Kodak SERIES I200 user manual

Summary of the content on the page No. 1

Kodak Imaging Guide Set for i100 and i200 Series Scanners
This document provides instructions for installing the Kodak Imaging Guide Set for i100 and i200 Series Scanners.
IMPORTANT: 4. Pull gently on the end of the imaging guide and slowly
remove it from the scanner.
• It is recommended that you thoroughly clean the scanner
before replacing the imaging guides. For complete 5. Discard the used imaging guide.
cleaning procedures, see the appropriate User’s Guide
6. Remove any dust or debris fr

Summary of the content on the page No. 2

Replacing the Lower Imaging Guide Instructions for Kodak i200 Series Scanners 1. Locate the lower imaging guide. 1. Power down the scanner. 2. Clean the lower transport area and imaging guide. 2. Access the inside of the scanner by opening the 3. Remove the screw from the lower imaging guide. scanner cover. 3. Lift up the scanner door release again and open the scanner door past the circuit board cover. Screw Lower imaging guide Upper imaging guide Circuit board cover Lower imaging guide 4.