Summary of the content on the page No. 1
AUTOMATIC DRUM WASHING MACHINE
USER MANUAL
HW55-1010
HW55-1010ME
Summary of the content on the page No. 2
03 - 09 8 - 15 16- 20 TABLE OF CONTENTS BEFORE USE USING THE APPLIANCE MAINTENANCE >COMPONENTS ............................... 03 >CONTROL PANEL ............................ 08 >CLEANING & CARE .......................... 16 >PREPARATION ................................ 04 >DISPLAY CODES ............................. 18 >PROGRAM SELECTION ..................... 10 >SAFETY INSTRUCTIONS ................... 05 >CONSUMPTION AND TECHNICAL DATA .. 11 >TROUBLESHOOTING........................ 19 >INSTALLA
Summary of the content on the page No. 3
03 BEFORE USE COMPONENTS Please read these instructions carefully before using this appliance. The instructions contain important information which will help you get the best out of the appliance and ensure safe and proper installation, use and maintenance. Keep this manual in a convenient place so you can always refer to it for the safe and proper use of the appliance. If you sell the appliance, give it away, or leave it behind when you move house, make sure you also pass on this manual so th
Summary of the content on the page No. 4
04 BEFORE USE PREPARATION PREPARING THE MACHINE Remove all the packing materials to prevent unsteadiness, including the polystyrene base. Upon opening the package, water drops may be seen on the plastic bag and the porthole. This is normal phenomenon resulting from water tests in the factory. DESCRIPTION This diagram may be slightly different from the layout of the washing machine you have just purchased due to technical improvements. Drain hose Water inlet value Power cord Back cover Back
Summary of the content on the page No. 5
05 BEFORE USE SAFETY INSTRUCTIONS BEFORE SWITCHING THE APPLIANCE ON FOR THE FIRST TIME DO ... DO NOT ... ... Make sure that the transport bolt are removed. ... Touch or use the appliance when barefoot or with wet ... Use a separate earthed socket for the power supply. or damp hands or feet. ... Make sure that the plug is accessible. ... Use fl ammable detergent or dry cleaning agent. ... Hold the plug and not the electric cable when ... Use any fl ammable sprays in close vicinity to th
Summary of the content on the page No. 6
06 BEFORE USE INSTALLATION ADJUSTING THE BOTTOM COVER When open the carton package, you will find a metalline board which is laid on the top of the washing machine as shown fig.1, the board used for reducing noise and rat proof by install it under the cabinet when setting as shown in fig.2. DISMANTLE THE TRANSPORTATION BOLTS The transportation bolts are designed for clamping anti-vibration components inside of the washing machine during the transportation process. 1. Remove the back cover. 2.
Summary of the content on the page No. 7
07 BEFORE USE INLET HOSE 1. Connect the nut on the inlet hose to the connector on the water valve. 2. Apply inlet hose to a water tap with cold, fresh water. Note: Use the hose-set supplied with the appliance. Old 1. 2. hose-sets should not be reused. DRAIN HOSE 1. Use the drain hose bracket to keep the end of the drain hose retained and prevent the outfl ow of water. Don't extend the length of the drain hose; if an extended hose is required, please consult a serviceman. 2. The height of the
Summary of the content on the page No. 8
08 USING THE APPLIANCE CONTROL PANEL G Quick Synthetic Cotton Remaining Time HW55-1010 。 Pre-Wash 30C 。 60’ 1000 5.5kg Cold 90C 。 。 800 Wool 40C 60C 30’ 。 Spin 40C 15’ 600 Stop 400 Start/Pause Power Speed Strong A B C D E F D Spinning Speed Setting Button A Detergent distribution drawer B Power Button E Strong button F Start/Pause Button C Program knob G Remianing Time OPERATIONAL FUNCTIONS A ¬Detergent _ The drawer contains three compartments: 2 distribution drawer 1: Prewash detergen
Summary of the content on the page No. 9
09 USING THE APPLIANCE D ¬ Spinning Speed _ Touch this button lightly to select the desired speed. When a speed is set, the indicator light Setting Button will be light on E ¬ Strong button _Touch this button lightly, the indicator light will be light on . you can increase the washing time, rinsing times in main wash stage of the selected program, which is suitable for dirty clothes. F ¬Start/Pause Button When the washing machine is connected to the power socket and a program is selected, light
Summary of the content on the page No. 10
10 USING THE APPLIANCE PROGRAM SELECTION PROGRAM MODES 2 1 Detergent compartment for prewash mode 3 1 2 Detergent compartment 3 Compartment for softener and other additives Preset spin PrProgramogramm Temperature 2 33 1 Recommended Laundryne speed 1 ¬ Prewash 60°C Very heavy soiling 1000 rpm 2 ¬ 90°C 90°C Heavy soiling 1000 rpm Cotton 3 ¬ 60°C 60°C Soiled cotton 1000 rpm 4 ¬ 40°C 40°C Non-fade and medium soiled 1000 rpm 5 ¬ Quick 40°C Medium soiled laundry 1000 rpm 6 ¬ 30°C
