Our goal is to provide you with a quick access to the content of the user manual for Zanussi ZBB2294L. Using the online preview, you can quickly view the contents and go to the page where you will find the solution to your problem with Zanussi ZBB2294L.
If looking through the Zanussi ZBB2294L user manual directly on this website is not convenient for you, there are two possible solutions:
Many people prefer to read the documents not on the screen, but in the printed version. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. You do not have to print the entire manual Zanussi ZBB2294L but the selected pages only. paper.
Below you will find previews of the content of the user manuals presented on the following pages to Zanussi ZBB2294L. If you want to quickly view the content of pages found on the following pages of the manual, you can use them.
EN User manual
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Helpful hints and tips _ _ _ _ _ _
or damaged power plug may overheat and cause a Care and cleaning fire. • Before maintenance, switch off the appliance and dis- 3. Make sure that you can come to the mains plug of connect the mains plug from the mains socket. the appliance. • Do not clean the appliance with metal objects. 4. Do not pull the mains cable. • Do not use sharp objects to remove frost from the ap- 5. If the power plug socket is loose, do not insert the pliance. Use a plastic scraper. power plug. There is a risk of elec
Environment Protection insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations This appliance does not contain gasses which could to obtain from your local authorities. Avoid damaging the damage the ozone layer, in either its refrigerant cir- cooling unit, especially at the rear near the heat exchang- cuit or insulation materials. The appliance shall not be er. The materials used on this appliance marked by the discarded together with the
Important! In the event of accidental defrosting, for Important! Do not use metallic instruments to remove the example due to a power failure, if the power has been off trays from the freezer. for longer that the value shown in the technical Movable shelves characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately The walls of the refrigera- and then re-frozen (after cooling). tor are equipped with a Frozen Food Calendar series of runners so tha
For safety, store in this way only one or two days at the • do not allow fresh, unfrozen food to touch food which most. is already frozen, thus avoiding a rise in temperature of Cooked foods, cold dishes, etc..: these should be covered the latter; and may be placed on any shelf. • lean foods store better and longer than fatty ones; salt Fruit and vegetables: these should be thoroughly cleaned reduces the storage life of food; and placed in the special drawer(s) provided. • water ices, if consume
Defrosting of the refrigerator 3. Leave the door open and insert the Frost is automatically eliminated from the evaporator of plastic scraper in the refrigerator compartment every time the motor com- the appropriate pressor stops, during normal use. The defrost water seating at the bot- drains out through a trough into a special container at the tom centre, placing back of the appliance, over the motor compressor, where a basin underneath it evaporates. to collect the de- It is important to peri
Problem Possible cause Solution The appliance does not operate. The appliance is switched off. Switch on the appliance. The lamp does not operate. The mains plug is not connected to the Connect the mains plug to the mains mains socket correctly. socket correctly. The appliance has no power. There is Connect a different electrical appliance no voltage in the mains socket. to the mains socket. Contact a qualified electrician. The lamp does not work. The lamp is in stand-by. Close and open the do
power and specifically designed for household appli- Replacing the lamp ances (the maximum power is shown on the lamp Caution! Disconnect the plug from the mains cover). socket. 4. Install the lamp cover. 1. Remove the screw 5. Tighten the screw to the lamp cover. from the lamp cov- 6. Connect the plug to the mains socket. er. 7. Open the door. Make sure that the light comes on. 2. Remove the lamp Closing the door cover (refer to the illustration). 1. Clean the door gaskets. 3. Replace the used
The appliance must be earthed. The power supply cable This appliance complies with the E.E.C. Directives. plug is provided with a contact for this purpose. If the do- Door reversibility mestic power supply socket is not earthed, connect the The door of the appliance opens to the right. If you want to appliance to a separate earth in compliance with current open the door to the left, do these steps before you install regulations, consulting a qualified electrician. the appliance: The manufacturer
x 2 I 4mm x 1 44mm I If necessary cut the adhe- Install the appliance in the Adjust the appliance in the Attach the appliance to the sive sealing strip and then niche. niche. niche with 4 screws. apply it to the appliance as Push the appliance in the Make sure that the distance shown in figure. direction of the arrows (1) between the appliance and until the upper gap cover the cupboard front-edge is stops against the kitchen 44 mm. furniture. The lower hinge cover (in Push the appliance in the t
ca. 50 mm 8 mm 8 mm Ha 90° 21 mm 90° K Ha Hc Ha ca. 50 mm Hb 21 mm Install the part (Ha) on the Push the part (Hc) on the Open the appliance door Remove the brackets and part (Ha). and the kitchen furniture mark a distance of 8 mm inner side of the kitchen door at an angle of 90°. from the outer edge of the furniture. Insert the small square (Hb) door where the nail must be into guide (Ha). fitted (K). Put together the appliance door and the furniture door and mark the holes. Hb Hd Hb Place t