Well Traveled Living Stowe user manual

Summary of the content on the page No. 1

Summary of the content on the page No. 2

Thank you for purchasing a Fire Sense Electric Fireplace. Important: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty. INSTALLATION INSTRUCTIONS – GENERAL 1. Read all instructions before using this appliance. 2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this appliance.

Summary of the content on the page No. 3

Use this appliance only as described in this manual. Any other use not recommended 17. by the manufacturer may cause fire, electric shock or injury to persons. Avoid the use of an extension cord because the extension cord may overheat and 18. cause a risk of fire. However, if you have to use an extension cord, the cord shall be 14 gauge minimum size and rated not less that 2025 watts. The extension cord must be a three wire cord with grounding type plug and cord connector. The extension cord

Summary of the content on the page No. 4

CONTROLS/LEG ASSEMBLY Your fireplace has the following functions: Leg Assembly: Lay stove on a flat surface. Attach 4 legs with screws provided as shown in Fig. 1: High heat 1350 watts Low heat On/Off Fig. 1 700 watts Power to the unit Please note: Both the low heat and high heat switches must be in the on position to achieve high heat. FOR YOUR SAFETY Service must be performed by a qualified service agency. REPLACING THE LIGHT BULBS

Summary of the content on the page No. 5

3. Turn the fireplace so you are facing the back of the fireplace. 4. Look for the access plate with the gold printing on it. 5. Remove the 3 screws holding the access plate in position (FIG1). Once you have removed the 3 screws, lift the access plate so the 2 positioning tabs come free of their slots. Once you have removed the access plate you can see and access the two 40 watt chandelier bulbs (FIG 2). 6. Remove each light bulb by unscrewing them out of the bases, turning

Summary of the content on the page No. 6