Summary of the content on the page No. 1
G5912
Product features and decorations may vary from picture above.
WARNING
IMPORTANT! KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
Please read these instructions before assembly and use of this product.
Adult assembly is required.
Tool needed for battery installation: Phillips Screwdriver (not included).
Requires four LR14 alkaline batteries for operation (not included).
Weight Limit: 9 kg (20 lbs).
w
w
w.
fi
s
he
r
-p
r
i
c
e
.
c
o
m
Summary of the content on the page No. 2
Warning and Caution Consumer Information Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB. Helpline: 01628 500302. WARNING To prevent serious injury or death from falls and being strangled in the restraint system: - Always use the restraint system. - Not recommended for children who can sit up by themselves AUSTRALIA Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond, (6 months approximately, until Victoria 3121 Australia. Consumer Advisory Service 1300 135 312. 9 k
Summary of the content on the page No. 3
Parts Pad Seat Back Tube Frame Lower Swing Arm Assembly (with Restraint System) 3 Link Toys Front Tube 2 Frame Tubes #6 x 1.9 cm Screws - 4 NOTE: Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten the screws. Shown Actual Size 3
Summary of the content on the page No. 4
Assembly IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp Press Button edges. DO NOT use if any parts are missing or broken. on Front Tube Contact Mattel for replacement parts and instructions if needed. Never substitute parts. Press Button on Lower Frame Tube Upper Frame Tube Rubber Feet Down 1 2 • Rotate the upper frame tube until it "snaps" into an upright • Position the front tube so that the rubber feet are flat on position, as sho
Summary of the content on the page No. 5
Assembly Frame Lower Frame Tubes Press Button on Upper Frame Tube Pull Front Tube 3 • Pull the front tube to be sure it is secure to each lower frame tube. 4 • While pressing the buttons on the upper frame tubes, insert them into the holes in the underside of the frame. • Continue to insert the upper frame tubes into the frame until you hear a "click" on both sides. 5
Summary of the content on the page No. 6
Assembly Upper Swing Arms Upper Frame Frame Upper Frame Tube Tube Lower Swing Arm Assembly (with Restraint System) 5 6 • Fit the lower swing arm assembly to the outer side of the • Check to be sure the upper frame tubes are secure in the upper swing arms. frame. If you can remove the upper frame tubes from the frame, you have not properly inserted the tubes into the frame. Remove the upper frame tubes from the frame and repeat Assembly step 4. 6
Summary of the content on the page No. 7
Assembly Seat Back Tube Buttons #6 x 1.9 cm Screws - 4 7 Shown Actual Size • Insert two #6 x 1.9 cm screws through the upper swing arm and into the lower swing arm. Tighten the screws. Swing Arm Short Tubes 8 • Position the seat back tube so that it curves toward the back of the swing. • While pressing the buttons on the seat back tube, fit the seat back tube into the short tubes on the swing arms. • Push the seat back tube until it “clicks” into place. • Pull up on the seat back tube to be sure
Summary of the content on the page No. 8
Assembly Pad Top Pocket Slot Slot Pad Lower Pocket Fastener Waist Belts Seat Bottom Tube Seat Back Tube 9 • Fit the top pocket on the pad over the seat back tube . • Lift the seat bottom tube and fit the lower pocket on the pad over the seat bottom tube . 10 • From behind the seat, insert the waist belts into the slots in the pad. • Push to fasten the restraint system to the pad. Assembly is now complete. 8
Summary of the content on the page No. 9
Battery Installation Hint: We recommend using alkaline batteries for longer battery life. 1.5V x 4 LR14 SHOWN ACTUAL SIZE Battery Holder 2 Battery Compartment Door • Open the battery holder. • Insert four LR14 alkaline batteries as indicated inside the battery holder. • Close the battery holder. Battery Holder 1 • Locate the battery compartment door on the frame. Battery Compartment Door • Loosen the screws in the battery compartment door. • Remove the battery compartment door and the battery
Summary of the content on the page No. 10
Battery Safety Information Set-Up & Use Batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: WARNING • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). To prevent serious injury or death • Insert batteries as indicated inside the battery compartment. from falls and being strangled in • Remove batteries during long periods of non-use. Always the restraint
Summary of the content on the page No. 11
Set-Up & Use Securing Your Child Anchored End Waist Belt Restraint Free End Tighten Anchored End Free End Loosen 2 To tighten the restraint straps: • Feed the anchored end of the restraint strap up through the buckle to form a loop . Pull the free end of the restraint strap . Waist Belt To loosen the restraint straps: Crotch Belt • Feed the free end of the restraint strap up through the buckle to form a loop . Enlarge the loop by pulling on the end of 1 the loop toward the buckle. Pull the an
Summary of the content on the page No. 12
Set-Up & Use Power Dial Starting the Swing Power Dial • Turn the power dial to any of eight settings. • Give the seat a light push to start the swinging motion. Adjust the swing power dial to the desired swing motion setting. Hint: As with most battery-powered swings, a heavier child will reduce the amount of swinging motion on all settings. In most cases, the low setting works best for a smaller child while the high setting works best for a larger child. • If swinging stops while using a lower
Summary of the content on the page No. 13
Set-Up & Use Hint: Your baby can enjoy lights and music with or without swinging. Baby Activated Parent Activated Lights and Lights and Volume Dial Music Switch Music Switch • Slide the lights and music switch to: When baby pulls either toy on the arch, one tune plays along with twinkling lights. On this setting, six tunes (approximately 10 minutes) play along with dancing lights. On this setting, music plays for about 10 minutes. Turns lights and music off. • Turn the volume dial to a comforta
Summary of the content on the page No. 14
Set-Up & Use Room-to-Room Portability WARNING • To prevent serious injury or death from falls and being strangled in the restraint system, always use the restraint system. • It is dangerous to use this product on an elevated surface. 3 Link Toys • Fit the link toys to either of the hanging toys on the swing. • Make sure your child is properly secured in the swing seat. • With baby facing forward and outward, lift the swing using the handle. • Carefully carry the swing to another room. Be sure t
Summary of the content on the page No. 15
Take Along Lift Seat Back Lift Seat Bottom Seat Back Press Tabs 2 1 • Tip the swing backwards with the seat back down. • Press both tabs on the frame at the same time to release the • Lift the seat back and seat bottom together. frame base. 15
Summary of the content on the page No. 16
Take Along Care • The frame, pad, liner and toys may be wiped clean using a mild cleaning solution and a damp cloth. Do not immerse Lower Frame Tube the frame. • This product has no consumer serviceable parts. Do not take this product apart. IMPORTANT! Never use this product without the provided pad. 3 • Rotate the lower frame tube around to the top of frame, as shown. To set the swing back up for use: • Rotate the lower frame tube around until it snaps into place. • Place the swing on a non-e
