Summary of the content on the page No. 1
Operator's Manual
LSM75BVG, LSM55H, LSM80H
WARNING: READ ENTIRE MANUAL BEFORE ATTEMPTING TO OPERATE MACHINE!
If incorrectly used this machine can cause severe injury. Those who use and maintain this
machine should be trained in its proper use, warned of its dangers, and should read the en-
tire manual before attempting to set up, operate, adjust, or service this machine.
The Engine Exhaust from this product contains chemicals known to the State
of California to cause cancer, birth defects
Summary of the content on the page No. 2
2 Important Rules for Your Safety Before operating this machine read all the instructions for safe operation, as well as, the instructions governing the engine and other components of this machine. TRAINING OPERATION • Read the Owner's Manual carefully. Be thoroughly • Prepare logs properly. Both ends of each log should be familiar with the controls and the proper use of the equip- cut as square as possible to help prevent the log from rid- ment. Know how to stop the unit and disengage t
Summary of the content on the page No. 3
3 Safety Information continued from page 2 MAINTENANCE Allow the engine to cool before refueling. • Keep machine in good working condition. • Never smoke while operating or refueling your log splitter. • Do not alter your log splitter in any manner. Such altera- Gas fumes can easily explode. tions could cause your splitter to be unsafe. • If gasoline is spilled move machine away from the area of • Before cleaning, repairing, or inspecting the machine, the spill and avoid creating any s
Summary of the content on the page No. 4
4 Operation Before Starting Your Log Splitter . . . 1. Check your Log Splitter. Be sure all bolts are tight. After several hours of operating and at periodic maintenance intervals, check all fasteners and tighten securely as required. WARNING : YOUR ENGINE IS SHIPPED WITHOUT OIL. YOU MUST FILL THE ENGINE WITH OIL BEFORE ATTEMPTING TO CRANK YOUR ENGINE. 2. Check oil and fill according to the engine owner's manual. • Read Engine manual for full instructions and safety warnings. •
Summary of the content on the page No. 5
5 Starting the engine 1. Read engine owner's manual for complete starting instruction. Do not operate this Splitter without reading the engine owner's manual. 2. Move the throttle control lever out to the START position. 3. Grasp rope handle and pull slowly until resistance is felt. Then pull cord rapidly to overcome compression, prevent kickback and start engine. 4. Operate engine in the 3/4 throttle position. Splitting Wood Logs may be split in either a vertical or horizontal position.
Summary of the content on the page No. 6
6 Figure 2
Summary of the content on the page No. 7
7 Refer- Quan- Refer- Quan- ence Part # tity Description ence Part# tity Description 1 358908 2 Lower Slide, Wedge 35 600208 1 Coupler Spider 2 358907 2 Spacer, Wedge 36 600203 1 3/4" ID Coupler 3 358906 1 Wedge Assembly 600209 1 1" ID Coupler (8hp) 5 400242 4 Capscrew, 1/2" x 2 1/2" NC5 37 455040 4 Flat Washer 1/4" 7 600371 1 3/4" Street Ell 38 600223 1 2 Stage Pump 8 600220 1 Pressure Hose 39 600218 1 Elbow Adapter, 45 degree 9 600212 1 Cylinder w/ Control Valve 40 600372 1 3/4" x 2" Nipple 60
Summary of the content on the page No. 8
Figure 3 A LSM with suspension 65 Figure 3
Summary of the content on the page No. 9
Summary of the content on the page No. 10
Summary of the content on the page No. 11
Summary of the content on the page No. 12
8 Limited Warranty Maxim Manufacturing Corporation, through its dealers will repair or replace any part, or parts of the LSM75BVG, LSM55H, or LSM80H frame that is defective in material or workmanship or both. Transpor- tation charges on parts submitted for repair or replacement under this Warranty must be borne by purchaser. The original sales receipt must be submitted as proof of purchase date. The sales receipt will be returned. Maxim Manufacturing Corporation assumes no liability for l
