Summary of the content on the page No. 1
High Efficiency Vaporizing System and Highly Durable Heaters Ensure 25% Increased Output.
Modular Design for Easy, Cost Effective Maintenance.
Standardized Interface Allows Interchangeable Control Modules on All Models.
Illuminated Fluid Tank for Easy Monitoring for the Level of Fog Fluid.
Electronic Low Fluid Monitoring Protects Pump from Running Dry
Heavy-Duty, Quiet Pump for Continuous, Silent Operation.
Summary of the content on the page No. 2
Table of Contents Introduction 1 Important Safeguards 2 Unpacking & Inspection 4 Setup 4 Operation 5 Control Module Operation 6 ANTARI X-20 DMX Module Settings 8 Maintenance 10 Performance Notes 11
Summary of the content on the page No. 3
Congratulations on the purchase of your new ANTARI X Fogger Introduction Thank you for choosing an ANTARI X Fogger. You now own a rugged and powerful state-of-the-art machine. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward tothereliableandsatisfactoryperformanceofyour ANTARIFogMachineforyearstocome. Please followthese operation, safetyand maintenance instructions to ensurea long and s
Summary of the content on the page No. 4
Important Safeguards Danger of Electric Shock ! Keep this device dry. ! For inside use only. Not designed for outside use. ! For the 110V models, use 3-prong grounded electrical outlet only. Prior to use take care to determine that the unit is installed at the ratedvoltage. ! AlwaysunplugyourANTARIFogMachinebeforefilling itstank. !Keepfogmachineupright. ! Unplug the machine when not in use. ! This machine is not water- or splash-proof. If moisture, water, or fog liquid gets inside the housi
Summary of the content on the page No. 5
! Never aim the output nozzle at open flames. ! If the supply cord is damaged, it mustbereplacedby manufactureroritsserviceagentorsimilarlyqualified personnelinordertoavoidahazard. !Theoutputnozzlebecomesveryhotduringoperation 0 (300C). Keep flammable materials at least 50 cm away from the nozzle. ! Always allow your ANTARI X Fogger to cool down before attempting to clean or service it. Danger of Explosion ! Never add flammable liquids ofanykind(oil,gas, perfume)tothefogliquid. ! Useonlythehi
Summary of the content on the page No. 6
Unpacking & Inspection Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. Before beginninginitialsetupofyourANTARIFogMachine,makesure thatthereisnoevidentdamagecausedbytransportation. In the event that the unit's housing or cable is damaged, do not plug it in anddonot attempttouseituntilaftercontactingyourANTARIdealerfor assistance. Setup Removeallpackingmaterialsfromshippingbox. Check that all foam and plastic padding is removed, esp
Summary of the content on the page No. 7
Operation ! Plug power cord into a grounded electrical outlet. Turn power switch on rear of unit to " ON" position. Warm-up is complete when the display on control module.shows " Ready to Fog" ! To emit fog, press the appropriate button on the control module for the desired length of time. ! The control unit's display will cycle " Warming up" and " Ready to Fog " as the machine re-heats to the proper operating temperature. ! For further information on operating your ANTARIFog Machine,see
Summary of the content on the page No. 8
going through the hose. If you are unable to determine the cause of the problem, do not simply continuepushingthecontrol module button, as this may damage the unit. Return the machine to your ANTARI dealer immediately. Control Module Operation FUNCITON VOLUME MANUAL TIMER ESC ENTER ON / OFF !X-10: 10 meter wired multi-function remote control module with 5-pin XLR connector for ANTARI X Series models X-310, X-510, X-515, X-530. Its interface allows the operator to customize fog machine
Summary of the content on the page No. 9
percentage (within the range of 1% to nonstop burst) by means of Up / Down keys. To adjust timer setting, go into Timer option. Cycle through Interval (within the range of 1 to 900 seconds), Duration (within the range of 1 to 200 seconds), and Volume (within the range of 1% to nonstop burst) by means of Up / Down keys. Use Enter (Volume) Key to select each option and make changes as desired. To turn off the heater and fan, go into Heat & Fan option. Use Enter (Volume) Key to confirm the
Summary of the content on the page No. 10
! X-30: All the X-10 features plus wireless capability. Wireless operation is possible up toadistanceof50 meters.Theaddresscanbesetfrom0to8,whichmeans total9differentunitscanbecontrolledseparatelyorin any combination desired. Press function to cycle to RF mode to select desired address number. Make sure the address setting on the X-30 matchs the address setting on the transmitter. There are two buttons on the transmitter. One istoreleasefog,theotheristostopthe operation. ANTARI X-20 DMX Modul
Summary of the content on the page No. 11
If Channel has a value from 0 to 5, the unit is OFF. Between the values 6 to 249thevolumeoffogoutputis regulated.With 6 being the minimum volume of fog produced and 249 approaching the maximum. The volume output rises as the DMX value is increased. If Channel has a value from 250 TO 255, the machine will operate at maximum output. Note: In the example above, if the machine were assigned the DMX address of 124, Channel would correspond to DMX address 124. In general, ANTARI X Fogger with X
Summary of the content on the page No. 12
Maintenance Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid container and the fog machine liquid tank immediately after filling. After every 40 hoursofcontinuousoperation,itisrecommendedto runacleaning solution composed of 80% distilled water and 20% white vinegar through the system to prevent the accumulation of particulate matter in the heating element. The recommended cleaning regimen is as follows: 1.Empty all fog fluid from machine. Add cle
Summary of the content on the page No. 13
Performance Notes ! All fog machines develop condensation around the output nozzle. Because this may result in some moisture accumulation on the surface below the output nozzle, consider this condensation when installing your unit. ! All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after being turned off. ! All fog machines have a recycling period after long bursts when the machine will shut itself down for a short period in order to
Summary of the content on the page No. 14
LIMITED WARRANTY Atari Lighting and Effect Ltd. warrants to the original purchaser that the ANTARI X Fogger will be free from original defects in workmanship and material for a period of six months from the date of purchase. During the warranty period, machines will be repaired or replaced at the option of ANTARI or its designated dealer. If the purchaser returns a completed registration card to ANTARI or its designated dealer within 30 days of purchase, ANTARI will extend the limited warr
Summary of the content on the page No. 15
