Human Touch HT-7120 user manual

Summary of the content on the page No. 1

March 14, 2012

REPLACING THE FOOT AND CALF MASSAGER
HT-7120
®
To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
SERVICE LEVEL: 3
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
Tools Required: Nail clipper or other instrument suitable for cutting zip ties, Phillips-head screwdriver, flat-head
screwdri

Summary of the content on the page No. 2

8. Using a Phillips-head screwdriver, remove the two screws from the two brackets on the massager frame, then remove the brackets (Fig.4). 9. Locate Pin A, insert a flat-head screwdriver between the pin head and the bracket, then tap the screwdriver handle to dislodge the pin from the bracket approximately 1/2 inch (Fig.4). NOTE: If the pin is stuck in the bracket, tap the pin with a hammer on the exposed area between the two sides of the mounting bracket to loosen it (Fig.4). 10. Use your

Summary of the content on the page No. 3

INSTALLING THE NEW FOOT AND CALF MASSAGER 1. Place the new foot and calf massager into position, then insert pin A just far enough into the left side of bracket A to hold it in place. 2. Line up the actuator bracket with the mounting point on Bracket A, then push the pin through the bracket as far as it will go by hand. 3. Line up the left side of the massager with Bracket B, then insert Pin B through the bracket as far as it will go by hand. 4. Use a small hammer to push both pins until