Summary of the content on the page No. 11
11 USING THE APPLIANCE CONSUMPTION AND TECHNICAL DATA CONSUMPTION TABLE The wash cycle times are intended as a guide only. The actual time used may vary due to different water pressure, initial water temperature, etc. PROGRAM Max. LOAD ENERGY WATER CONSUMPTION TEMPERATURE WASHING TIME CONSUMPTION ¬ Prewash 5.5 kg 1.16 kWh 52L 60° around 2:16 h ¬ 90°C 5.5 kg 1.56 kWh 46L 90°C around 2:08 h Cotton ) ¬ 60°C* 5.5 kg 0.95 kWh 49L 60°C around 2:59 h ¬ 60°C 5.5 kg 1.14 kWh 45L 60°C around 1:59 h ¬ 4
Summary of the content on the page No. 12
12 USING THE APPLIANCE WASHING METHODS PLEASE NOTE This washing machine is for domestic use only. If the machine is use for commercial purpose the guarantee will not be valid anymore.Do not use it for purposes other than that for which it was designed. Follow the instructions given on the label of each garment and wash only machine-washable garments. POWER SUPPLY Connect the washing machine to the power supply (220V to 240V~/50Hz). WATER CONNECTION Turn on the tap. The water must be clean and
Summary of the content on the page No. 13
13 USING THE APPLIANCE LOADING THE MACHINE Open the washer door, put in the laundry piece by piece. Close the door tightly. ¬ When fi rst using the washing machine, let it run unloaded for one program to prevent the laundry from being tainted by oil or dirty water from the washing machine. Before washing you should run the machine without laundry, but with detergent, with 60°C programm. ¬ Do not overload the washing machine. SELECTING DETERGENT The washing effi ciency and the performance is
Summary of the content on the page No. 14
14 USING THE APPLIANCE SETTING SPIN SPEED Remaining Time stop Touch this button lightly to select the desired speed. When a speed is set, strong speed Start/Pause the indicator light will be light on. STRONG BUTTON Remaining Time Touch this button lightly, the indicator light will be light on . you can increase the washing speed strong time,rinsing times in main wash stage of the selected program, which is suitable for dirty clothes Start/Pause START WASHING Remaining Time When the washing m
Summary of the content on the page No. 15
15 USING THE APPLIANCE CARE CHART Resistant material Bleachable in cold water Don't dry clean Delicate fabric Do not bleach Dry fl at Washable at 95 °C Iron at 200 °C Hung to dry Washable at 60 °C Iron at 150 °C Dry on clothes hanger Washable at 40 °C Iron at 100 °C Tumble dry, normal heat Washable at 30 °C Don't iron Tumble dry, reduced heat Hand wash Dry cleaning with any solvent Don't tumble dry Dry clean only Dry cleaning with pericloride Wool Seal Dry cleaning with aviation fuel LOAD REFERE
Summary of the content on the page No. 16
16 MAINTENANCE CLEANING & CARE AFTER WASHING Turn off the water supply and pull out electricity plug after each wash. Open the washer door to prevent formation of moisture and odours. If the washing machine is left idle for a long period, drain the water in the machine and replace the drain hose. 1 1.. 2 2.. CLEANING THE DETERGENT DRAWER Clean the detergent distribution drawer regularly. 1. Swing out the drawer, fl ush it clean with water and then replace it. CLEANING THE MACHINE 2. Unplug the
Summary of the content on the page No. 17
17 MAINTENANCE WATER INLET VALVE AND INLET VALVE FILTER To prevent blockage to the water supply by ingress of foreign substances, clean the water inlet valve and inlet valve fi lter regularly. MOVING THE MACHINE If the machine is to be moved to a distant location, replace the transportation bolts removed before installation to prevent damage as shown below. 1. 2. 1. Remove the blanking plugs. 2. Remove the back cover 3. Insert the synthetic stabilisers and the transportation bolts. 4.
Summary of the content on the page No. 18
18 MAINTENANCE DISPLAY CODES DISPLAY CODES AND SPECIAL FUNCTIONS ERROR MESSAGE CAUSES SOLUTIONS Err1:The start/pause lamp off and the ¬ Door is not properly shut. _ Shut the door properly. buzzer beeping Err2:The start/pause lamp twinkles twice ¬ Drainage error, water not _ Clean the fi lter and check the drain hose for in 4 seconds. emptied within 4 minutes. blockage. If error still exists, please contact the maintenance personnel. Err3:The start/pause lamp twinkles 3 ¬ Temperature sensor _ Co
Summary of the content on the page No. 19
19 MAINTENANCE TROUBLESHOOTING TROUBLESHOOTING The following circumstances do not constitute problems. Do not contact the Service Center until the problem has been confi rmed. PROBLEM CAUSES SOLUTIONS Washing machine fails to ¬ Poor connection to the power supply. _ Check connection to the power supply. operate. ¬ Power failure. _ Check the power supply. ¬ The washer door is not properly closed. _ Close the washer door properly. ¬ Machine has not been switched on. _ Make sure the machine is s
Summary of the content on the page No. 20
20 MAINTENANCE
