Dimplex CFP90 user manual

Summary of the content on the page No. 1

CFP60, CFP90 & CFP120
Industrial Fan Heater
08/19588/0 (UK) Issue 0
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC)

EN55014, EN60555-2 and EN60555-3 which cover the essential requirements of EEC Directives 73/23 and 89/336

Summary of the content on the page No. 2

1 500mm 445mm 500mm MIN. MIN. 466mm 1000mm MIN. 510mm 2 (a) (b) (e) (c) D E (d) A1 A1 1L1 3L2 5L3 13NO 1L1 3L2 5L3 13NO A B 2T1 4T2 6T3 14NO A2 2T1 4T2 6T3 14NO A2 3 TM (f) (g) C M H I F G T 380 - 415V 3PN + E 4 5a 5b ~3P 220 - 240V ~3PN 380 - 415V (FACTORY SUPPLIED)

Summary of the content on the page No. 3

Dimplex Industrial Fan Heater Models : CFP60, CFP90 & CFP120 THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE Electrical IMPORTANT SAFETY ADVICE Model Heat Electrical Electrical Required Supply Weight DO NOT COVER OR OBSTRUCT the air inlet or outlet grille. Output Supply Load Plug Cable IMPORTANT – Disconnect from the mains supply before (per phase) carrying out maintenance work. kW Amps Amps 5G x kg THIS HEATER MUST BE EARTHED CFP60 3 / 6 380-415V ~3PN 9.0 16 1

Summary of the content on the page No. 4

To reset the cut-out follow the procedures below : Operation 1. Disconnect power supply. The heat output from this heater is regulated using the rotating wheels 2. Determine what has caused the cut-out to operate and rectify. shown in Fig. 3. By rotating these wheels, with the unit plugged in, ( Note : This should only be undertaken by competent persons various fan and heat settings may be obtained. with experience of repairing electrical appliances and in full Function control wheel knowledge o