optimum system performance. The system consists of
Summary of the content on the page No. 4
Emergency Disarming The system can be disarmed using the ignition key regardless of the method used to arm During the Panic the system. This method of disarming also serves as an emergency override if the remote control Alarm Activation transmitter cannot be used. Enter the vehicle and insert the ignition key. 1 Turn the ignition key to the ON (II) position. 2 ON The system stops the panic alarming when the ignition key is turned to the ON (II) position. Check to see the status LED goes off.
Summary of the content on the page No. 5
System Controls This section explains how to change the arming mode from MANUAL to AUTOMATIC. Arming Mode NOTE: The arming mode of the Security System is preset to MANUAL arming. (MANUAL AUTOMATIC) NOTE: Steps 1 thru 5 must be completed within 5 seconds. Insert the ignition key. 1 Remove the ignition key from the ignition switch. (All the way out) 2 Insert the ignition key. 3 Remove the ignition key from the ignition switch. (All the way out) 4 Insert the ignition key. 5 The switching procedure
Summary of the content on the page No. 6
System Controls This section explains how to change the arming mode from AUTOMATIC to MANUAL. Arming Mode (AUTOMATIC MANUAL) ON Turn the ignition key from the ON (II) position to the LOCK (0) position. 1 Remove the key from the ignition switch. LOCK Status Open a door or the tailgate and close it. (The EXIT delay starts.) LED 2 Check that the status LED blinks. 4625030B 4625051B NOTE: Steps 3 thru 7 must be completed within 5 seconds. Insert the ignition key. 3 Remove the ignition key from the
Summary of the content on the page No. 7
Valet When the security system is placed in the valet mode, it is temporarily Placing the System in the Valet Mode placed on hold. When in the valet mode, the system cannot be armed, but panic mode is still functional. This is a convenient feature if the car (Valet Mode can be changed only from is to be washed, serviced, or valet parked. Before removing the ignition key, opening/closing of the door or Automatic Arming Mode) tailgate is not related to set valet mode. NOTE: Steps 1 and 2 must
Summary of the content on the page No. 8
Valet If you follow either procedure below, the Status LED blinks once to show In the Valet Mode: the system is in the Valet mode. Status Open one of the doors or the tailgate. LED The Status LED blinks once. 4625051B 4625060B Status After turning the ignition switch to LOCK (0), remove the ignition key. LED The Status LED blinks once. 4625051B Keyless/Security during the Valet Mode. Lock/Unlock of Keyless Panic of Keyless Arming/Disarming of Security VALET MODE is ON Active Active Non-Active VA
Summary of the content on the page No. 9
Valet Exit From the Valet Mode With the system in the Valet mode, take the key out of the ignition switch. 1 Press the UNLOCK button on the remote control transmitter. 2 2 Observe that the Status LED flashes twice, indicating that the system is out of the Valet mode. 3 The system is now in the Disarm mode. 4625051B 3 Status LED © 2004 American Honda Motor Co., Inc. - All Rights Reserved. 9
Summary of the content on the page No. 10
Arming There are two possible ways to arm the system: Arming Methods MANUAL Arming (Remote Control) AUTOMATIC Arming (Passive) When the main unit is set to MANUAL, the system is armed by using the remote control Manual Arming transmitter. This is the factory setting. The system beeps three times. It does not arm itself unless any door or the tailgate is (Remote Controlled) closed when the LOCK button is pressed. Make sure the arming mode is set to MANUAL. 1 Turn the ignition key to the
Summary of the content on the page No. 11
Arming When the main unit is set to AUTOMATIC, the system arms automatically 20 seconds after the last door or the tailgate is closed*. Automatic Arming If a door or the tailgate is opened during the 20 seconds exit delay time, the timer resets and the 20 seconds exit delay time restarts after the last door or the tailgate is closed. (Passive) If the ignition key is inserted into the ignition switch during the exit delay time, the system will (Arms the security system without be disarmed.
Summary of the content on the page No. 12
Arming Exit the vehicle, and close all the doors and the tailgate. 4625030B The system arms automatically 20 seconds after the last door or the tailgate is closed. Observe 4 that: The status LED flashes four times per second during the exit delay time, and once per 3 20-sec exit delay time seconds after the system is armed. (Be sure to check that the status LED flashes.) The parking lights flash once without a beep to confirm the system is armed. (Be sure to check that the lights flash.) NOT
Summary of the content on the page No. 13
Alarm Mode After the system is armed, opening of any door or the tailgate, or breaking of window glass will trigger the alarm. Alarm Triggered Mode If the door or tailgate is kept open, the alarm will continue to sound for 5 minutes. If the battery is disconnected in the alarm mode, any attempt to reconnect the battery will send the alarm into the triggered mode. When the alarm is triggered, observe that: 1 The horn sounds once per 1.5 seconds for one alarm duration (horn duration is 30
Summary of the content on the page No. 14
Disarming Regardless of the method used to arm the system, the system can be disarmed using the Remote Control remote control transmitter. Disarming Press the UNLOCK button once on the remote 1 control transmitter. Observe that: The remote control LED illuminates. The security system disarms and the parking lights flash twice when the alarm has not been triggered. If the alarm has been triggered, the horn sounds four times to tell you the alarm has been triggered. The doors and tailgate
Summary of the content on the page No. 15
Tripped Sensor Warning and Indication The system will warn you that the security system has been tripped in your absence. Tripped Sensor Warning If the system was tripped and automatically rearmed, observe that: 1 The horn sounds four times when the system is disarmed. 4625020B © 2004 American Honda Motor Co., Inc. - All Rights Reserved. 15
Summary of the content on the page No. 16
Tripped Sensor Warning and Indication After disarming the system, if the tripped sensor warning indicator appears, you can Tripped Sensor Indication identify which portion of the security system has been tripped by observing the number of flashes as shown below. Information regarding the security system can be retrieved from the memory of the systems main control unit. Disarm the security system. 1 Close the door and tailgate. Insert the ignition key. 2 Within 1 second after step 2, open a d
Summary of the content on the page No. 17
Glossary Description The amount of time the horn sounds when the alarm is tripped or the panic feature is ALARM DURATION activated. The duration is 30 seconds. To turn the security system’s protection on. ARM The optional mode in which the security system is armed automatically (passively) after all the * AUTOMATIC ARMING doors and the tailgate are closed. The doors and tailgate do not lock when the system is armed. The mode in which the system is armed and disarmed by the remote control transm
Summary of the content on the page No. 18
Glossary Description If a door or the tailgate is opened during the exit delay time, the timer will reset and restart the EXTENDED EXIT ARMING countdown procedure when the specific door or the tailgate is closed. A mode in which the horn and lights are intentionally activated. PANIC Useful for attracting attention in case of an emergency. A feature that cancels (ignores) a particular sensor that has caused the alarm to be SENSOR CANCELLATION tripped consecutively for 5 minutes. A feature that in
Summary of the content on the page No. 19
Specifications Main Unit Design ................................................................................................... Microprocessor, all solid state Operating Voltage ............................................................................... 13 V DC (8 V to 16 V allowable) Current Consumption (Arming) ....................................................................................................2 mA Operating Temperature ..................................................
Summary of the content on the page No. 20
20 08E55-SHJ-1000-81 © 2004 American Honda Motor Co., Inc - All Rights Reserved. © 2004 American Honda Motor Co., Inc. - All Rights Reser Printed in Japan ved.
