Summary of the content on the page No. 1
PACKAGE HEAT PUMP
INSTALLATION INSTRUCTIONS
Installer: Affix literature adjacent to the unit.
®
is a trademark of Maytag Corporation and is used under
license to Goodman Company, L.P. All rights reserved.
*NOTE: Please contact your distributor or our website for
the applicable product data book referred to in this
Goodman Company, L.P.
Part No. 10730418 2000-2004 Goodman Company, L.P.
1810 Wilson Parkway • Fayetteville, Tennessee 37334
Effective: May 2004
Printed in USA
www.amana-hac.com
Summary of the content on the page No. 2
SAFET SAFET SAFET SAFET SAFETY INSTR Y INSTR Y INSTR Y INSTR Y INSTRUC UC UC UC UCTI TI TI TI TIO O O O ONS NS NS NS NS RECOGNIZE SAFETY SYMBOLS, WORDS, AND LABELS The following symbols and labels are used throughout this manual to indicate immediate or potential safety hazards. It is the owner’s and installer’s responsibility to read and comply with all safety information and instructions accompanying these symbols. Failure to heed safety information increases the risk of personal injury, pro
Summary of the content on the page No. 3
or equal to the design heating and cooling loads of the area to be GENERAL INFO GENERAL INFO GENERAL INFO GENERAL INFO GENERAL INFORM RM RM RM RMA A A A ATI TI TI TI TIO O O O ON N N N N conditioned. The loads should be calculated by an approved method or in accordance with A.S.H.R.A.E. Guide or Manual J - Load Cal- TO THE INSTALLER culations published by the Air Conditioning Contractors of America. Before installing this unit please read this manual and the Product Obtain from: Data Book appl
Summary of the content on the page No. 4
ON ON CG Y R W W1 W2 O See the unit wiring diagram for electrical connections. ROOM THERMOSTAT C/X G Y R O W1 W2 E OUTDOOR UNIT C/X G Y R O W W1 W2 PH__C02E Wiring shown is for D9945804 (THSMEC1H2BA) thermostat. ROOM THERMOSTAT C/X G Y R O W2 E OUTDOOR UNIT C/X G Y R O W W1 W2 PH__C02E Wiring shown is for 10636701(THSADC1H2BA) or 10636702 (THSMDC1H2BA) thermostat PHD60 TWO-STAGE Yellow No. 20 Wire in Blower Section Figure 1 - Rigging ROOM THERMOSTAT C G Y2 Y1 R O W1 W2 W3 DUC DUC DUC DUC D
Summary of the content on the page No. 5
UNIT VOLTAGE The unit transformer is factory connected for 230V operation. If the unit is to operate on 208V, reconnect the transformer primary lead as shown on the unit wiring diagram. Low Voltage Terminal Strip CIR CIR CIRCUL CUL CULA A ATIN TIN TING AIR AND FIL G AIR AND FIL G AIR AND FILTER TER TERS S S CIR CIRCUL CULA ATIN TING AIR AND FIL G AIR AND FILTER TERS S DOWNSHOT AIRFLOW CONVERSION Units are shipped from the factory ready for horizontal airflow. These units can be easily converted
Summary of the content on the page No. 6
FLANGE BRACKETS Drill 2-1/8" Dia. holes Install Screws Removed From Back Panel SUPPLY AIR RETURN AIR Motor Leads MUST exit at bottom Figure 9 - Flange Bracket Installation Figure 7 - Vertical Blower Assembly 6. Align the horizontal duct covers (Figure 10) over the flange HORIZONTAL DUCT COVER INSTALLATION brackets just installed and secure with screws included in the Horizontal Duct Cover kit. The second step in the downshot airflow conversion is to install Hori- zontal Duct Covers. Horizontal D
Summary of the content on the page No. 7
be filled either before a cooling startup or during a unit “cycle-off” after 20 minutes of running on first cycle. This drain can be ex- tended using 3/4” PVC piping. 1-1/2" Minimum drop at outlet Figure 12 - Horizontal Duct Cover Installation 90° ELL DUCTWORK Condensate 2-1/2" of Drain Trap 3/4" PVC Duct systems and register sizes must be properly designed for the C.F.M. and external static pressure rating of the unit. Ductwork should Figure 13 - Condensate Drain Connection be designed in acc
Summary of the content on the page No. 8
OPERATING INSTRUCTIONS ACCESSO ACCESSO ACCESSO ACCESSO ACCESSORIES RIES RIES RIES RIES 1. Turn on the electrical power supply to the unit. 2. Place the room thermostat selector switch in the COOL or HEAT position (or AUTO if available, and if automatic Horizontal Duct Covers (CHK001A) changeover from cooling to heating is desired). Single Point Power Connection (SPK**A) 3. Set the room thermostat to the desired temperature. Roof Curb - Heat Pump (PRC06A1) Roof Curb - Universal (PRC08A1) MAINTENA
