Dacor MWDV308 user manual

Summary of the content on the page No. 1

ERWD, EWD, IWD, MRWD, MWDV, MWDH,
OWD, PWD Warming Drawers
24”, 27”, 30”, 36” Wide, PLANNING
Revised
1/3
03/04/09 Warming Drawers GUIDE
All tolerances: +1/16”, -0, (+1.6mm, -0) unless otherwise stated
WARNING
1. Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
3/4" Min.*
2. This appliance must be installed in accordance with the
(19 mm)
accompanying installation instructions.
Warming Drawer
C
36"

Summary of the content on the page No. 2

ERWD, EWD, IWD, MRWD, MWDV, MWDH, OWD, PWD Warming Drawers 24”, 27”, 30”, 36” Wide, PLANNING Revised 2/3 Warming Drawers GUIDE 03/04/09 All tolerances: ±1/16” (±1.6mm) unless otherwise stated ERWD EWD MRWD30B (only) 3 1/2" 3 7/16" (89 mm) (87 mm) 1 7/16" (37 mm) 10 1/8" 1 1/8" 1" (257 mm) (29 mm) (25mm) All other MWDH/V PWD MRWD series 3 1/4" 2 1/4" (83 mm) (57 mm) 1" (25 mm) A 1" 1" (25 mm) (25 mm) HANDLE DIMENsIONs DRAWER FACE DIMENsIONs (MWD SerieS ShoWn) 40" (1016 mm) Mounting 3 prong B H

Summary of the content on the page No. 3

ERWD, EWD, IWD, MRWD, MWDV, MWDH, OWD, PWD Warming Drawers 24”, 27”, 30”, 36” Wide, PLANNING Revised 3/3 Warming Drawers GUIDE 03/04/09 All tolerances: ±1/16” (±1.6mm) unless otherwise stated C B E D Chassis 5/16” (8 mm) A DRAWER FACE DIMENsIONs (iWD/oWD SerieS ShoWn) Drawer open F 40" (1016 mm) Mounting hole, 3 prong 9 places 120 Vac power cord OVERALL DIMENsIONs - IWD/OWD sERIEs tOP VIEW ** ** ** ** G Chassis without drawer installed ** = OWD24 mounting holes CHAssIs DIMENsIONs (iWD/oWD Sh