Curtis RCD824 user manual

Summary of the content on the page No. 1

CD PLAYER WITH TURNTABLE ANDSTEREO RADIO RECEIVER



















RCD824



INSTRUCTION MANUAL

Summary of the content on the page No. 2

GRAPHICAL SYMBOLS EXPLANATION AND OUTDOOR USE OR WET LOCATION WARNING THE OPERATING INSTRUCTION SHALL ACCOMPANY THE ILLUSTRATION OF THE GRAPHICAL SYMBOLS MARKED ON THE APPLIANCE, AND AN EXPLANATION OF THEIR MEANING.

Summary of the content on the page No. 3

IMPORTANT SAFETY INSTRUCTIONS 1. READ THESE INSTRUCTIONS 2. KEEP THESE INSTRUCTIONS 3. HEED ALL WARNINGS 4. FOLLOW ALL INSTRUCTIONS 5. DO NOT USE THIS APPARATUS NEAR WATER 6. CLEAN ONLY WITH A DRY CLOTH 7. DO NOT BLOCK ANY OF THE VENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH THE MANUFACTURERS INSTRUCTIONS 8. DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOVES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT. 9. DO NOT DEFEAT THE SAFETY PURPO

Summary of the content on the page No. 4

LOCATION OF CONTROLS 1) DUST COVER 2) DIAL POINTER 3) LEFT SPEAKER 4) LED DISPLAY 5) MEMORY LED INDICATOR 6) REMOTE SENSOR 7) FM STEREO LED INDICATOR 8) CD DOOR 9) VOLUME KNOB 10) X-BASS CONTROL BUTTON 11) PROGRAM BUTTON 12) REPEAT BUTTON 13) RIGHT SPEAKER 14) TUNING KNOB 15) CD DOOR OPEN BUTTON 16) CD STOP BUTTON 17) RADIO BAND SELECTOR 18) FUNCTION SELECTOR 19) 3.5MM STEREO HEADPHONE JACK 20) CD PLAY/PAUSE BUTTON 21) CD SKIP UP BUTTON 22) CD SKIP DOWN BUTTON 23) SPIND

Summary of the content on the page No. 5

FM & FM-STEREO RECEPTION SET THE RADIO BAND SELECTOR AT “ FM ” POSITION. PROGRAMS ARE RECEIVED IN MONO MODE. IN PARTICULAR WHEN STEREO SIGNAL ARE WEAK. IT IS PREFERABLE TO RECEIVE THE PROGRAM IN MONO. SET THE RADIO BAND SELECTOR AT “FM-ST” POSITION FOR RECEIVING STEREO PROGRAMS. THE FM-STEREO LED INDICATOR WILL LIGHT UP TO SHOW FM STEREO PROGRAM IS RECEIVING. HINTS FOR BEST RECEPTION:- - AM : THE RECEIVER HAS A BUILT-IN AM BAR ANTENNA. IF AM RECECPTION IS WEAK, SLIGHTLY ROTATE OR R

Summary of the content on the page No. 6

PHONO NOTED: - REMOVE THE STYLUS PROTECTOR. - BE SURE THAT THE TONE ARM IS BEING DETACHED FROM THE TONE ARM REST BEFORE OPERATING AND RE-SECURED AGAIN AFTERWARDS. 1. SELECT TO “ PHONO ” FUNCTION. 2. SET THE SPEED SELECTOR TO THE PROPER POSITION DEPENDING ON THE RECORD TO BE PLAYED. 3. PLACE THE RECORD ON THE PLATTER (USE THE SPINDLE ADAPTOR IF REQUIRED). 4. LIFT THE TONE ARM FROM THE REST AND SLOWLY MOVE IT TO THE RECORD SIDE. THE PLATTER WILL START TO ROTATE. 5. PLACE THE TONE ARM